閥的調節機構 的英文怎麼說

中文拼音 [fádediàojiéjīgòu]
閥的調節機構 英文
innervalve assembly
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 機 : machineengine
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  • 機構 : 1 [機械工程] （機械的內部構造或一個單元） mechanism 2 （機關; 團體） organ; organization; institu...
  1. In this study, the load charateristics of submergible centrifugal pump and the influence of various regulating methods on energy dissipation are analyzed. the loading capacity of the submergible motor in variable speed drive control process is analyzed. the papers simple discribe the basic structure of the variable speed drive system in electric submergible pump > principle of pwm inverter and the basic structure of igbt

    在研究中，對潛油離心泵負載性能以及閘閥調節和調速調節對能耗的影響進行了分析；對潛油電動機在變頻調速的負載進行了分析；對潛油電泵變頻調速系統的基本結構、 pwm逆變器原理以及igbt的基本結構進行了簡單介紹。
  2. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  3. Enforcement agencies to promote the implementation of devices installed, it compressed air - driven, export thrust ; regulation valves are part of the implementation of devices to regulate direct contact with the media, regulatory medium flow

    執行機構是執行器的推動裝置，它以壓縮空氣為動力，輸出推力；調節閥是執行器的調節部分，直接與介質接觸，調節介質的流量。
  4. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  5. Based on advanced technology, this thesis bring forward the optimal scheme and set down general system - drawings and flow charts. using step7 - micro software, we achieve the auto - control aim in drinking water treatment. in practice, the complexity and non - linaerity exit in the system of water treatment, so we apply fuzzy control in water treatment and design a kind of controller which structure can be altered according to the using - rate of ozone and the variety of water quality

    實際飲用水處理系統由於存在復雜性、非線性、時變性，本文根據臭氧生物活性炭水處理工藝存在復雜性、非線性、時變性等特點，將模糊控制應用在水處理這一不確定的非線性時變系統，針對不同水溫下臭氧利用率及水質的變化，設計一種基於系統過程狀態的變結構的模糊控制器，以單片機作為主要控制硬體，按查表方式設計軟體，對進水閥門開度進行在線控制，調節臭氧氣體與進水的比例（臭氧流量及濃度不變） ，達到氣水比最優化。
  6. Due to the component of natural gas is very complex in different zone of our country, the product has taked on special design, it set up moore component factor of thirteen kinds, which offer user to select and setup, so as to satisfy measurement for contains various component natural gas, at the same time established many take - pressure way in order to suit to different measure device, and have automatic calculate and display super - compression factor function

    A q型操作器輸出svout ： 010ma 420ma 05v 15v信號，可直接驅動執行機構變頻器或再由伺服放大器去驅動電動調節閥門或由電氣轉換器和閥門定位器去驅動氣動薄膜閥。操作器處于自動工作狀態時，其信號輸入svin和操作輸出信號相當於是直通的。以實現dcs系統或調節器對執行機構的自動控制。
  7. Ideal for applications where the valve is not readily accessible, these actuators provide a labor - saving alternative to manual flow control regulation

    特別適用於不容易操作閥門的環境，這些執行機構能夠替代人工流體控制調節，節省人工成本。
  8. This paper discusses operation of dense phase pneumatic conveyor with automatic pressure control valve, and structure and operation of the automatic pressure control valve

    摘要通過分析密相自動調節式氣力輸送的原理，探討了自動調節閥的結構和工作機理。
  9. Nibco series 100, quality, line of electric actuators are designed for quarter - turn applications ? ball, butterfly and plug valves ; dampers ; vents and similar uses

    美國尼伯科100系列優質電動執行機構專為90o旋轉用途的球閥、蝶閥、旋塞閥、調節閥、通風口等類似應用設計製造。
  10. Nibco series 300, quality, line of electric actuators are designed for quarter - turn applications ? ball, butterfly and plug valves ; dampers ; vents and similar uses

    美國尼伯科300系列優質電動執行機構專為90o旋轉用途的球閥、蝶閥、旋塞閥、調節閥、通風口等類似應用設計製造。
  11. If by their ticket enforcement agencies use the power, control valves can be divided into pneumatic, electrical, fluid movement three, namely to compressed air to power sources pneumatic - valve to call for the engine electric control valves for the liquid medium ( such as oil ) pressure - driven electricity fluid moving control valves, and their functions and characteristics hours are electromagnetic valves, electronic style, smart, floor bus - control valves

    如果按其所配執行機構使用的動力，控制閥可以分為氣動、電動、液動三種，即以壓縮空氣為動力源的氣動調節閥，以電為動力源的電動控制閥，以液體介質（如油等）壓力為動力的電液動控制閥，另外，按其功能和特性分，還有電磁閥、電子式、智能式、現場總線型控制閥等。
分享友人
分享到 Line

分享到臉書