閘架 的英文怎麼說

中文拼音 [zhájià]
閘架 英文
damper frame
  • 閘 : anchor gate
  • 架 : Ⅰ名詞1 （用來放置東西或支撐物體等的東西; 架子） frame; rack; shelf; stand 2 （毆打; 爭吵） fight;...
  1. Hilly countries can be canalized by the construction of locks, tunnels, and bridge aqueducts

    可以通過修築閘門、隧道及高架引水道在丘陵地區開通運河。
  2. The bank of shanghai of university of shanghai, the park of zhabei of construction bank railway hospital, the green sea new station on the ground of daning, the subway extends line ( in building ), inner loop, zhonghuan ( while planning ), overhead on the 1st, form the three - dimensional network of communication lines

    上海大學上海銀行，建行鐵道醫院閘北公園，大寧綠地上海新客站，地鐵1號延伸線（在建中） 、內環、中環（規劃中） 、高架，形成立體交通網。
  3. According to eigenvalue equation ( general formula ) of the energy method of the plane steel frame structure stability, and considering the restriction of the end of the column of the main steel frame and function of deflection curve gained from the differential balance equation general resolution, we get the equation for calculating the length coefficient of the main frame structure stability of the steel arch gate and the resolutions are also given

    根據平面剛架穩定性能量法特徵值方程（通式） ，考慮弧形鋼閘門主框架柱的柱端約束的特殊情況，求出撓曲線函數（試解函數）通解，得到弧形鋼閘門主框架柱穩定性計算長度系數方程。其中弧門主框架主橫梁式形框架的臨界荷載比較現行規范推薦的有限元法簡單方便、結果精確及物理概念明確等優點。
  4. All sizes are standardly equipped with awwa epoxy coated, ul / fm listed osy resilient seated gate valves, cfm ( cubic feet per minute ) or gpm ( gallon per minute ) meter and ball type test cocks

    作為標準配置，所有通徑美國自來水廠協會（ awwa ）認可的環氧樹脂塗敷， ul / fm認證外閥桿軛架彈性閥座閘閥， cfm （立方英尺/分鐘）或gpm （加侖/分鐘）水表和球型測試旋塞。
  5. The parallel seat gate assembly consists of two interchangeable spring loaded discs, a fully guided disc carrier, and retaining pins

    平行閥座閘閥由兩個可互換彈簧負載閥瓣，一個全導向閥瓣托架和扣環銷釘構成。
  6. In this paper, ansys, the software on finite element analysis, is made use of processing the static and modal analysis on the preliminary models and its " modified ones. by analyzing the results, we can conclude that the stresses on the components of the modified models are tended to equilibration and the location of the branches " brace can also influence stresses and translations on the branches. in addition, the values of the intrinsic frequencies on modified models " are larger than the ones on preliminary models, but the ranges of the frequencies on both models are almost same

    傳統的弧形閘門的支臂結構基本上都是三角架式的，這主要是因為按平面體系進行計算的傳統設計方法忽略了結構的整體性及弧形閘門的空間結構特點，設計得比較保守，而實際上，將其改為a型結構也存在可行性，本文是利用有限元分析軟體? ? ansys對原模型及修改模型分別進行靜態和固有頻率的計算，通過分析比較其結果可知，支臂改為a型后會使閘門的整體受力趨于均勻，即原模型受力大的部件其應力變小，而原模型受力小的部件其應力會變大；而且a型支臂的支桿在不同的放置位置對支臂的應力和位移變化也有一定的影響。
  7. The corrosion resistant plate penstock is in the frame of obvious - stem, which mainly consists of lifting device, frame, gate plate, seal, wedge block compressing set, rod and rod joint, rod guide tube, install accessory and etc

    不銹鋼閘門為明桿式結構，主要由啟閉裝置、閘框、閘板、密封件、楔塊壓緊裝置、門桿和桿接頭、桿導架、安裝附件等組成。
  8. Tag location for gate and globe valves is typically on the valve yoke or body / bonnet flange

    閘閥和截止閥的標簽位置通常在閥門軛架或閥體/閥蓋法蘭上。
  9. 4. choosing the reasonable deflection curve function. according to the energy method and the constrained condition of column end of the steel arch gate, the article presents a practical calculating formula for the stability of the main frame structure of the steel arch gate

    選擇合理的撓曲線函數（試解函數） ，根據能量法及弧門柱端約束條件，提出弧形鋼閘門主框架（平面鋼框架）穩定性計算的實用解析計算公式，並根據影響弧門主框架穩定性的因素對該公式進行修正。
  10. Automatic circuit reclosers and fault interrupters for alternating current systems, requirements for overhead, pad - mounted, dry vault, and submersible

    交流系統用架空座墊安裝式乾燥地下室型和浸沒式自動電路重合閘和故障斷路器的要求
  11. Requirements for overhead, pad - mounted, dry vault, and submersible automatic circuit reclosers and fault interrupters for alternating current systems up to 38 kv

    38kv及以下交流系統用架空底座安裝型乾燥地下室型和浸沒式電路自動重合閘和故障斷路器的要求
  12. Cavity area treatment in structural block of chamber 2 of tgp north lane shiplock

    三峽船閘北線二閘室結構塊架空部位的處理
  13. The enterprise deyang sunlight electric co., ltd. has special knowledge within the ranges roasting, thyristor and vacuum coating as well as sputtering

    公司專業從事晶閘管可控硅整流器、烤架以及真空鍍膜和濺射業務。
  14. With the support of the study above, this dissertation shows us the second - order analysis method of the elastic - plastic stability of steel arch gate

    在此研究的基礎上給出弧形鋼閘門主框架彈塑性穩定性實用二階分析方法。
  15. In order to solve those problems, this article adopts the energy method to analyze the stability of the major frame of steel arch gate to make up the weakness in the current standards and found the calculating models of the stability of the whole major frame of the steel arch gate. it also presents the general formula for calculating the eigenvalue and the precise equation of the calculating the length coefficient of the steel arch gate frame by using the energy method and choosing the proper experiment function

    本文主要採用能量法對弧形鋼閘門主框架線彈性穩定性進行分析與研究，建立單柱概化弧形鋼閘門主框架整體穩定的計算模型，並通過選擇合適試解函數，應用能量法給出特徵值方程及弧門框架穩定性計算長度系數精確解的公式，提出一個基於該模型方便工程設計的實用計算公式。
分享友人
分享到 Line

分享到臉書