鐵電元件 的英文怎麼說

中文拼音 [tiědiànyuánjiàn]
鐵電元件 英文
ferroelectric cell
  • : Ⅰ名詞1 (金屬元素) iron (fe) 2 (指刀槍等) arms; weapon 3 (姓氏) a surname Ⅱ形容詞1 (形容...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ量詞(用於個體事物) piece; article; item Ⅱ名詞1. (指可以一一計算的事物) 2. (文件) letter; correspondence; paper; document
  1. This product is used mainly in the leads of contacting net of high speed & quashing high speed railways, power cables, wire clips, mechanical fittings & accessories, electrical components & switch contacts

    產品主要應用於高速或準高速路接觸網導線、纜、導線夾、機械零配、及開關觸頭。
  2. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面流作用於有限長芯上的模型,引用了氣隙磁場一維解,研究了單層繞組磁場,奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較,簡單介紹了二維解; ( 2 )用有限軟體ansoft對大圓環直線感應機空載氣隙磁場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定壓下的瞬態分析,得到了轉矩,位移,轉速隨時間變化曲線圖,利用單極性霍爾測定轉速並與軟體計算結果進行了比較,採用等效路法計算了堵轉時的最大磁力並做實驗進行了驗證,由實驗測得了三相流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  3. A fault current limiter using permanent magnets has been designed and its performance simulated using a twodimensional time - stepping finite - element method incorporating a model of hysteresis for hard magnetic materials

    摘要按永久磁設計製成的故障流限制器,性能是靠含有硬磁材料的磁滯模型的2維時間分級有限方法獲得的。
  4. The voltage ir on core adopts semienclosed insert model. the current element adopts two - stage compensation to have wide load property. the whole plasticenclosed voltage coil. can withstand instantaneous large voltage impulse. the double jewels bearing or the magnetic - propelled bearing can ensure long lifetime. the bipolar aluminium nickel cobalt damping magnet steels have high coercivity, stable magmetic property. the electric function is in accordance with iec521 international standard

    芯採用半封閉插入式,採用二級補償使表計具有寬的負載特性。全塑封的壓線圈能稱說瞬時大壓沖擊。雙寶石軸承或磁推動軸承確保表計長壽命。
  5. Arrange and mount the flame - proof, explosion - proof elements in a cabinet welded by thin iron - board to form a explosion - proof cabinet, according to the system diagiram of users

    按照用戶提供的系統圖,將多種隔爆型防爆組裝在一個用薄板焊成的櫃內,形成一個防爆配櫃。
  6. Corrosion protection of metals - non - electrolytically applied zinc flake coatings on iron or steel components ; german version en 13858 : 2003

    金屬的防腐蝕.或鋼上的非解鍍鋅薄塗層
  7. Specification for drawn or rolled iron - chromium - aluminum alloys for electrical heating elements

    加熱的拉伸或輥軋鉻鋁合金規范
  8. It is necessary to study the mechanism of harmonics generation, make sure the content and distribute of harmonics current in order to alleviate their harm to traction power system ' s component, equipments of protect and measure as well as other customer ' s electronics equipments

    為了從根本上抑制力牽引負荷諧波帶來的影響,削弱諧波對牽引供系統主、保護測控裝置和其他用戶子設備的影響,有必要研究氣化道牽引諧波產生的機理,確定饋線流諧波的含量與分佈狀況。
  9. For the former has inductance winding and ferromagnetic material, its measurement range is restricted by saturation, so it has a narrower range of frequency. being an inductance, it has the possibility of resonance

    由於磁式壓互感器帶有感線圈和磁性材料,測量范圍受心磁飽和的限制,傳輸頻帶不夠寬;作為感性,存在磁諧振的可能,可靠性差。
  10. The purpose behind this thesis is to study the nonlinear electro - mechanical coupling perfo rmance, and to have relatively simple yet substantial constitutive relations of ferro - electrics, that can eventually provide guidance for material design, sensor or actuator structural analysis and life expectancy for ferro - electric structure and system

    本論文就是針對材料的非線性力耦合性能進行研究與分析,以期能對其本構關系作出簡單明確的描述,為的材料設計、結構分析及壽命估計等提供依據。
  11. Components for electronic equipment. magnetic components and ferrite materials. inductor of low self - inductance value. general requirements

    子設備.磁氧體材料.低自感量的感器.一般要求
  12. Standard specification for drawn or rolled iron - chromium - aluminum alloys for electrical heating elements

    用拉制或軋制鉻鋁合金標準規范
  13. Standard specification for drawn or rolled nickel - chromium and nickel - chromium - iron alloys for electrical heating elements

    加熱用拉制或軋制鎳鉻及鎳鉻合金標準規范
  14. Surface acoustic wave components, capacitors, emc filters, ntc thermistors, ptc thermistors, ferrites & accessories, inductors, microwave ceramics, arrestors, rf modules etc

    聲表面波容器,源濾波器,熱敏阻,壓敏阻,氧體磁心與附感器,微波陶瓷,氣管,射頻前羰模塊等等
  15. In this device, a small voltage would switch the semiconductor between nonmagnetic and ferromagnetic states

    在此中,稍微施加壓即可使半導體在非磁與磁兩種狀態之間切換。
  16. Its control precision must fit a certain extent standard. now, proportional hydraulic valve which developed from the general hydraulic valve is applied in ali kind of control scopes. it uses proportional electromagnetic iron to change the electron signal into mechanical signal instead of the manual adjuster or general switch electromagnetic iron

    現在工業生產中得到廣泛應用的比例液壓閥多是在普通液壓閥的基礎上,採用廉價而可靠的比例作為-機轉換,把氣控制信號轉為機械信號,以代替原閥內的手動調節器或普通開關式
  17. Production in casting iron, aluminum, electronic components etc

    ,鑄鋁,生產等。
  18. Researchers must answer several major questions before the second category of devices can take off as a viable industry : can we devise economic ways to combine ferromagnetic metals and semiconductors in integrated circuits

    為了讓第二類自旋工業起飛,成為實際的產業,研究人員必須先回答下列幾個主要問題:是否能想出較經濟的方法,在積體路中結合磁金屬和半導體?
  19. Yet, most existing high speed on / off valves use electromagnet as their electicity - mechanism conversion element, and good performant electromagnets have to be imported from other countries, in such situation, it is difficity to make excelent high speed electromagnet valve made in our country, even if we can make good performant high speed electromagnet valve in our country, it still has the shortcoming of not high enough respond speed, too small placket and big volumeo in this thesis, a new high speed on / off valve is developed based on two types of existing valves, this new valve has higher respond speed, a little big placket and little volume o for the new valve, several main task was made out as below : a ) several types of high speed on / off were first analyzed, then the basic performance of the actuator of the new valve was analyzed

    高速開關閥是20世紀80年代發展起來的一種具有響應速度快、抗污染能力強、與路配合好等特點的一個良好的動力放大。但是現有的高速開關閥基本上採用?機轉換,高性能的又基本為進口,難以滿足高性能高速開關閥國產化的要求,即使是高性能的式高速開關閥,仍存在著響應速度不夠大、開口過小、體積較大的缺點。本文在現有兩種高速開關閥的基礎上,設計了一種新穎的高速開關閥,在提高其動態性能的同時,增大了閥的開口,減小了閥的體積。
  20. Components for electronic equipment. magnetic cores and accessories. pots cores made of ferro - magnetic oxides for transformers. general requirements

    .磁芯和附.變壓器壺形芯磁迴路.一般要求
分享友人