鏡片厚度 的英文怎麼說

中文拼音 [jìngpiānhòudù]
鏡片厚度 英文
lens thickness
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 片 : 片構詞成分。
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 鏡片 : [光學] lens; optic
  1. Material and methods normal rats of male sd were divided into young, adult, and aging groups. preparation of samples for light microscopy : animals were anesthetized by peritoneal injection of 6 % chloral hydrate ( 0. 5ml / 100g body weight ). perfusion and fixation of animals were carried out by a common procedure : 37 normal saline 50 - 100 ml and then 4 % paraformaldehyde pbs 100 - 400ml were perfused through the left ventricle of the heart, the whole procedure was lasted for about somin. the entire brain was dissected out and dipped in the fixative solution for 12h at 4. brain pieces targeted were choosen and then passed the graded alcohols for dehydration, dipping into paraffin for embeding, and reshaping the pieces

    2 ）磷酸緩沖液100400m ， 30分鐘灌注完畢，取出整腦，在上述固定劑oc ）內后固定12小時。切取觀察部位腦塊，然後，進行梯度酒精脫水，浸蠟，包埋，修塊，石蠟連續切片（德國leica石蠟切片機人切片厚度still ， zlllll ，蛋自甘油載片撈片， 60c烤箱過夜，二甲苯脫蠟，梯度酒精置換，浸水， h六染色，梯度酒精脫水，二甲苯透明，中性樹脂封片。室溫風干后，顯微鏡觀片， olympus萬能顯微鏡照相。
  2. However, spectacles are made of thick convex lens. skills and precautions are needed to wear contact lens properly. both are not suitable for the elderly

    不過，這些眼鏡片有相當的厚度，配戴隱形眼鏡亦需要一些特別技巧，對于年紀較大的患者未必適合。
  3. In this paper, the methods that the author used are as follows : light microscopy : the testis was fixed in bouin ' s fluid, dehydrated in an ethyl alcohol series, embedded in paraffin, sectioned at 6 u m and stained with hematoxylin and eosin, then observed with olympus microscopy and photographed

    光鏡樣品以bouin ' s固定液固定，系列酒精脫水，石蠟包埋，切片厚度6 m ，蘇木精、伊紅染色， olympus顯微鏡觀察並拍照。
  4. The research result indicated : for the strip primary mirror discussed in this article, the hexagon light - weighted cell has the best structural rigidity quality, the square cell is a little worse, the triangle cell is the worst ; there is an optimum on primary mirror thickness ; on condition of 1g gravity load combining with 4 centigrade uniform temperature rising, the thinner and higher of the flexible support reed, the better of the primary mirror surface figure. the decision of the structural parameters of the flexible support reed must take static rigidity, dynamic rigidity, static strength and dynamic strength of primary mirror assembly into account

    研究結果表明：對于本文的長圓形主鏡，採用正六邊形輕量化孔，鏡體結構剛性品質最好，正方形次之，正三角形最差；主鏡鏡體厚度存在最佳值；主鏡組件在1g重力、均勻溫升4共同作用的工況下，主鏡柔性支撐簧片厚度越小、高度越高，主鏡綜合面形誤差（ p - v值）越小，但同時主鏡組件的剛體位移增大、固有頻率下降，因此柔性支承結構參數的確定要綜合考慮主鏡的綜合面形誤差和主鏡組件靜態剛度、動態剛度、靜態強度和動態強度等因素。
  5. The result of transmission electron microscope ( tem ) showed that layers of layered silicates were exfoliated and dispersed in matrix homogeneously. according to statistical data, average thickness of layers was lonm, and the thickness of the biggest layers was less than 40nm, only a few layers were exfoliated in monolayer whose thickness was about inm

    透射電子顯微鏡（ tem ）照片顯示：層狀硅酸鹽片層發生剝離，片層均勻分散在nbr基體中，統計表明片層的平均厚度約為10nm ，最大的聚集體的片層厚度達到40nm ，推斷有一小部分片層剝離成單晶層的形式，厚度為1nm 。
  6. Finally, the size of ba - ferrite fine magnetic particles was measured and analyzed from sem image which was treated using a better technology, and the functions of the particle thickness, diameter and their ratio were obtained

    對較佳工藝條件下得到的掃描電鏡照片進行測量和分析，得到顆粒的厚度、直徑和厚徑比的函數分佈。
  7. That is, by the calculation of the anti - thermal deformation quality factor and synthetic quality factor of some typical primary mirror materials, the primary mirror material is selected scientifically and rationally. by the finite element method and the conception of structure rigidity quality factor, researching the relation between the light - weighted cell shape, the mirror thickness and mirror structural rigidity quality. by the force - thermal coupling analysis of the primary mirror assembly, the relations between the thickness, height of the flexible support reed and primary mirror synthesis surface figure error ( p - v ) have been researched

    即，通過對常用主鏡材料的抗熱變形品質因數和綜合品質因數的定量分析，科學地完成了主鏡的選材；應用有限元分析方法，藉助于結構剛性品質因數的概念，研究了主鏡輕量化孔的形狀和主鏡厚度對鏡結構剛性品質的影響；通過對主鏡組件的力熱耦合分析，研究了主鏡柔性支撐簧片厚度與高度對主鏡面形的影響。
  8. For the flexible support reed is very thin ( 1. 3mm ), it ' s necessary to study the buckle of the primary mirror assembly. the calculation indicates that when space camera is launched, the primary mirror assembly would work well

    為了滿足主鏡的設計約束條件，主鏡柔性支撐簧片厚度設計的較薄（ 1 . 3mm ） ，因此有必要對主鏡組件的結構穩定性進行校核。
  9. Lens thickness measure

    鏡片厚度測量器
  10. Cytochemical methods : the testis was fixed in cold acetone, embedded in paraffin, sectioned at 6 u m, observed with olympus bh - 2 microscopy and dna was showed with feulgen, glycogen was showed with pas

    細胞化學樣品以冷丙酮固定，常規石蠟包埋，切片厚度為6 m ， feulgen反應顯示dna ； pas反應顯示糖原顆粒， olympusbh - 2型顯微鏡觀察。
  11. A five - phase numerical model based on prism coupled is derived from maxwell equation and fresnel equation. using the professional software - mathcad, characteristic of this numerical model is simulated. the relationships between depths of the metal film, bio - sensitive film, cover slide, the refractive index of bio - sensitive film and the resonant angle ospr has been discussed respectively

    根據maxwell方程和fresnel方程推導出5層棱鏡耦合spr數值化模型，利用數學軟體mathcad對該數學模型進行了模擬，討論了金屬膜厚度d _ 2 、生物膜厚度d _ 3和折射率n _ 3 、載玻片厚度d _ 1與諧振峰值_ （ spr ）的關系。
分享友人
分享到 Line

分享到臉書