鍋爐水管 的英文怎麼說

中文拼音 [guōlúshuǐguǎn]
鍋爐水管 英文
boiler water tube
  • 鍋 : 名詞1. （炊事用具） pan; pot 2. （裝液體加熱用的器具） boiler; cauldron3. （某些器物上像鍋的部分） bowl （of a pipe, etc. ）
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 鍋爐 : boiler; furnace
  • 水管 : waterpipe; water carrier; aqueduct; water conduit; water pipe; syphon; siphon （消防） 水管車 hos...
  1. The afterheat, which is collected by recovery devices, in winter can be used as the low level thermal source of heat pump, and in summer can preheat feed water, thus equivalent an economizer. because energy flows in the system so reasonably that energy is used to the most, therefore, its energy conservation effect is significant, and the operating expenditure declines consequently. the sewage can be reused after due treatment, thua it has a certain social and ecological benefit, too

    本研究中選用分離式熱管裝置提供洗浴用水，利用水源熱泵裝置，一機兩用，進行空間供熱和製冷，並通過余熱回收器對系統內的余熱進行回收，冬季可作為水源熱泵的低位熱源，夏季可對鍋爐給水進行預熱，起到「省煤器」的作用。這樣實現系統內的能量合理流動，從而達到節能的目的，同時洗浴污水經適當的處理后可以回用，因而還具有一定的社會和生態效益。
  2. The main production includes heat - pipe, heat - pipe exchanger setting, rubber tyre hot water deaerate power station, boiler deaerator, tyre forming machine, rubber cutting machine, vulcanize, vulcanizing pot and the special carbon steel or stainless steel pot for oil, chemical engineering, medicine, chemical fertilizer field use

    濟南仙峰泰山化工設備有限公司主要生產熱管、熱管換熱器、橡膠輪胎廠子午胎斜交胎熱水除氧動力站、鍋爐除氧器、輪胎成型機、切膠機、硫化機、硫化罐，還有石油、化工、化肥、醫藥、冶金、建材等行業使用的各種碳鋼、不銹鋼、有色金屬的塔、罐、釜、換熱器等產品。
  3. This paper introduces the boiler water disposal system and its traditional chemicals adding method in kusan pipeline, then describes anew method of adding chemicals into deoxidizer

    摘要介紹了庫鄯管道鍋爐水處理系統及其加藥方式，針對傳統加藥方式存在的問題提出在除氧器內加藥的改進措施，並對除氧器內加藥的可行性進行分析。
  4. Manufacturers ' data report for watertube boilers, superheaters, waterwalls, economizers

    水管鍋爐過熱設備爐壁水管排和熱力裝置的生產商數據報告
  5. Boiler feed pipe

    鍋爐給水管
  6. Increscent weight of oxidation, graphic and micrographic were explored, meanwhile, the mechanism of anti - erosion and wear - resistant of new coating material are also studied. at last, a program applied to calculate the temperature distribution and heat transmission between water wall tubes with sprayed coatings and metal anti - erosion tile was developed by use of visual basic

    文中最後採用vb6語言計算機編程，計算了不同材料塗層對鍋爐水冷壁管的傳熱效果及徑向溫度梯度的影響，同時與加裝了防護瓦和未加任何防護的水冷壁管進行了比較。
  7. Measurement precision contribute to improving the security class and economic of boiler running and automatic level of whole plant. the smart measurement instrument of the boiler ’ s air flow designed in the thesis and the instrument can make the degree of accuracy get to. firstly, the thesis build the “ velocity - area ” method which is on basis of “ log - tchebycheff ” on the analyzing of basic measure method of boiler ’ s air flow. secondly, model86 averaging pitot tube was selected the right model of flow transducer which can pickoff the differential pressure and static pressure. modelc264 which made in setra system corp. u. s. a was selected as ultra low differential pressure transmitter. a good flow of boiler ’ s air was calculated by offsetting pressure and temperature. finally, numeroscope was designed with z80cpu and other chips

    精確的監測有助於提高鍋爐燃燒的安全型、經濟性，也有助於提高電廠的整體自動化水平。本文設計的智能化鍋爐風量測量裝置能夠實現對鍋爐送風的精確測量，精度可達。本文首先研究鍋爐送風矩形大管道測量理論，提出在流來流量測量測點布置基於「對數-切比雪夫」法的速度-面積法。
  8. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  9. Boilers - 1 mpa tubular type water gauges

    鍋爐. 1 mpa管型水位計
  10. Rent : usd7500 / month or rmb 62000 / month. include tax, management fee, maintenance fee for elevator, air conditioner, heating floor system, hot water boiler, water softener system

    月租：美金8000元。包稅金，管理費，電梯維修保養費，空調保養費，地暖保養費，鍋爐及軟水系統保養費。
  11. With thermal spray technology, the surface of water wall tubes is easily covered by varied high performance coatings. in this paper, several new alloy and cermet coatings applied to water wall tubes were designed and their performance was studied according to the research item of hanchuan power station of hubei province " the study and development on the corrosion - resistant and wear - resistant coatings of water wall tubes in boiler "

    採用熱噴塗技術可以方便地在鍋爐管道表面獲得各種高性能的防腐耐磨塗層。本文結合湖北省漢川電廠的研究項目「鍋爐水冷壁管防腐耐磨塗層的開發研究」進行水冷壁管新型合金和金屬陶瓷復合塗層的設計和性能研究。
  12. Tubular or water tube boiler

    水管鍋爐，火管鍋爐
  13. Shell boilers - requirements for feedwater and boiler water quality

    火管鍋爐.給水和鍋爐水質的要求
  14. For manufacture water cooling panels, coal - saving devices, reheaters, superheaters and steam pipelines of boilers

    用於鍋爐水冷壁、省煤器、再熱器、過熱器和蒸氣管道的製造。
  15. Shell boilers - part 10 : requirements for feedwater and boiler water quality

    火管鍋爐.第10部分:鍋爐給水和鍋爐水質量要求
  16. The water wall tubes were leaked by the high temperature corrosions, which put the boiler units shut down and made the safety and economy operation of the power plants effected severely, which also made the safety generation and dispatch of the all power network effected severely

    鍋爐水冷壁高溫腐蝕造成水冷壁管爆漏，迫使鍋爐停機，嚴重影響了電廠運行的安全性和經濟性，對整個電網的安全生產和調度也造成了嚴重的後果。
  17. Analysis on reason of waterwall tube weld leakage of supercritical boiler

    超臨界鍋爐水冷壁管焊縫泄漏原因的分析
  18. Experimental study on frictional flow resistance in water wall tubes of a 600 mw supercritical once - through boiler

    直流鍋爐水冷壁管阻力特性的試驗研究
  19. The coatings deposited with a new subsonic flame spraying possess high bonding strength, low porosity and is low costly, at the same time, it is applied to the worksite of boiler tubes specially. the coatings applied to water wall tubes were deposited by subsonic flame spraying in this study

    本課題採用了一種新型亞音速火焰噴塗技術制備鍋爐水冷壁管道塗層，其塗層不僅結合強度高、孔隙率較低，而且塗層制備的成本低，特別適用於鍋爐水冷壁管的現場噴塗。
  20. Thedeviation was caused by the influence of the condensate temperature in the equalizer andthe positive / negative sampling tubes as well as by the effect of the high ambienttemperature

    對此，分析了鍋爐水位偏差的原因有平衡容器內凝結水溫度問題，正負壓取樣管內凝結水溫差的問題及環境溫度高的問題。
分享友人
分享到 Line

分享到臉書