錐底 的英文怎麼說

中文拼音 [zhuīde]
錐底 英文
base of cone
  • 錐 : Ⅰ名詞1. （錐子） awl2. （似錐物） awl-shaped things 3. （錐體） cone Ⅱ動詞（鉆） drill; bore
  • 底 : 底助詞（用在定語后, 表示定語和中心詞之間是領屬關系, 現在多寫作「的」）
  1. Then suddenly, he thought of the awl which is used to make shoes

    情急之下，他想到了老伴納鞋底用的錐子。
  2. Any cone is a third part of the cylinder which has the same base with it and equal height.

    任一（正）圓錐是與其同底等高圓柱的三分之一。
  3. 45taper concave slope of chassiss main body elastic material output bar of case shell s main body 30strip arcual fillister of chassiss main body

    底盤主體45錐形凹坡外殼主體配置彈性導料條底盤主體長條30弧形凹槽。
  4. From up to down, food firstly arrives at material output bar, then lays off from taper concave slope, finally, food gets into round basin on baseplate after mutual effect through arcual fillister

    食品從上而下先到達彈性導料條，再到錐形凹坡下料，最後通過弧形凹槽的相互作用，食品到達底盤上圓形食盆。
  5. All vertices are clipped by the bottom plane of the viewing frustum

    所有頂點都被視圖截錐的底平面所剪裁。
  6. Laboratory glassware. round bottom flasks. flat bottom flasks. flasks with conical ground glass joint

    實驗室用玻璃器皿.圓底燒瓶.平底燒瓶.錐形磨口燒瓶
  7. Bottom water coning is an important factor affecting reservoir development effect, causing earlier water breakthrough, rapid water cut increase and production decrease

    摘要底水錐進是影響底水油藏開發效果的重要因素。
  8. Implants for osteosynthesis - bone screws and auxiliary equipment - specification for screws having symmetrical and asymmetrical thread and conical undersurfaces

    接骨用植入物.接骨螺釘和輔助設備.有對稱和不對稱螺紋及圓錐形底面的螺釘規范
  9. The effective reflection area of a cubic corner reflector is defined, it is testified for the cubic corner reflector that the ray reflect from this prism is not parallel with the ray incident on the corner of undersurface of this prism, the effective reflection area is calculated in the case of the ray incident on the undersurface of this prism vertically, the acreage of the effective reflection area is two thirds as that of the undersurface of this prism

    定義了立方角錐棱鏡的有效反射區，證明了立方角錐棱鏡底面角部區域（即非有效反射區）入射光與出射光不平行，並且在入射光垂直棱鏡底面入射情況下計算得有效反射區的面積為底面的三分之二。
  10. By means of the ironing effect of heating - plate and the beating effect of vibrating - roller. the surface of toe part or heel - seat will be made flat and will have a better edge

    本機利用圓錐滾軸對放在熱底模上的鞋底不斷振動和推壓來實現按摩去皺。
  11. However, both of them have disadvantages. mo tip feas is fabricated by evaporating tip cathodes on base, so it has bad coherence with the base. on the other hand, the characteristics of silicon result in the bad heat stability, bad emission reliability, and low current density

    然而，這兩種陰極存在各自的缺點，如鉬尖錐是蒸鍍在基底上的，所以與基底的附著力不強;而硅的特性又決定了其熱穩定性差，發射的可靠性低，發射電流有限。
  12. Road vehicles - m18 x 1, 5 spark - plugs with conical seating and their cylinder head housing

    道路車輛.帶有圓錐形底座的m18x1 . 5火花塞及其汽缸蓋外殼
  13. Road vehicles - m18 1, 5 spark - plugs with conical seating and their cylinder head housing iso 2345 : 1994

    道路車輛.錐形底座m18 1 . 5火花塞及汽缸蓋座孔
  14. Jordan algebraic technique provides a useful tool for describing and analyzing symmetric cone optimization problem, and the jordan frame plays an important role in euclidean jordan algebras

    摘要若當代數技術是描述和分析對稱錐優化的一個有效工具，若當基底的歐幾里德若當代數中具有重要的作用。
  15. Cone bottom bucket

    錐底式料桶
  16. Specification for open bottomed taper plug valves for 1st, 2nd and 3rd family gases up to 200 mbar

    壓力可達200毫巴家庭用一類二類和三類燃氣敞口底部錐形旋塞閥規范
  17. The military organisation may be with perfect accuracy compared to the figure of a cone, the base of which, with the largest diameter, consists of privates ; the next higher and smaller plane, of the lower officers ; and so on up to the apex of the cone, which will be the commander - in - chief

    軍事組織酷似圓錐體，直徑最大的底部是由列兵組成的比底部較高的截面，是由較高級軍事人員組成的由此類推，直到圓錐體的頂端就是總司令了。
  18. The article starts from the features of the tapered involute spline analyses the characters of hob design, expounds the main steps in the tapered involute spline bob design

    摘要從錐底漸開線花鍵的特徵著手，分析了滾刀設計的特點，給出了錐底漸開線花鍵滾刀設計的主要步驟。
  19. Chute, which is connected with the bottom of funnel cone, is designed to be as close as possible to the mill table

    與漏斗錐底部連接的溜管要設計得與磨盤越近越好。
  20. The conical insulator high 15 cm, the diameter of top is 5cm and that of the bottom is 35cm. the insulator is operated for more 300 times on voltage more 600kv, and maximum voltage is 750kv. the operated is stability and no surface flashover phenomenon is happened

    錐形絕緣子高15cm ，錐底直徑35cm ，錐頂直徑5cm ，實驗結果表明滿足設計要求，在600kv以上工作300多次，最高電壓達750kv ，運行穩定，未發生沿表面閃絡現象。
分享友人
分享到 Line

分享到臉書