閥杠 的英文怎麼說
中文拼音 [fágāng]
閥杠
英文
valve buckle-
You can not add assistant lever to the hand wheel. clockwise turn of hand wheel means the closing of valve, otherwise it means opening
操作時手輪順時針旋轉為閥關,反之為開,不得在手輪上再增加輔助杠桿。Note : on pump discharge, the preferred check valves are an in - line spring loaded, swing design with lever and weight or lever and spring
注意:在泵的排泄口處,首選的止回閥是管內彈簧負載,旋啟式,配置杠桿和重量或杠桿和彈簧。In order to overcome such slow response to flow retardation, the disc may be supplied with a levermounted or with spring loaded
為了克服對于流量減速的遲緩反應,這種閥瓣可能要配置杠桿或彈簧負載來幫助止回閥的啟閉。In reassembly of lever handle, align the index plate so that the number one ( 1 ), indicating the full closed * position, is at right angles to the bore of the valve
在組裝杠桿手柄時,對準刻度板,使其指示全閉位置的數字1位於閥門閥腔上的準確位置。Standing clear of the outlet ( discharged water may be hot ), slowly lift and release the lever handle on the temperature and pressure relief valve to allow the valve to operate freely and return to its closed position
經常清洗出口(排泄水可能是熱的) ,慢慢提起並釋放降溫減壓安全閥上的杠桿手柄,使得閥門能夠靈活工作並恢復到關閉位置。Lever and weight loaded safety valve
杠桿式安全閥Since the compensation valve cannot open unless it is mechanically actuated by the flat diaphragm via a lever, it ensures that the flat diaphragm and the hose diaphragm cannot be over - stretched
除非通過杠桿受平隔膜的機械作用,補償閥門是打不開的,這就保證了平隔膜和軟管隔膜不會被過分地拉伸。But there are some defaults in conventional balance values, such as low - frequency vibration, excessive high controlling - pressure, disadvantage in stability and safety, complicated construct etc, the key matters are that the valves neither work solely nor run synchronously in two cylinders
但傳統的平衡閥存在著不少缺點,如低頻振動、控制壓力偏高、工作平穩性和安全性較差、結構較復雜等,關鍵問題是在雙杠變幅等迴路中,既不能單獨應用,又不能實現雙缸同步運行。Lever reducing valve
杠桿式減壓閥分享友人