鐵芯繞組 的英文怎麼說

中文拼音 [tiěxīnrào]
鐵芯繞組 英文
cored winding
  • : Ⅰ名詞1 (金屬元素) iron (fe) 2 (指刀槍等) arms; weapon 3 (姓氏) a surname Ⅱ形容詞1 (形容...
  • : 芯名詞1. (物體或器物的中心部分) core 2. (蛇的舌頭) snake's tongue
  • : 繞名詞1. [書面語] (彎曲) bend2. (姓氏) a surname
  • : Ⅰ名詞1 (由不多的人員組成的單位) group 2 (姓氏) a surname Ⅱ動詞(組織) organize; form Ⅲ量詞(...
  1. The current transformer is fully enclosed. the primary and secondary windings and iron core are insulated by epoxy resin. it has a good ability of antipollution and moisture proof

    本型電流互感器為全封閉結構,一、二次均澆注在環氧樹脂內,耐污染及潮濕。
  2. The current transformer is fully enclosed structure. the primary and secondary windings and iron core are insulated by epoxy resin. it has a good ability of antipollution and moisture proof

    本型電流互感器為全封閉結構,一、二次均澆注在環氧樹脂內,耐污染及潮濕。
  3. The current transformer is fully enclosed and busbar structure. the secondary windings and iron core are insulated by epoxy resin. it has a good ability of antipollution and moisture proof

    本型電流互感器為全封閉母線式結構,二次均澆注在環氧樹脂內,耐污染及潮濕。
  4. The calculation method using in factory has larger error and is n ' t used in high ignition point oil transformer. in this paper a calculation method, which has been verified by experiment results, is presented based on the fundamental theories and rule equation of heat transfer to calculate the temperature rise of average oil, top oil, coil, core and hot - point. a program has been compiled

    本課題立足於工程實際應用,根據傳熱學基本原理和經典試驗換熱準則式,通過對變壓器發熱冷卻原理進行分析和研究,提出了一套計算變壓器平均油溫升、頂油溫升、溫升、溫升和最熱點溫升的計算方法並編制了計算軟體,對影響變壓器溫升的因素進行了分析。
  5. In the models, the iron core nonlinearly of the traction transformer and the magnetic hysteresis effect without the b - h curve are considered. having tested by digital simulation, the winding parameter has not changed in the state of external fault or magnetizing inrush etc. but the winding parameter has obviously changed in state of inter fault or inter - turn fault. ( 3 ) the rules three phases converted to two phases of traction transformer in electric railways are developed in this paper

    ( 3 )利用牽引變壓器磁鏈平衡方程,建立了基於系統辨識理論的雙單相接線牽引變壓器、阻抗匹配平衡牽引變壓器及scott (斯科特)接線牽引變壓器的「灰箱」模型,該模型考慮了牽引變壓器非線性和磁滯效應,但又不直接反映在模型中,並且無需的b - h曲線數據。
  6. Lzct bushing type current transformer is suitable for is suitable for current measurement , metering and microcomputer protection of distribution equipments in 35kv and 10kv ac power system

    該型電流互感器的環型和二次採用優質環氧樹脂真空澆注在可阻燃的塑料殼體內,防潮濕,性能穩定,無需維護。
  7. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面電流作用於有限長上的模型,引用了氣隙磁場一維解,研究了單層磁場,奇數極半填槽雙層在採用整距和短距時磁場的分析、比較,簡單介紹了二維解; ( 2 )用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定電壓下的瞬態分析,得到了轉矩,位移,轉速隨時間變化曲線圖,利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較,採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證,由實驗測得了三相電流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  8. An a. c. voltage of 2000 volts is applied between the winding and ground to test the integrity of the insulation between the winding and core iron

    在線圈和地線上加上2000伏交流電以測試線圈之間的絕緣的整體性能。
  9. The voltage transformer is fully enclosed type the iron core is piled up of the cold roll silicon steel sheet. the iron core, primary and secondary windings are casting resin by advanced vacuum carting equipment. it has a good ability of antipollution and moisture proof. the secondary outlet is wrapped by outlet box with three exits with different directions. it, s convenient. it can prevent from stealing electricity

    本系列電壓互感器為全封閉式結構,採用優質冷軋硅鋼片制,並經嚴格的熱處理,與一次和二次一起以先進的真空澆注工藝用環氧樹脂澆注成型,互感器耐污穢,耐潮濕性能好二次出線端子有出線端子盒,端子盒有三個不同出線方向接線方便,並可實現防竊電措施。
  10. The current transformer is busbar type. the secondary windings and iron core are insulated by epoxy resin. the middle hole is used for busbar going through and mounting

    本型電流互感器為母線式。二次均澆注在聚脂樹脂內,中間窗孔供一次母線穿過及安裝用。
  11. The current transformer is busbar type. the secondary windings and iron core are enclosed in a plastic crust. the middle hole is used for busbar going through and mounting

    本型電流互感器為母線式。二次均封裝在阻燃塑料殼內,中間窗孔供一次母線穿過及安裝用。
  12. The zero sequence current transformer is full enclosed type. the secondary windings and iron core are insulated by epoxy resin. the middle hole is used for cable going through

    本型零序電流互感器為全封閉式。二次均澆注在聚脂樹脂內。中間窗孔供三相電纜穿過。
  13. Areas for future research include : measuring core distortion and losses, primary winding coupling ( for class b applications ), tests with feedback, and last, but not least, listening tests

    進一步的研究領域還可以包括:測量失真和損,初級耦合( b類應用) ,在有反饋的環境下測試,還有,聽感測試等等。
  14. The core loss is an important criterion of its performance. if the core loss is too large, it will be heated and the efficiency will be decreased when add the exciting current to the stator coils

    損是評判電機性能的一個重要指標,如果損太大,在定子中加勵磁電流后則會產生發熱和效率下降等不良現象。
  15. In this method, the similar inductance is used to extract the excitation current of ct, which, through some electronic circuits, turns into proper compensation current and is injected into the compensation winding. this current replaces the exciting current, so the error is reduced

    本文的實現方法是採用具有與電流互感器相似磁特性的製成的電感提取電流互感器的勵磁電流,將該勵磁電流經過一些電子電路的處理,產生補償電流,注入補償,從而減小電流互感器的誤差。
  16. This model not only reckons in the effects of the space distribution and the connection pattern of the windings, the position of the short circuit point and the space harmonics of the gap magnetic field, but also takes into account the pole geometry, slot effects, saturation and eddy current in the rotor

    該模型不僅能考慮的分佈與聯接方式、故障的空間位置、氣隙磁場的空間諧波,還能細致地考慮磁極形狀、的飽和和渦流等因素。
  17. The voltage transformer is fully enclosed structure. the primary and secondary windings and iron core are insulated by epoxy resin. it has a good ability of insulation and moisture proof

    本型電壓互感器為全封閉結構。一、二次均澆注在環氧樹脂內,絕緣性能優良,耐潮濕。
分享友人