門關閉運行 的英文怎麼說

中文拼音 [ménguānbìyùnháng]
門關閉運行 英文
closing travel
  • 門 : Ⅰ名詞1 （房屋、車船等的出入口 ） entrance; exit; door; gate 2 （形狀或作用像門的東西） switch; va...
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 閉 : Ⅰ動詞1. （關; 合） close; shut 2. （堵塞不通） block up; obstruct; stop up Ⅱ名詞（姓氏） a surname
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 行 : 行Ⅰ名詞1 （行列） line; row 2 （排行） seniority among brothers and sisters:你行幾? 我行三。where...
  • 運行 : move; be in motion; run; working; machine run; operation; corotation; propulsion （影片）
  1. By hydraulic modeling, this paper describes studies on the stability of a floating bulkhead operating in standing water and flowing water, and it ' s hydrodynamic stability characteristics that distinguish in standing water from in flowing water ; and direct measurements of the forces acting on the model floating body during floating and sinking is taken. as a result, the rotation stress curves are produced and analyzed ; to provide data for optimum operation schedule analyses of the sluice, the relationship of the impact forces acting on the side wall of the gate and the running speed is studied ; the reasons of unstably uplifting of the bulkhead are discussed and the method to solve the problem is also given in this paper

    本文結合常州新閘防洪控制工程水工模型試驗，系統分析了浮箱門在靜水和動水中的穩定性及其影響因素，指出靜水穩性和動水穩性的不同特點；試驗測定了浮箱門動水運行時的受力情況，給出並分析了定位過程轉動力的變化過程曲線；根據浮箱門啟閉速度與門體和岸墻之間撞擊力大小的關系，選擇合理的動力設備，為設計和工程實踐提供可靠依據；分析浮箱門難以穩定上浮的原因，並給出解決方案。
  2. Fire safety systems - operated safety systems - part 3 : automatic shutting sliding door

    消防系統.運行的安全系統.第3部分:自動關閉滑動門
  3. One side, groovy cast steel flap valves increase the head loss, waste electricity, the other side, when flap valves close, it always delay time because of it ' s low proportion. the bump load seriously threaten the safety of pumping station. through the research and development of flap valve used in the renovation practices in the design of air - filled floating flap valve in no. 1 chuhe pumping station of anhui province, the working characteristics and design methods of air - filled floating flap valve are studied in this paper

    但在拍門運行使用的同時，又時常暴露出一些缺陷，主要有：一是常規的鑄鐵或鑄鋼拍門加大了流道的水頭損失，特別是對于裝機容量較大的排澇泵站，其電能損耗相當可觀；二是拍門在自重下下落關閉時，往往由於過多考慮水頭損失導致浮重過小而延誤閉門時間，致使水體倒灌，再因緩沖裝置失靈導致閉門時門體對門框撞擊力很大，嚴重危及站身安全。
  4. The system will display the gate status, the thunder status and fire signal status. it allows the management clearly receiving running status of all facilities and subsystems in the central control room. the system graphically displays the alarm position, informs management by phonetic alarm and provides relevant disposal method for the management, which reduce cost of undesired contingency

    虹口稅務局基於節能和高效管理的考慮，在夜間，如果雙鑒探頭檢測到有人活動，則自動控制燈光開啟與關閉，同時聯動視頻進行錄像，並在界面上實時反映門的開關狀態防雷的狀態消防信號的狀態等，讓機房管理人員通過機房監控系統統能夠全面地了解機房內所有設備和子系統的運行狀態，並形象地顯示報警發生的位置，進行語音提示，同時提示相應報警的處理方法，將損失減少到最小。
  5. After valve is closed ( press control ) pump will stay at min speed before stopping. during delay stop, pump can be restart or stop immediately

    壓力控制中，在閥門關閉后泵不會立即停止，而是低速運行一段時間（可設定）后停止。根據需要，在此期間泵能再次啟動或立即停止。
  6. During unit startup and load is lower than 15 %, drum level is controlled by feedwater control valve, feedwater pump remains at minimum safety speed ; when load is between 15 % and 25 %, feedwater control valve is closing at fixed speed determined by function module, main motor - operated - valve is opened automatically, control mode of drum level is transferred to feedwater pump automatically and bumplessly ; when load is between 25 % and 50 %, control valve is closed fully, and main motor - operated - valve is open fully, drum level is controlled by one pump ; when load is more than 50 %, first pump is kept in operation, second pump is putting into operation automatically and

    在機組啟動、沖轉及機組並網至15 %負荷階段，給水泵維持在最低安全轉速下運行，汽包水位由低負荷給水調節閥自動控制; 15 %至25 %負荷階段，給水調節閥由函數模塊按照一定的速率自動平滑關閉，主給水電動門自動打開，汽包水位控制方式自動無擾切換為給水泵自動控制;負荷在25 %至50 %階段時，給水調節閥已完全關閉，主給水電動門已完全打開，水位控制已全由單臺給水泵承擔;負荷大於50 %后，在第一臺給水泵運行的同時，第二臺給水泵自動無擾投入。
  7. During selecting the spring return actuators, we can choose the more reasonable and more economical actuators, if we know the different torque needed by the valve working at opening, operating and closing

    在單作用執行器的選配過程中，如果能夠了解閥門在開啟、運行和關閉時的扭矩分配，我們就可以更加經濟、更加合理地選配執行器。
  8. During selecting the spring return actuators, we can choose the more reasonable and more economical actuators, if we konw the different torque needed by the valve working at opening, operating and closing

    在單作用執行器的選配過程中，如果能夠了解閥門在開啟、運行和關閉時的扭矩分配，我們就可以更加經濟、更加合理地選配執行器。
  9. The two phases will require the development of various security procedures for flight deck access and additional procedures in the event of emergency evacuation. subsequent to the meeting, cad issued a new flight operations notice which defined the latest faa regulations regarding the strengthening and locking of the cockpit door on all passenger aircraft flying into the usa, and further mandated the cad locked cockpit door procedures, including requiring the door locking mechanism to be secure to the extent that tempering with the lock or door handle from the passenger cabin does not unlock the door

    在會議過后，民航處發出新的飛行運作通告，就美國聯邦航空局關于所有飛往美國的客機駕駛艙門必須鎖好和令艙門更為鞏固的最新規則，作出闡釋；並且進一步就民航處規定關鎖駕駛艙艙門的程序發出指令，其中包括規定艙門的關閉裝置必須鞏固，即使有人從客艙內破壞駕駛艙的門鎖或把手，也不會令駕駛艙的門開啟。
  10. In the light of the operational characteristics of the system, the author argues that in the selection of materials, the control system and the design of dc motor for the whole - sealed platform screen door system, some key technologies shall be specially emphasized

    根據屏蔽門系統是帶載運營的特點，對其材質選擇、控制系統、執行電機等在設計、選擇及應用全封閉式屏蔽門系統時應著重關注的幾個關鍵技術作了闡述。
  11. This device is an important part in valve driving mechanism, it works according to the movement rule of cam to ensure the exhaust port open and close correctly, so that it can make the diesel engine running normally

    該推桿裝置是氣門驅動機構中的重要部件，它按照凸輪的運動規律進行工作，來完成進排氣門的正確開啟和關閉，從而使柴油機正常運行。
  12. The national fire protection agency ( nfpa ) guidelines require a confirming flow test to be conducted whenever a " main line " valve such as the shutoff valves or a backflow assembly have been operated

    美國國家防火協會（ nfpa ）指導原則要求對于主管線上運行的閥門，如關閉閥或防迴流閥總成，必須進行流量測試。
  13. Fire protection system installations : the national fire protection agency ( nfpa ) guidelines require a confirming flow test be conducted whenever a " main line " valve such as the shutoff valves or a backflow assembly have been operated

    消防系統安裝：美國國家消防局（ nfpa ）指導原則要求只要是「主管線」上已經運行的閥門，如關閉閥或防迴流閥總成，都需要進行流量確認檢測。
  14. To assure trouble - free check valve operation and shutoff operation, the valve should be periodically opened and closed to keep valve seat and valve disc guide stem free of build up of system contaminants

    為了確保無故障止回閥運行和關閉運行，閥門應該定期開啟和關閉，以保持閥座和閥瓣引導閥桿避免系統污染物淤積。
分享友人
分享到 Line

分享到臉書