防火間距 的英文怎麼說

中文拼音 [fánghuǒjiān]
防火間距 英文
fire separation
  • : Ⅰ動詞(防鷥) provide against; defend against; guard against Ⅱ名詞1 (防守; 防禦) defence 2 (堤...
  • : fire
  • : 間Ⅰ名詞1 (中間) between; among 2 (一定的空間或時間里) with a definite time or space 3 (一間...
  • : Ⅰ名詞1 (距離) distance 2 (雄雞、雉等的腿的後面突出像腳趾的部分) spur (of a cock etc )Ⅱ動詞...
  • 防火 : fire prevention; fire safety; fireproof
  • 間距 : interval; separation; spacing; espacement; space; spacing; space length; range; unpack; step
  1. Of all kinds village does an enterprise to should be mixed in civilian curtilage in the center ; ( should stay between 2 ) building have appropriate fire prevention span and fire prevention channel ; ( 3 ) abuts type farming curtilage every between due firewall ; ( when 4 ) builds bridal chamber house, should raise architectural fireproof grade, use the blame combustion housing materials such as ferroconcrete, brick, tile ; when decorating, reduce use bamboo, wood to wait as far as possible can burn material

    各類村辦企業應混在民宅當中; ( 2 )房屋之應留有合適的防火間距通道; ( 3 )毗連式農宅每戶之應有墻; ( 4 )建造新房屋時,應提高建築的耐等級,採用鋼筋混凝土、磚、瓦等非燃燒建築材料;裝修時,盡量減少使用竹、木等可燃材料。
  2. Unfortunately, the engine room was incommodious, resulting in the air inlet muffler too close to the generator unit and making it inconvenient for maintenance staff to perform operation. in a spirit to avoid such an awkward situation and save the investment on muffling treatment, we suggest the following solution be adopted in future construction of engine rooms

    例如我們以前治理過的某個油機房其進風口外為通道,不能佔用,進風消音器只能安裝在油機房內,而油機房內部空設計又過小,就造成進風消音器發電機組過近,維護人員操作起來很不方便。
  3. With analyzing of the case study and based on simulating and analyzing quantitatively, this article, considering the goal of the performance - based fire - protection design is protecting occupants from being injured and keeping buildings from being damaged, thought that fire compartmentation of a large building of saling books can be divided according to their saling malls and fire compartmentation in the saling mall can be separated by the fire - proof screen. on the evacuation design, the quantity of safety exits around these buildings and the evacuation width should be increased if possible and the safety exit number, exit width and evacuation distance can be determined according to the simulating results on smoke layer temperature and height, concentration of co2 and co, occupants evacuation time and visibility. on the means of preventing and discharging smoke, the most proper measure should be determined according to their geometrical characteristics and the natural means of discharging smoke is feasible to the large building of saling books. based on analyzing of smoke

    通過對案例分析研究,本文認為大型書城建築性能化設計研究的最終目的是保證人員生命安全和保證建築結構安全,在模擬計算和量化分析的基礎上,大型書城的分區可以將中庭連通的書城區域劃分為一個區,在書城場地內可以採用卷簾進行分區劃分;在人員疏散設計中,應盡可能利用書城賣場的空設計較多的安全出口和增大疏散寬度,其安全出口數量、寬度和疏散離可以根據人員安全疏散時和煙氣溫度、沉降高度、 co2濃度、 co濃度、能見度模擬計算結果驗證確定;在排煙方式的選擇上,應當根據建築物的幾何特點選取最適宜的措施,就大型書城建築而言,採用自然排煙的方式是可行的。
  4. The reasonable house space between of villages and small towns in the east of sichuan is explored from such aspects as sunlight, fire control and neighbourhood, which can be used as references

    摘要文章對川東村鎮住宅的合理做了初步的探討,從日照標準、防火間距、相鄰關系方面分析了規劃區內外的住宅的大小,並給出了參考數值。
  5. The some fire control system is an advanced multi - senor short range air defense system, which integrated both x and ka bands searching and tracking radars, laser range finder, combined the control computer of subsystem with the master computer, and applied the technology of data fusion

    摘要某控系統集兩個頻率波段的搜索雷達、跟蹤雷達和電視跟蹤器、激光測機於一體,分系統控制處理計算機與系統主計算機相結合,採用了數據融合技術,是一部多傳感器集成的現代化空系統,具有搜索性能好、反應時快、抗干擾能力強、自動化程度高、使用性能好等特點。
  6. Article 21 any unit or individual shall not damage or arbitrarily use, dismantle and stop using fire control facilities and devices, and shall not bury and occupy hydrant, occupy fire prevention space and block fire control passageway

    第二十一條任何單位、個人不得損壞或者擅自挪用、拆除、停用消設施、器材,不得埋壓、圈佔消栓,不得佔用消,不得堵塞消通道。
  7. These measures are as follows : shorten the primary wind intervals to improve thermal load of the burner ; reduce the size of hypothetical circle of contact to prevent the flame from splashing ; use nozzles with larger height / width ratio to increase the effusive rigidity, so as to increase the jet flow depth of secondary wind into the main jet flow ; use a higher primary wind velocity to increase its jet flow rigidity ; use a special flame holder structure of the primary nozzle, so as to improve

    這些技術措施主要有:縮小一次風以提高燃燒器區域熱負荷;縮小假想切圓焰刷墻;採用高寬比較大的二次風噴口以增加射流剛性,提高二次風射流進入主射流的深度;採用較高的一次風速來提高一次風射流剛性;一次風噴口採用特殊穩燃結構;提高下二次風的托粉能力。
分享友人