鏡煤巖 的英文怎麼說

中文拼音 [jìngméiyán]
鏡煤巖 英文
vitrite
  • : Ⅰ名詞1 (鏡子) looking glass; mirror 2 (幫助視力或做光學實驗的器具) lens; glass 3 (姓氏) a s...
  • : 名詞(黑色固體礦物) coal
  • : 名詞1. (巖石) rock 2. (巖峰) cliff; crag
  1. In adding - acid system : the resistivities of different lithotypes " cp tend towards being constant and equal when weight percentage of aniline exceeds 50 % ; because of the structure difference of different lithotypes, the polymerizing places and processes are different ; the resistivities of vituain / pan and fusain / pan reach the lowest point respectively when ( ntloisiog / an is 0. 6, 1. 0 ; the resistivities of cp decline fast and tend towards being constant along with the reduction of diameter of coal. in not adding - acid system : the resistivities of different lithotypes ' cp decline evenly ; it is found on the crossed experiment of cp, that ( nflsaog / an mole proportion is the most important factor to influence output ratio of cp and the weight percentage of aniline is the most important factor to influence resistivities of cp. according to the result of the crossed experiment of cp

    在有外加酸體系中:苯胺百分含量大於50時,不同組分的電阻率趨于恆定和一致;由於不同組分結構上的差異,導致苯胺聚合場所和聚合過程的不同;當過硫酸銨/苯胺摩爾比為0 . 6 , 1 . 0時,-聚苯胺導電材料電阻率和絲炭-聚苯胺導電材料的電阻率分別達到最低值;在無外加酸體系中:不同組分/聚苯胺導電材料的電阻率隨著聚合時間的增加而均勻下降,並在8小時左右達到恆定;在對絲炭-聚苯胺導電材料進行的正交試驗中發現:過硫酸銨/苯胺摩爾比對產率的影響最大,苯胺重量百分比對產率影響最小,而對產物電阻率影響最大的是苯胺重量百分比。
  2. In accordance with coal sample observation by scanning electron microscope ( sem ) and researches based on such subjects as anthracology, tectonic geology and material mechanics, the endokinetic fractures in coal are further classified into dewatering fractures, condense fractures and static pressure fractures, while the exogenetic fractures are further divided into tensile fractures, pressure fractures, shrink fractures and slack fractures, consistent with the development regularity of the geometric shapes, sizes and arrangement of fractures

    摘要分析、歸納了大量的掃描電子顯微觀測結果,以學、構造地質學研究?基拙,依鋸中顯微裂隙的形態、大小、排列組合等發育特徵,將內生裂隙進一步劃分?失水裂隙、縮聚裂隙、靜壓裂隙,將外生裂隙進一步劃分?張性裂隙、壓性裂隙、剪性裂隙、鬆弛裂隙。
  3. Petrographic analysis of bituminous coal and anthracite - method of determining microscopically the reflectance of vitrinite

    和無煙相分析.第5部分:反射率顯微測定方法
  4. Multi - hierarchical, multimeans, comprehensive and deepened research on the macrofractures, microfractures system and pores system features, capacity of cbm storage and osmosis, adsorption characteristic, as well as physical properties of surrounding rocks of coal reservoirs have been made. furthermore, classifying standard and identifying characteristics for fractures - pores system of low coal rank coal reservoirs in zhungaer basin has been put forward as well. in this process, some routine instrument are used, such as viewing coal mine scene and hand specimen, observing polished section and surface which are made from lump coal and powder coal samples, observing and image analyses under the common microscope ' s transmitted light, reflection light and fluorescence

    通過礦井現場、下觀察統計等常規手段,採用多種先進儀器和測試技術展開對儲層的裂隙系統與孔隙系統發育特徵、儲滲性能、吸附特性及儲層圍物性特徵的多層次、多手段分析,並綜合室內外觀測及前人成果,提出了儲層裂隙與孔隙系統的劃分標準與識別特徵,分別從宏微觀尺度、定性與定量層次對裂隙與孔隙系統特徵及其與儲層儲滲性能關系的研究。
  5. The results show that there is distinct relation between reflectance of vitrinite and coal classification, though this correspondence is relatively complex, especially in low - medium metamorphic bituminous stage where coals with same sometimes can be divided into different classes

    研究表明:質組反射率與種之間的關系較復雜,特別是在中低變質煙階段,相同變質程度往往歸屬于不同種,受組成和還原程度的影響較大。
分享友人