阻容網路模擬 的英文怎麼說

中文拼音 [zǔróngwǎnglùmónǐ]
阻容網路模擬 英文
resistance-capacitance network analog
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 網 : Ⅰ名詞1 （捕魚捉鳥的器具） net 2 （像網的東西） thing which looks like a net 3 （像網一樣的組織或...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 網路 : 1. [電學] network; electric network2. （網） meshwork; system; graph （指一維復形）; mesh
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. By compared with the simulation results and the experiment results, we come to the conclusions that : ( 1 ) circuit with assistant network can widen soft - switching extent in lagging arm, reduces duty - cycle loss on the secondary, diminishes switching dissipation of inverter spot - welding power source. ( 2 ) the range of resonant capacitor, the important factor to soft - switching process, not only affects zero - voltage turn - off of power switches, but also affects the range of zero - voltage turn - on of power switches. so resonant capacitors must be considered according to many aspects ; ( 3 ) it easily fulfils soft - switching condition in lagging arm as leakage inductance of power transformer increases, but bigger leakage inductance of power transformer increases opening dissipation of transformer and decreases efficiency of soft - switching inverter power source

    通過模擬結果與軟開關點焊逆變器試驗結果的對比分析，得到了如下主要結論：採用輔助網路可以完全拓寬全橋軟開關逆變器的滯后橋臂軟開關范圍，減小了次級占空比丟失，降低了逆變電阻點焊電源的開關損耗；諧振電容是影響軟開關工作狀態的重要因素，其大小不僅影響開關管的零電壓關斷，同時也影響開關管的零電壓開通范圍，因此，諧振電容應該綜合考慮；功率變壓器漏感越大，越容易滿足滯后橋臂的軟開關條件，但是大的漏感也使變壓器的通態損耗增加，降低了軟開關逆變器的效率。
  2. Firstly, wall ’ s transfer matrix is deduced by laplace transformation based on 3r2c thermal network model. secondly, frequency response of transfer matrix is calculated. thirdly, we make the frequency response of transfer matrix of stimulation model equate the theoretical frequency response of wall transient heat conduction by applying appropriate identification algorithm, from which we can obtain every polynomial ’ s coefficient of model transfer function, then each parameter of resistance and capacitance is calculated by appropriate optimization algorithm

    首先，根據模擬熱流網路模型用拉普拉斯變換推出墻體的傳遞矩陣;然後，計算傳遞矩陣的頻率響應;最後，採用頻域回歸方法求出模型傳遞函數各次項的系數，進而通過一定的優化演算法確定模型的各個熱阻、熱容參數，使通過模型建立的多項式s -傳遞函數與墻體瞬時傳熱的理論超越s -傳遞函數完全等價。
  3. To analyze the factors of impacting load balancing of links, which is including the number of routes between source node and destination node, the number of routes through every link, the maximum flow between source node and destination node, the maximum flow through every link, the free bandwidth of every link and so on, we present the fast dynamic routing algorithm ( fdra ) and the critical link routing algorithm ( clra ). simulation results show presented algorithms in the paper are better than other algorithms in reject ratio of the traffic requests and performance of rerouting the traffic requests when a link is failure, especially in computing time cost

    通過分析影響網路的鏈路負載均衡的因素，比如源-目的節點間的最大流，通過每條鏈路的最大流，源-目的節點間的路徑數目，通過每條鏈路的路徑數目，以及鏈路的剩餘容量等，提出了快捷動態路由演算法fdra和關鍵性鏈路路由演算法clra ，通過模擬，與最小跳演算法（ mha ） 、最寬最短路徑（ wsp ）演算法、最小干擾路由演算法（ mira ）相比較，提出的兩種演算法在業務阻塞率、資源利用率以及重路由性能方面都有很好的效果。
  4. Whereafter, this thesis describes the relationship between the block probability and erlang capacity, and analyses the erlang capacity using two different methods. this thesis discusses the factors which effect the erlang capacity of system. the erlang capacitis are given under every conditions to direct cdma network planning

    隨後分析了阻塞概率和愛爾蘭容量的關系，並用兩種不同的方法（理論分析和蒙特卡羅模擬）對cdma系統的愛爾蘭容量進行了詳細地分析，討論了各參數對系統的愛爾蘭容量的影響，同時給出了各種情況下系統容量，用以指導cdma系統的網路規劃。
分享友人
分享到 Line

分享到臉書