鍍鎳層 的英文怎麼說

中文拼音 [niècéng]
鍍鎳層 英文
nickel coating
  • : 動詞(用電解或其他化學方法使一種金屬附著到別的金屬或物體表面上) plate
  • : 名詞[化學] (金屬元素) nickel (ni)
  • : i 量詞1 (用於重疊、積累的東西 如樓層、階層、地層) storey; tier; stratum 2 (用於可以分項分步的...
  1. The plating measuring results were agreed well with the conclusion. thus, phosphorus generation mechanism of complex heterocatalysis was proposed. meanwhile, concentration ratio of niso _ 4 and nah _ 2po _ 2 also greatly affects the phosphorus content

    同時研究發現,在絡合體系相同的情況下,次亞磷酸鹽和硫酸的濃度比對化學鍍鎳層中磷的含量有很大的影響。
  2. The photograph of sem showed that its surface have homogenously coated with nickel, although the hollow glass beads were crashed by agitation and heating. after pretreatment and nickel plating, the dispersity of mica powders evidently improved and the infrared emissivity decreased from 0. 85 to 0. 43, and has certain wave absorbability of radar

    對雲母的化學工藝研究中,發現經過預處理后雲母表面獲得了,通過掃描電鏡分析,后雲母的分散性提高,表面狀態發生了較大的變化,法向積分發射率顯著降低,由0 . 85降低為0 . 43 。
  3. ( 1 ) first, metallizing abs plastics surface by chemical coarsing, metal ion absorption, metal ion reducing and chemical copper - plating. then, the copper - coating was thickened by electroplating in order to improve adhesion between following - coating and plastics matrix, and nickel was preplating. finally, ni - sic composite was plated

    ( 1 )通過反復實驗,確定工藝流程:首先通過粗化、敏化、活化和化學銅,使塑料表面金屬化,再電銅加厚銅,增強后續與塑料基體的結合力,然後預,最後電ni ? sic復合
  4. The coating can be white zine, color zine, nickel, phosphate processing or resin

    磁體表面防氧化可採用白鋅、五彩鋅、、磷化、或環氧樹脂噴塗。
  5. And then electroplate nickel - sealing with solid particulate, which is to make micro - crack chromium when electroplating chromium again, this can avoid unsmoothness, and slower corrosion speed, as a result, improve defence performanc e

    含有固體微粒的封,令到再鉻時形成微孔鉻,從而防止產生大而深的直貫基體金屬的少量腐蝕溝紋和凹坑,向橫向發展,減緩了穿透基體的腐蝕速度,進一步提高了防護性能。
  6. Study of the corrosion resistance of electroless ni - p coating on aluminium alloy

    鋁上化學鍍鎳層耐蝕性研究
  7. Colorization of chemical deposition for ni - p alloy

    化學的著色處理
  8. Standard test methods coating weight and chemical analysis of zinc - nickel alloy electrolytically coated on steel sheet

    鋅合金薄鋼板的塗重量和化學分析的標準試驗方法
  9. As an initial stage on the process of foamed nickel preparation, a layer with low phosphorus content nickel deposit is applied on polyurethane foam substrate as a conducting layer

    在制備泡沫材料的過程中,首先要求在聚氨酯海綿基體上低磷化學制備導電
  10. Othogonal testing method was employed to screen electroless nickel bath composition producing deposits with phosphorus content of wtl. 5 %. the paper also discussed the effects of ni2 + concentration, h2po2 - concentration, triethanolamine concentration and bath temperature on phosphorus content of electroless nickel deposits respectively

    本研究採用正交試驗方法,篩選並確定了磷含量為1 . 5的最佳低磷化學配方,並研究了硫酸濃度、次磷酸鈉濃度、三乙醇胺濃度和溫度對磷含量的影響。
  11. Meanwhile, properties of cobalt - tungsten, nickel, cobalt deposit as copper barrier at temperature between 400 and 800 were compared

    同時比較了在400 800下,鈷鎢合金、鈷的防銅滲能力。
  12. Metallic coatings. acceptance conditions for nickel - and chromium - plated zinc alloy parts

    金屬.鉻的鋅合金零件的驗收條件
  13. Rapid determination of phosphorus content in electroless ni - p coating

    化學鍍鎳層中磷含量的快速測定
  14. The assembly shall have a electroless nickel - plated tubular copper body

    這種總成應該具有非電鍍鎳層管狀銅閥體。
  15. Technics for improving die - cast aluminum case electroless nickel coating quality

    提高壓鑄鋁外殼化學鍍鎳層質量工藝
  16. High temperature oxidation resistance of nickel multiple plating containing sio2, zro2 particles

    2微粒復合鍍鎳層抗高溫氧化性能
  17. Nickel plated overlay in stem hole for carbon steel valves to combat severe alkylation conditions

    碳鋼閥門採用閥桿孔內鍍鎳層的閥桿,適用於嚴酷的烴化應用環境。
  18. The influences of different pretreatment techniques on the adhesion of electroless nickel plating on magnesium alloy have been studied in this paper

    摘要研究了鎂合金多種前處理工藝對化學鍍鎳層與基體之間結合力的影響。
  19. Standard test method for measurement of coating thicknesses by the magnetic method : electrodeposited nickel coatings on magnetic and nonmagnetic substrates

    用磁性法測量磁性和非磁性基底上的電解沉積鍍鎳層厚度的標準試驗方法
  20. The adhesive force between the coating and the magnesium substrate has been estimated by using bend test, file test, and scribe test

    採用彎曲法、銼刀實驗法和劃線劃格實驗3種結合力測試方法,對化學鍍鎳層與鎂合金基體之間結合力的優劣進行了定性評價。
分享友人