阻尼值的英文怎麼說

中文拼音 [zhí]
阻尼值英文
damped quantity

  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : 名詞(尼姑) buddhist nun

※中文詞彙阻尼值在字典百科國語字典中的解釋。

  1. Different algorithms were compared in the numerical simulation and model experiment of concrete velocity inversion the results showed that, compared with the least - square solutions and the damped least - square solutions, the damped and natural weighted least - square solutions reflected the inner defections of the tested object more reliably and exactly due to the usage of correct priori information, which benefited the suppression of noises and made the iterations of inverse stable and convergent

    結果表明,相對于最小二乘法和最小二乘法,基於自然權的加權最小二乘演算法,由於利用了正確的先驗信息,不但使反演過程收斂,而且具有數穩定、抗噪能力強的優點,其成像結果能真實有效地反映對象內部缺陷,因此更適用於混凝土的超聲波速度反演。
  2. The centrosymmetric structural dynamical systems with damping were studied. the nearest triple matrix of the centrosymmetric with satisfying characteristic equations was found to a given triple matrix ( mass 、 stiffness and damping matrices ). finally, numerical examples were given

    3 .研究了中心對稱結構動力模型修正問題,對給定的三重矩陣(質量矩陣、剛度矩陣和矩陣) ,求滿足譜約束條件且具有中心對稱特性的「最接近」的三重矩陣,並給出數算例。
  3. Then, the influence of the damp, stiffness and position of viscous shearing damper on the effectiveness of viscous shearing damper is analyzed

    並利用程序從數上分析器的阻尼值、剛度器的位置對減振效果的影響。
  4. By using dma, dsc, afm, waxs etc, the maximum damping value, the temperature range of damping functional regions, ta, la as well as the morphology of the resulting damping materials were characterized

    以dma 、 dsc 、 afm 、 waxs等表徵測試了上述材料的最大阻尼值、功能區寬度、 ta 、 la及材料的微相結構。
  5. Then, the program based on complex eigenvalue method was employed to investigate the influence of three parameters on vibration - controlled of cables. final, in term of character of vsd which is strongly dependent on temperature, the method based on lowermost damper of first order vibration - controlled aim at design tiptop temperature and checked at minimum temperature is presented, in which available shear area of damper is calculated

    最後,在學習國內外研究成果的基礎上,根據粘性剪切型器的溫度依賴性強的特點,提出在設計最高溫度下,以滿足一階制振目標的阻尼值下限為標準設計器插板的有效剪切面積,最後在設計最低溫度下復核拉索各階制振目標是否滿足的設計方法。
分享友人