鎢化合物 的英文怎麼說
中文拼音 [wūhuàgěwù]
鎢化合物
英文
tungsten compound-
While if pulse laser ablation is applied, the output of mixed target is obviously more than that of plumbago target. the carbon nanotubes prepared by nano - tungsten catalyzer are very straight without any bent and their diameters are under 10nm. it is worth to pay more attention and need to study further
其中以鎢作為催化劑原料與石墨混合製成固體靶,蒸餾水作為流動相時,得到的納米纖維狀產物直徑不到10nm ,而且形狀筆直,值得關注,目前國內外尚無以鎢作為催化劑成功制備納米一維碳材料的報道,因此該研究具有嶄新而廣闊的研究前景。The particles distributed hi the matrix of grey cast iron, but some contact each other. the composite layer extend gradually into the substrate. when volume fraction of wc is 36 wt % and 27 wt %, the matrix of the composite is high chromium cast iron, consist of white carbide bars and the austenite. wc particles distributed uniformly, retaining approximately quondam granular form in the composite layer which has an evident interface area with the substrate, with good bonding strength
對不同碳化鎢體積分數的灰鐵和低鉻鑄鐵基復合材料的微觀組織結構分析表明:碳化鎢體積分數為52時,復合層內基體為灰口鑄鐵組織,顆粒直接分佈在灰鐵基體上,部分碳化鎢顆粒有相互接觸的現象,基材與復合層之間沒有明顯的過渡;碳化鎢體積分數為36 、 27時,復合層內基體為高鉻鑄鐵,由面塊狀的奧氏體和白條狀碳化物組成,碳化鎢顆粒表面固溶於基體組織中,粒形基本保持完整,分佈均勻,與基體構成冶金結合,基材與復合層之間存在一個明顯的平緩過渡區。Abstract : analytical methods for impurities in tungsten and tungstic compounds in recent 10 years were reviewed. among them were atomic emission spectrometry , atomic absorption spectrometry , mass spectrometry , electrochemical analysis , spectrophotometry and activation analysis. 53 references were cited
文摘:綜述了近10多年來鎢及其化合物中雜質元素的分析方法,涉及方法包括原子發射光譜法、原子吸收光譜法、分光光度法、質譜法、電化學分析法以及活化分析法等。Chemical analysis methods for non - rare earth impurities of rare earth metals and their oxides - determination of molybdenum and tungsten content - inductively coupled plasma atomic emission spectrographic method and inductively coupled plasma mass spectrum method
稀土金屬及其氧化物中非稀土雜質化學分析方法鉬鎢量的測定電感耦合等離子體發射光譜法和電感耦合等離子體質譜法To test the validity of the model, hybrid inorganic / organic complementary ecd, comprising a tungsten oxide ( wo3 ) and polyanilinc ( pani ) thin film couple in combination with a proton - conducting polymer electrolyte, is studied
為了要測試這個模型是否準確,對混合有機以及無機物的互補式電致色變元件進行研究,結合三氧化鎢和聚苯胺薄膜與導氫離子高分子電解質構成一互補式電致色變元件。Abstract : polyphenylacetylenes were synthesized by rn ( nbd ) cl 2 and wcl6 / ph4sn catalyst systems in n2 at room temperature. polymers with high yield and high molecular weight were obtained. their structures were characterized by uv, ir, nmr and gpc, respectively. the fluorescence of the polymer solution with different concentration was investigated using variable excitation wavelength from uv to visible region. the relation between fluorescence and polymer structure was studied. the results showed that the molecular chain structure has great influence on fluorescence of the polymers. the emitting peak wavelength of fluorescence for the polymer of high stereoregularity is independent of solution concentration and excitation wavelength. the emitting peak wavelength of fluorescence for the polymer with disordered molecular chain arrangement varies with changing the solution concentration and excitation wavelength, and different emission sites in molecular chains and low emitting yield are shown. the measurement and analysis of fluorescence spectroscopy of polyphenylacetylenes may provide some useful information to judge the molecular chain arrangement in some conjugated polymers
文摘:使用有機金屬銠、金屬鎢/四苯基錫催化劑體系聚合苯乙炔,分別獲得了高產率和高分子量的聚苯乙炔.使用uv , ir , nmr , gpc等分別對聚合物結構進行了表徵.採用不同波長的激發光對聚合物熒光性能進行研究,詳細分析了聚合物結構與熒光性能之間的關系.研究結果發現,不同聚合物結構對聚合物熒光性能產生很大影響,規整性高的聚合物,將有較高的發光量子效率;聚合物規整性差,將可能導致多個熒光發光結構點,其熒光強度降低.聚合物熒光光譜研究將對某些共軛聚合物結構的規整性分析提供一些有用的信息The arc physical characteristic of mixed gases ( ar + he + co2 ) and its effects on weld shaping were discussed
摘要採用鎢極氬弧焊對不同比例氬氦二氧化碳混合氣體的電弧物理特性及其焊縫成形進行了實驗。Abstract : comparision is made between the characteristics of recovered wcand conventional wc by clectronic probe detection. in view of perfect crystal lization, less defect in the crystal and sufficient compound carbon, cemented carbide superior to conventional wc is developed by process optimization to compensate for the high o2 content and more inclusions in the recovered wc
文摘:用電子探針檢測手段對比了回收碳化鎢和一般碳化鎢的不同特性,從回收碳化鎢具有結晶完整、晶內缺陷少、化合碳充足等優良性能出發,用工藝優化手段彌補回收碳化鎢氧含量高、夾雜物多等缺點,試制出了性能優于用一般碳化鎢生產的硬質合金。It is very popular to be used for the welding of orbital tube, pipe, very small parts, short welding cycles and also where a specific number of welds are called and then the electrode is to be replaced. cerium tungsten electrode, tungsten cerium electrodes, w - ce electrode, ce - w electrodes, tungsten electrode, tungsten
鎢鈰並不適合於高電流條件下的應用,因為在這種條件下,氧化物會快速的移動到高熱區,即電極焊接處的頂端,這樣對氧化物的均勻度造成破壞,因而由於氧化物的均勻分佈所帶來的上述好處將不復存在Industrial test of high speed steel making in electric arc furnace by direct reduction and alloying with tungsten molybdenum vanadium oxide ore
電弧爐鎢鉬釩氧化物礦直接合金化冶煉高速鋼工業試驗分享友人