長管蒸發器 的英文怎麼說

中文拼音 [zhǎngguǎnzhēngfāqì]
長管蒸發器 英文
long tube evaporator
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  2. Ultraviolet absorption detector, photodiode array detector ( dad ), fluorescence detector, and electrochemical detector are optional detectors, response value of which is relative to not only quality of the object under test, but also structure of the compound ; refractive index detector and evaporative light - scattering detector are universal detector, responding to structure of all compounds ; evaporative light - scattering detector is quality - type detector, whose responding value only relates to quality of the object under test for compounds with similiar structures ; photodiode array detector ( dad ) can, at the same time, record absorption spectra of the object under test in a prescribed wave scope, consequently, it can be used in spectrum control and inspection of purity of chromatographic peaks of the object under test

    紫外、二極體陣列、熒光、電化學檢測器為選擇性檢測器，其響應值不僅與待測物的質量有關，還與化合物的結構有關；示差折光檢測器和蒸發光散射檢測器為通用型檢測器，對所有的化合物結構均有響應；蒸發光散射檢測器屬質量型檢測器，對結構類似的化合物，其響應值幾乎僅與待測物的質量有關；二極體陣列檢測器可以同時記錄待測物在規定波長范圍內的吸收光譜，故可用於待測物的光譜管制和色譜峰純度的檢查。
  3. The plate - tube evaporator, the single back - fin evaporator and the box condenser. after analyzing the physical model and setting up the mathematical model according to the two - phase flow of adiabatic capillary tubes, it also numerically simulates and analyzes the different effects of main parameters on the capillary tube length. based on the heat transfer analysis and counting of thermal insulation layer, the cad system accomplishes the parametric design and drawings of the refrigerator body

    該系統完成了對典型製冷裝置的換熱器部件，如板管式蒸發器、單脊翅片管式蒸發器、箱壁式冷凝器的參數化設計和繪圖；分析了絕熱型毛細管兩相流的物理模型，並建立數學模型，對絕熱型毛細管各主要參數對其長度的影響進行了數值模擬和計算分析；基於對電冰箱箱體絕熱層厚度的傳熱分析和計算，完成了整個箱體的參數化設計和繪圖工作。
  4. After the rationality of theoretical model has been testified, going along a series of numerical simulation and find the best ratio of evaporation segment and condensation segment by means of analyse the temperature variety of the electronic element surface on the effect of the radiator structure change. a series of strenthen step about heat transfer put forward theoretically by means of numerical analysis focuse on the thermal resistant of each tache of the heat transfer

    在證實了本理論模型是合理的基礎上，本文根據所建立的模型進行了一系列的數值模擬計算，分析了熱管型電子器件散熱器的結構尺寸（蒸發段和冷凝段的長度比、肋片的高度等）變化對發熱器件表面溫度的影響，得到了蒸發段和冷凝段的最佳長度比。
分享友人
分享到 Line

分享到臉書