門架式結構 的英文怎麼說

中文拼音 [ménjiàshìjiēgòu]
門架式結構 英文
portal framed structure
  • 門 : Ⅰ名詞1 （房屋、車船等的出入口 ） entrance; exit; door; gate 2 （形狀或作用像門的東西） switch; va...
  • 架 : Ⅰ名詞1 （用來放置東西或支撐物體等的東西; 架子） frame; rack; shelf; stand 2 （毆打; 爭吵） fight;...
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 架式 : rack
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. Based on large amounts of investigations on domestic dairy housings at present in beijing and aimed at dairy breeding technology - dairy building parameters - dairy structure, this paper made the portal frame of light - weight steel structure in cowshed to be the researched case and elaborated the theories and methods of structure optimization of portal frame of light - weight steel structure in cowshed. at last, some conclusions were drawn

    本文在大量調查研究的基礎上，針對目前我國牛舍發展落後的現狀，針對北京地區，從成乳牛舍內飼養工藝?成乳牛舍建築參數確定?成乳牛舍結構角度出發，選取輕型門式剛架牛舍作為研究對象，闡述了輕型門式剛架牛舍結構優化的理論和方法，並取得了一些結論。
  2. Technical specification for steel structure of lightweight buildings with gabled frames

    門式剛架輕型房屋鋼結構技術規程
  3. Technical specification for steel structure of light - weight buildings with gabled frames

    門式剛架輕型房屋鋼結構技術規程
  4. Finite - element analysis of end - plate connections in light weight steel structure with gabled frames

    門式剛架輕鋼結構端板連接節點承載性能的有限元分析
  5. The causes of crack on main boom structure of portal bucket stacker reclaimer

    門式斗輪堆取料機主臂架結構性開裂的原因分析
  6. The stability bearing capacity of purlin was calculated by formulas of two criterion and some design manual. some comments on the design of purlin are proposed after comparing the results, including the investigation result of this paper

    把試驗和理論計算結果與門式剛架規程、澳洲冷彎型鋼結構規范及設計手冊的計算結果進行了比較。
  7. Finically, the dynamic property of portal water injection sheet piles is analyzed in this paper, and the influence on dynamic property of pile length and distance between piles is discussed in detail

    此外，還探討了門架式水力插板樁的動力特性，以及樁長和樁間距對結構動力特性的影響。為進一步指導工程實踐提供了理論依據。
  8. Third, using the powerful fea software, ansys, it was studied how to construct the modules with high dynamic performances for nc machine tools on the foundation of the dod theory of us and bf sizes ; and the dod of the bed of nc machine tools and gantry columns were successfully accomplished, which prove that the dod theory of us and bf is feasible and efficient

    3 .研究了在大型有限元分析軟體ansys平臺上，利用基於元結構和框架尺寸優化的理論，如何構造出動態特性優良的數控機床模塊。通過基於元結構和框架尺寸優化的方法，成功地對數控機床床身和龍門式立柱進行動態優化設計，驗證了基於元結構和框架尺寸優化的機床構件動態設計及大件結構創成是可行性的，且具有一定的高效性。
  9. A great amount of post tensioned pre - stressing concrete single box beam for double track ( as called the box beam hereinafter ) has been used on the line. it is of infeasibility in adoption of the traditional practice of pre - fabrication in precast factory and erection of the box beam with the track laying machine for that this type of beam is characterized by new structure, complicated workmanship, large volume and difficulty in transportation. therefore, the key and hardest problem to tackle is that what processing should be adopted to precast the box beam on site and that what kind of machinery should be used to transport and erect the box beam

    由於該型梁具有結構新、工藝復雜、體積大、運輸困難，將常規鐵路的橋梁廠製造橋梁、經過鐵路運梁到工地、邊鋪邊架進行橋梁製造與架設的傳統施工模式應用到該線是行不通的，必須在現場預制橋梁、並採用專門的運架梁設備進行橋梁架設，因此箱梁的製造、架設施工成為該線施工技術攻關的重點和難點。
  10. Design and discussion for wind resistant pillar with light - weight steel structure

    門式剛架輕鋼結構抗風柱的設計
  11. In this paper, ansys, the software on finite element analysis, is made use of processing the static and modal analysis on the preliminary models and its " modified ones. by analyzing the results, we can conclude that the stresses on the components of the modified models are tended to equilibration and the location of the branches " brace can also influence stresses and translations on the branches. in addition, the values of the intrinsic frequencies on modified models " are larger than the ones on preliminary models, but the ranges of the frequencies on both models are almost same

    傳統的弧形閘門的支臂結構基本上都是三角架式的，這主要是因為按平面體系進行計算的傳統設計方法忽略了結構的整體性及弧形閘門的空間結構特點，設計得比較保守，而實際上，將其改為a型結構也存在可行性，本文是利用有限元分析軟體? ? ansys對原模型及修改模型分別進行靜態和固有頻率的計算，通過分析比較其結果可知，支臂改為a型后會使閘門的整體受力趨于均勻，即原模型受力大的部件其應力變小，而原模型受力小的部件其應力會變大；而且a型支臂的支桿在不同的放置位置對支臂的應力和位移變化也有一定的影響。
  12. The corrosion resistant plate penstock is in the frame of obvious - stem, which mainly consists of lifting device, frame, gate plate, seal, wedge block compressing set, rod and rod joint, rod guide tube, install accessory and etc

    不銹鋼閘門為明桿式結構，主要由啟閉裝置、閘框、閘板、密封件、楔塊壓緊裝置、門桿和桿接頭、桿導架、安裝附件等組成。
  13. Stress which three portal frames of dairy housing bore under different conditions was analyzed and relations between different post distance, roof gradient and structure internal force capability and steel dosage were obtained. at the same time, the structural section was optimized with float stress exponent method to lower steel dosage

    通過程序，對牛舍三種門式剛架結構在不同工況下進行了應力分析，分析了不同柱距、屋面坡度與結構受力及結構用鋼量的關系，並用準則法中的浮動應力指數法對優選出的結構進行了截面優化，達到了降低結構用鋼量的目標。
  14. Lightweight steel portal frame and its optimum web height

    輕型門式剛架結構及其最優腹板高度的研究
  15. Through over - all stability analysis, the influence of height - span ratio, rafter slope to the stability and the effective factors of gable portal frames are also presented in this paper

    通過對門式剛架的整體穩定分析，研究了剛架的高跨比、斜梁坡度對結構的穩定和計算長度系數的影響。
  16. The domestic and abroad research about retaining structure with double - row piles is summarized, and its disadvantages are shown in this paper. two - dimensional nonlinear plane - strain fern analysis, which emphasizes the pile - soil interaction, is developed for portal water injection sheet piles with the software ansys

    本文在總結國內外對雙排樁支護結構的研究現狀的基礎之上，結合通用有限元軟體ansys ，對門架式水力插板樁進行了二維非線性平面應變有限元分析，就其中的關鍵問題? ?樁與土的共同作用進行了研究。
  17. And use some theories about marketing channel construction and management, containing relationship marketing theory, supply chain theory, channel authority transfer theory, stimulating theory and game theory, analyze the macroscopic and microcosmic change of the whole medicine industry, and find out the opportunities in the market and challenges confronted with. through analyzing the macro and micro environment of the whole medicine industry, studying the development of medicine industry marketing channel - model and the feature of update model, relating with the experience of the same company ' s channel construction, the author study the xiamen meacon co. with realizing its marketing channel actuality, using swot analyse way, analyze its features and problems

    本論文採用實證研究法、深度訪談法、定性與定量相結合的方法，運用營銷渠道構建及管理的相關理論，包括關系營銷理論、供應鏈理論、激勵理論、渠道權力轉移理論以及博弈論等理論，通過分析整個醫藥行業的宏觀和微觀環境變化，研究醫藥市場營銷渠道模式演變過程和現有模式的特點，並結合相同類型企業渠道建設的經驗，針對廈門美康制藥公司的營銷渠道的現狀，分析其特點以及存在的弊端，並根據消費品營銷渠道一般模型，提出了其營銷渠道框架的重構方案，即美康公司四級營銷渠道的構建方案。
  18. Because of its many advantages, the tapered portal frame is getting more and more application. ( ( technology code of light steel structure of portal frame ) ) ( cecs 102 : 2002 ), our country enacted, does n ' t define conditions that tapered portal frame needs anti - earthquak - e design. but mentions in illustration of rules : when earthquake fortification intensity is 7 degree, the portal frame does n ' t need anti - earthquake checking generally ; but for 8 degree and above, horizontal just with lengthways frames both need anti - earthquake checking

    楔形變截面門式剛架山于其諸多的優點得到越來越廣泛的應用，我國頒布的協會標準《門式剛架輕型房屋鋼結構技術規程》 （ cecs102 2002 ）中沒有對變截面門式剛架需要進行抗震設計的情況進行具體規定，但在後面的條文說明中提到： 「當抗震設防烈度為7度時，一般不需做抗震驗算；當為8度及以上時，橫向剛架和縱向框架均需做抗震驗算。 」
  19. Railway fixed equipment. post brackets and portal structures for signalling in aluminium alloy

    鐵路固定設備.鋁合金信號用柱式支架和門架式結構
  20. The author designed the state diagram which based on the event driven which is suit for e - government affairs architecture which is cited from state diagram and the finite state machine theory. thus, the limitation of the present modeling methods which is unable to describe complex operation process can be gotten over. the uniflow ' s organization architecture adopts new matrix organization architecture and combined with the static department tree structure and the dynamic workgroup pattern

    在uniflow工作流管理系統的集成設計中，作者從狀態圖及有限狀態機理論中引申設計出了適合於電子政務架構基礎的基於事件驅動的狀態圖（ statediagram ）模型，克服現有的建模方法不能描述復雜業務過程處理的缺陷； uniflow的組織架構採用新型的矩陣制組織結構，將政務部門的靜態部門樹型結構和動態工作組模式相結合，使組織模型和過程模型靈活地集成起來，克服了傳統組織模型的單一、缺乏彈性等缺陷。
分享友人
分享到 Line

分享到臉書