鋼筋搭接 的英文怎麼說

中文拼音 [gāngjīnjiē]
鋼筋搭接 英文
bar splicing
  • : 鋼名詞(鐵和碳的合金) steel
  • : 名詞1 (肌的舊稱) muscle2 [口語] (肌腱或骨頭的韌帶) tendon; sinew 3 [口語] (可以看見的皮下靜...
  • : 動詞1 (支; 架設) put up; build 2 (把柔軟的東西放在可以支架的東西上) hang over; put over 3 (...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • 鋼筋 : concrete iron; concrete reinforcing bars; rebar; reinforcing bar; reinforced bar; reinforcing ste...
  1. Reinforcements set in the precast slabs lapped with each other at the side of the slabs. in this way, the floor stands loads in two ways. the prestress in precast slabs can improve mechanical performance and meet the demands of large room width in many building structures

    本論文主要研究單向預應力雙向疊合板樓蓋,其以預應力預制疊合底板為底模,利用板側伸出實現橫向傳力,變單向受力為雙向受力;通過二次澆築混凝土形成整體樓蓋結構;通過預制底板中單向施加先張預應力改善了樓蓋的受力性能,滿足了大開間及不同型式建築的要求。
  2. Transverse rebar shall be overlapped in priority, in the same section of overlap area, proportion of overlapped rebar connections shall not be more than 50 % of total quantity of re - bar

    4梁板橫向採用,在同一連區段內鋼筋搭接頭面積配百分率應不大於50 % 。
  3. Lapped length of steel bar

    鋼筋搭接長度36
  4. 3 - wire strands with tensile strength of 1570 mpa were collocated in the lower precast concrete slabs of superposed floor. the manner of reinforcement lap and other detailing were brought forward. plane dimensions of the tested floor are 9m and 12m, and height is 180mm

    本論文通過對前期試驗的分析總結,選用1570mpa的三股絞線作預制底板的預應力,提出了合理的板側橫向鋼筋搭接方式和其它構造措施,並按照現行規范設計並製作了試驗結構,樓蓋平面尺寸9 12m ,樓板厚度180mm 。
  5. The detail procedures of the loading test on the ultimate bearing capacity under different load cases and the author ' s first - hand experience during the tests are documented in the paper. based on the experimental performance, it has been verified that the superposed floor assembled by the precast - prestressed sandwich slab working under the design and the reliability of the lateral connecting character of the slab

    在板側縫內施加后張法無粘結預應力,在構造上利用板側伸出的相互實現橫向傳力,變單向受力為雙向受力形成裝配整體式樓蓋結構,可明顯改善樓蓋結構的受力性能。
分享友人