錐殼結構 的英文怎麼說

中文拼音 [zhuīkéjiēgòu]
錐殼結構 英文
conical shell structure
  • 錐 : Ⅰ名詞1. （錐子） awl2. （似錐物） awl-shaped things 3. （錐體） cone Ⅱ動詞（鉆） drill; bore
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. The common hypotheses of the shell structure aren ' t alterative in the new finite element method, and it finishes the solution through the integral of the different laminas

    新單元的計算方法不改變殼體結構的一般假設條件，利用厚度方向分段積分來完成問題的求解，並對層合截錐殼進行計算。
  2. Practical method for analyzing plate - cone reticulated shell

    板錐網殼結構的實用計算方法
  3. Direct dynamic analysis of plate - cone cylindrical reticulated shell subject to earthquake action

    板錐柱面網殼結構地震響應的動力時程分析
  4. The effects of r / h ratio, l / r ratio and cone angle on the dynamic response of the conical shells are discussed in this section

    分析了圓錐殼結構的徑厚比、長徑比及錐角變化對結構應力響應的影響。
  5. Abstract : the end basket with a form of double layered conical weave net is simplified into a model of continuous conical shell - beam combined structure and in accordance with the test results of experimental modal analysis. a part of geometrical and material parameters of the conical shell in the model are identified to get an equivalent mechanical model which has the same dynamic characteristics as that of the prototype structure. by simulation and experiment, the effectiveness of the method offered is fully verified

    文摘:將大型汽輪發電機定子端部的雙層圓錐型編織網殼簡化為連續錐殼-梁組合結構.根據實際結構的試驗模態分析所得到的模態參數識別模型中錐殼的部分幾何、彈性參數，獲得了與定端繞組實際結構具有相同動特性的當量力學模型.對實際機組的計算和實驗結果證明了本文中的方法是可行的
  6. In the paper, the latticed shell of double - layer hyperbolic pyramid is vertically applied to the structure of cooling tower and reinforced concrete planks with ribs are put up around the latticed shell, in accordance with situation that the most latticed shells are applied to lateral roof and cooling tower is put up by the reinforced concrete structure, a kind of new construction that includes the lower reinforced concrete structure and the upper latticed shell structure is established

    本論文把雙層雙曲線四角錐網殼結構豎向應用於冷卻塔的筒壁，在網殼的周圍掛鋼筋混凝土帶肋板。由於目前大多數網殼結構都水平應用於屋蓋或樓蓋結構和冷卻塔筒壁大多數採用鋼筋混凝土結構，本文的研究形成了一種上部網殼結構下部鋼筋混凝土結構的新型結構。
  7. The opening stress and the life of crack growth is calculated and compared with the test results and the experience formula. the feasibility of the newman theory of opening stress used in the high strength steel is validated. then through the slice synthesis method, the three dimension surface crack of the weld joint of cone - cylinder is decomposed into many plane through cracks

    本文將基於裂紋閉合現象建立的帶狀屈服模型，用在平面貫穿裂紋中，計算此時的裂紋張開應力和疲勞裂紋擴展壽命，與試驗結果和經驗公式比較，驗證newman裂紋張開應力理論在高強鋼中的可行性；然後，用切片合成法，把潛艇結構凸錐柱結合殼焊縫處的三維表面裂紋分解成平面貫穿裂紋，用帶狀屈服模型的理論來分析平面貫穿裂紋，得到裂紋沿深度方向的擴展速率，進而得到潛艇結構的疲勞壽命。
  8. The calculating mold consisted of shell, pyramidal neck of shell with varied thickness, flange of ring with definite thickness for analytic solution is set up for the strength calculation and the design of the structure dimension of shell flange and pyramidal neck. this theoretic solution is compared with the results of finite element analysis and stress - strain measurement and is verified to be right

    為設計計算烘缸法蘭及錐頸的強度與結構尺寸要求，建立以簡體、具有斜面的變厚度圓柱殼的錐頸及具有一定厚度圓環的法蘭環為解析解的計算模型，進行應力求解，將該理論解與有限元分析及應力應變實測結果進行分析對比，驗證該解結果的正確性。
分享友人
分享到 Line

分享到臉書