鉛耗 的英文怎麼說

中文拼音 [qiānhào]
鉛耗 英文
lead loss
  • : 鉛名詞1. (金屬元素) lead (pb) 2. (鉛筆心) lead (in a pencil); black lead
  • : Ⅰ動1 (減損; 消耗) consume; cost 2 [方言] (拖延) waste time; dawdle Ⅱ名詞1 (壞的音信或消息) ...
  1. The dead leaves that were blown against the leaded panes seemed to him like his own wasted resolutions and wild regrets.

    敗葉被吹到加條的玻璃窗上,他覺得它們就象他自己損了的決心和沉痛的悔恨。
  2. Pencils, ink and paper are expendable supplies

    筆,墨水和紙都是銷品。
  3. The sea breeze, as though it had the sooner blown itself out by its unusual violence, was already at an end ; it had been succeeded by light, variable airs from the south and south - east, carrying great banks of fog ; and the anchorage, under lee of skeleton island, lay still and leaden as when first we entered it

    海風竭了淫威,很快地平靜下來,緊跟著,輕柔的海風從南面東南面飄拂而來,攜來了大團大團的霧氣。在骷髏島的下風處,灰色的錨地像我們初次進來時一樣平靜。
  4. Constrained to technologies, the lead - acid battery mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current, etc. the charging current of these methods cannot match efficiently the acceptance curve of the lead - acid battery proposed by j. a. mas. as a result, some of these methods have a low time efficiency and incompleteness charging. and some of them lead to overcharge and gas - generation, which will result in low - efficiency, time - consuming and prone - to - damage of the charging operation

    酸蓄電池由於受到技術條件的限制,其充電主要採用恆壓、恆壓限流、恆流等常規充電模式,這些方法的充電電流未能有效的遵從馬斯所提出的可接受充電電流曲線,因而有的充電方法時間效率低、充電不完全;有的則存在著過充電和析氣等現象,並導致充電過程的低效,時和易損。
  5. The charging of lead - acid battery, the most widely accepted secondary battery, constrained to technological limitation, mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current and etc. those methods may not follow the internal physical and chemical laws within the battery, leading to serious overcharge and gas - generation, and resulting in low - efficiency, time - consumming and prone - to - damage of the charging operation

    二次電池中被最廣泛接受的酸蓄電池由於技術條件的限制,其充電主要採用恆壓、恆壓限流、恆流等常規模式,這些充電方法未能遵從電池內部的物理化學規律,大多存在著嚴重的過充電和析氣等現象,並導致充電過程的低效,時和易損。
  6. In the course of technical innovation, qiandongshan mill make the most of existing facility, tap the latent power, improved facilities efficiency ; adopted new process and energy - saving facilities, the production quota improved ; many facilities were cut down, gained it ' s ends of energy - saving and comsumption - lessening ; by technical innovation, the cost of ore processing droped greatly, benefit is remarkable in society and economy

    摘要硐山選礦廠生產技術改造充分利用現有設備設施,挖潛增效,提高了設備利用率;採用新工藝和節能設備,大幅度提高了生產技術指標;裁減大量設備,達到節能降的目的;通過技術改造,選礦成本大幅下降,取得了顯著的經濟效益和社會效益。
  7. In order to lower the comsumption of reagent, the stability experiments of pb midst standard solution were carried out, which shows that three months storage of the solution has no significant change for the experiments

    為了降低試劑消,本文進行了中間標準溶液穩定性實驗,結果表明,中間標準溶液可有效保存三個月,效果令人滿意。
  8. Experimental study on new combined steel - lead damper

    新型鋼組合能器試驗研究
  9. Chapter 3 based on several mechanical models which are used to analyze the mechanical abilities of lved, two lands of mechanical models which used to analyze the mechanical abilities of lved are compared

    第三章研究論述粘彈性阻尼器的幾種力學模型,給出模型中參數的確定方法,從描述阻尼器能準確性和合理性的角度對比兩種模型的優缺點。
  10. As energy - absorbers and bridge isolation devices, the lrb ( lead - rubber - bearings ) have the effective ability of aseismic

    銷橡膠減震支座( lrb )既是一種隔震裝置,也是一種能阻尼器,具有良好的減震性能。
  11. Energy consumption for products of lead and zinc metallurgical enterprise part 1 : energy consumption for products of zinc metallurgical enterprise

    鋅冶煉企業產品能.第一部分:冶煉企業產品能
  12. Energy consumption for products of lead and zinc metallurgical enterprise part 2 : energy consumption for products of zinc metallurgical enterprise

    鋅冶煉企業產品能.第二部分:鋅冶煉企業產品能
分享友人