長度允差 的英文怎麼說

中文拼音 [zhǎngdùyǔnchā]
長度允差 英文
length of tolerance
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 允 : Ⅰ動詞（允許） permit; allow; consent Ⅱ形容詞（公平; 適當） fair; just Ⅲ名詞（姓氏） a surname
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 長度 : length; longitude; size; extent; footage
  1. The size of baking the positive pole over a slow fire in advance allows the deviation to accord with the following regulations

    預焙陽極的尺寸允許偏差應符合以下規定： a長度，不大於0 . 1 %
  2. Measurement and characterization of surface texture is an important aspect of precision metrology. historically this has involved partitioning a profile into different wavelength regimes referred to as roughness, waviness and form followed by numerical quantization. parameters computed are then inspected for tolerance compliance to ensure a part performs its intended function. this approach is satisfactory when the specification has been carefully determined and the process is stable. however, when the manufacturing process is under development or when instability or modifications to the process invalidate specifications, there is a need to study surface finish parameters in relation to functional performance or process measures. in this context, the problem of surface texture classification and recognition are discussed. advanced techniques developed for this purpose along with applications are presented. also, the techniques discussed here will be useful across large bandwidth, from the characterization of nano scale to traditional micro scale surfaces

    表面結構的測量與特徵描述是精密計量技術的一個重要方面，傳統上包括將輪廓情況根據不同的波長范圍劃分為粗糙度、波紋度和形狀及后續的數字量化.按算得的參數檢查它是否為公差允許，以保證零件執行其指定的功能.當技術特性已經經過仔細確定，並且其過程穩定時，該方法是令人滿意的;但是，當製造過程正在進行中或過程的不穩定、過程變化使技術特性失效時，就需要研究和功能表現及過程評定相關的表面參數.討論了表面結構的分類與識別問題.同時闡述了為此目的而開發的先進技術及其應用.所研究的技術對從納米尺度到傳統的微米尺度的較大帶寬范圍內的表面特徵描述都是有效的
  3. To improve the controlling quality of this system, it permit user modify controlling parameters. user can input integral coefficient - kt. scaling coefficient can be adjusted by controlling system according to e and adjusting scale inputted by user

    為進一步改善控制系統的控製品質，允許用戶對控制參數進行修改， k _ i由用戶輸入， k _ u則根據用戶設定的調整步長和溫度偏差的情況由控制系統自調整。
分享友人
分享到 Line

分享到臉書