鐵感應 的英文怎麼說

中文拼音 [tiěgǎnyīng]
鐵感應 英文
core induction
  • 鐵 : Ⅰ名詞1 （金屬元素） iron （fe） 2 （指刀槍等） arms; weapon 3 （姓氏） a surname Ⅱ形容詞1 （形容...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  1. The magnet of kaiyuan ct permanent canister magnetic dressing machine is made of the high quality ferrite material or rare earth alnico. magnetic separator the average magnetic induction of the canister surface is 100 - 600mt

    磁選機-豫重牌ct永磁筒式磁選機的磁系，採用優質鐵氧體材料或與稀土磁鋼復合而成，磁選機筒表平均磁感應強度為100 600mt 。
  2. Mains frequency coreless, induction iron - melting furnace and iron - holding furnace

    工頻無心感應熔鐵
  3. Smelting technology of high strength gray iron in induction furnace

    高強度灰鑄鐵感應電爐熔化技術
  4. Transformers and inductors for use in telecommunication and electronic equipment - main dimensions of coil formers - coil formers for laminated cores

    電信和電子設備變壓器和感應器.線圈架主要尺寸.疊層鐵芯線圈架
  5. The production is composed of debugging box, magnetic induction 485 communication controller, ? high strength magnet and buffer rubbers

    二產品組成:控制儀由調試盒磁感應485通訊控制儀高強度磁鐵和緩沖橡膠塊組成。
  6. Sodium hydroxide for industrial use - part 6 : determination of iron content - atomic absorption spectrometry and inductively coupled plasma atomic emission spectrophotometry

    工業用氫氧化鈉.第6部分:鐵含量的測定.原子吸收光譜測定法和感應耦合等離子體原子發射光譜測定法
  7. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。
  8. The effect of compound casting technology and compound modification on the properties of high speed steel roll collar was studied. the results showed that compound high speed steel roll collar with high and even hardness and good bond between outer and inner layers could be gained when the modified colbalt free high speed steel in outer layer and nodular iron inner layer in connection with appropriate rotational speed of centrifugal machine, pertinent pouring interval between two kinds of the melt and moderate pouring temperature as well as surface induction heat treatment were chosen. it is indicated in industrial use that the service life of compound roll collar is higher by 5 times than that of high chromium cast iron collar

    研究了離心復合鑄造工藝和復合變質處理對高速鋼輥環性能的影響，結果表明，選用變質高碳無鈷高速鋼作外層，用球鐵作內層，選擇合適的離心機轉速、兩種金屬熔液澆注間隔時間和澆注溫度，結合採用表面感應熱處理工藝，可獲得硬度高、均勻性好、內外層結合良好的高速鋼復合輥環，用於工業生產其使用壽命比高鉻鑄鐵輥環提高5倍以上。
  9. Induction hardening and tempering of iron and steel parts

    鋼鐵件的感應淬火回火處理
  10. Process of induction hardening and tempering of iron and steel

    鋼鐵的感應淬火和回火處理
  11. Metallographic examination of induction hardened pearlitic spheroidal graphite cast iron parts

    珠光體球墨鑄鐵零件感應淬火金相檢驗
  12. Abstract : this paper introduced the induction hardening experiment of components ? the gear - park and the drive support sprocket. give some advise on the pearlitic malleable iron ' s induction heat - treatment, and show coil design intending to meet the harden profilc according to the drawing

    文摘:本文介紹變速箱零件? ?駐車齒輪和鏈輪支架的感應淬火試驗工作，提出對可鍛鑄鐵感應淬火中值得注意的問題及針對這兩種零件的特殊硬化層要求而設計的感應器。
  13. Development of induction melting technology and its application in cast iron production

    感應熔煉技術的發展及其在鑄鐵生產中的應用
  14. In the past, the establishment of dynamic mathematical model neglected iron loss generally, but iron loss exists truly

    以往建立感應電機動態數學模型時，通常忽略了電機的鐵耗，但在電機中鐵耗是真實存在的。
  15. After establishing induction motor simulation model with iron loss, this paper has investigated effect of iron loss and proposed two schemes to compensate estimated error due to iron : one modified the structure of controller, the other modified the structure of observer, both schemes eliminated the detuning effect of iron

    對于鐵耗的影響，本文建立了考慮鐵耗的感應電機模擬模型后，研究了鐵耗造成的估計誤差，並利用兩種方法對誤差進行補償，一種是修改控制器結構的方法，另一種是修改觀測器結構的方法，最終都較好地消除鐵耗對速度估計的影響。
  16. Questions and answers about the basic theory of cast iron melting with induction furnace

    感應電爐熔煉鑄鐵基礎理論問答50例50
  17. Relationship between tensile strength and hardness of gray irons melted in medium - frequency induction furnace

    中頻感應電爐熔煉灰鑄鐵抗拉強度與硬度的關系
  18. We also analyzed the interaction among the distribution of the magnetic field around the magnet, the induced electromotive force in the coil and the vibration of the magnet

    對永久磁鐵在空間產生的磁場分佈、感應線圈中的感應電動勢與磁鐵相應振動等因素的相互關系進行了計算分析。
  19. The special slot is adopted in the rotor of the induction machine with compound cage rotor and there is two materials of casting aluminum and copper iron alloy in the slot

    復合籠條轉子感應電動機轉子採用特殊的槽形，且槽中含有鑄鋁和銅鐵合金兩種材料。
  20. Nickel, ferronickel and nickel alloys ; determination of sulfur content ; iodimetric titration method after induction furnace combustion iso 7527 : 1985 ; german version en 27527 : 1991

    鎳.鎳鐵.鎳合金.硫含量的測定.感應電爐燃燒后碘滴定
分享友人
分享到 Line

分享到臉書