閉觸點 的英文怎麼說

中文拼音 [chùdiǎn]
閉觸點 英文
closed contact
  • : Ⅰ動詞1. (關; 合) close; shut 2. (堵塞不通) block up; obstruct; stop up Ⅱ名詞(姓氏) a surname
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • : Ⅰ名詞1 (液體的小滴) drop (of liquid) 2 (細小的痕跡) spot; dot; speck 3 (漢字的筆畫「、」)...
  1. 0. 1in connectors for frequencies below 3 mhz. part 11 : edge socket connectors with closed ends and having a contactspacing of 2. 55 mm 0. 1 in mating either with board mounted connectors or printed wiring boards with edge board contacts

    頻率低於3mhz的連接器.第11部分:與印製電板裝連接器或板邊具有接的印製線路板相配用的帶封端的間距為2 . 55mm
  2. The signals can occur at anytime, but board transfer dose not occur until both contacts are closed

    信號隨時產生,但板的傳送必須在兩個合時方可產生。
  3. Under operation system of dos and windows, control software is developed respectively. the wave of voltage and current as the ac contactors switch - on and switch - off is displayed dynamically, which make the equipment not only used as general electric life test instrument, but can apply test date for contactor study

    在控制軟體方面,分別完成dos平臺和windows平臺控制軟體設計,實現了交流接合與斷開時刻電壓、電流波形動態顯示功能,使該裝置不僅能作為交流接器常規電壽命試驗裝置,還對接的研究提供必要的試驗數據。
  4. An isolated relay can have more than one pole and can have normally closed contacts as well as normally open contacts

    隔離繼電器可以有多個鍘刀,可以有常閉觸點,也可以有常開
  5. To consistently be vertical at contact, remember that the racquet face should be closed with the non - hitting hand at the low point of the backswing

    為了在接要一致性地保持垂直,記得非打擊的手在背後拉拍的低而網拍面應該是關的。
  6. Here ' s the key point : once the racquet face is closed at the low point of the backswing you are guaranteed vertical at contact as you swing forward and up

    在這里:一旦網拍面在背後拉拍的低是關的,則可保證當你向前和向上揮拍的時候,球拍在接是保持垂直的。
  7. In the switched - off condition or when the current supply is interrupted the three relay contacts on the output terminals 3 to 8 are open

    在開關關或供電電流中斷時,輸出終端3到8上的三個繼電打開。
  8. This lights up as long as the output contact is closed

    只要輸出合,這個燈就會亮著。
  9. Time of closing contact

    合時間
  10. Contact closure circuit

  11. Closing of contact

  12. In the switched - on condition, and below the respective switching threshold set, the output relays are in the working condition and the relay contacts are closed

    當開關打開但未達到各個開關設定的閾值時,輸出繼電器處于工作狀態,繼電合。
  13. We introduce in detail the circuit current and voltage when the relay is switch - on and switch - off, and make the software in dos and windows. the equipment can dynamic shows the wave of the current and voltage when the relay is switch - on and switch - off

    在檢測方面,分別完成了dos和windows平臺控制軟體設計,實現了繼電器合與打開時的電壓、電流波形的動態顯示功能。
  14. Detail specification for multi - contact edge socket electrical connectors - single or double sided, closed ended, replaceable contacts, through - board solder or wire wrap terminations - full assessment level

    邊緣插座電氣連接器詳細規范.單面或雙面端可替換穿板焊接或線繞終端.全面評估級
  15. It is composed of magnetic pulse sensor and control components, and is a built - in part inside distributor. it detects engine cranking position signal and cylinder signal via sensor, followed by treatment by control unit, thus controlling the on off of the current of control ignition coil to achieve the purpose of ignition. it has a function of auto closing regulation

    該型產品是為微車無火系統而研發的,它由磁脈沖傳感器和控制組件構成,內置於分電器內,通過傳感器檢測發動機曲軸位置信號汽缸信號,然後經控制組件處理,控制火線圈中電流的通斷,從而達到火目的,具有合角自動調整等功能。
  16. It is composed of magnetic pulse sensor and control components, and is a built - in part inside distributor. it detects engine cranking position signal and cylinder signal via sensor, followed by treatment by control unit, thus controlling the onoff of the current of control ignition coil to achieve the purpose of ignition. it has a function of auto closing regulation

    該型產品是為微車無火系統而研發的,它由磁脈沖傳感器和控制組件構成,內置於分電器內,通過傳感器檢測發動機曲軸位置信號、汽缸信號,然後經控制組件處理,控制火線圈中電流的通斷,從而達到火目的,具有合角自動調整等功能。
  17. Normally closed contacts

    正常
  18. Standard guide for measuring voltage drop on closed arcing contacts

    合跳火上電壓降的測量的標準規范
  19. Make contact springs

    彈簧
  20. Rectangular connectors for frequencies below 3 mhz ; part 3 : detail specification for a range of connectors with trapezoidal shaped metal sheels and round contacts ; removable crimp contact types with closed crimp barrels, rear insertion rear extraction

    頻率低於3mhz的矩形連接器.第3部分:梯形金屬殼和圓連接器范圍的詳細規范.帶式圓筒,后插入后抽取的可拆卸的壓扁型系列詳細規范
分享友人