阻抗調配器 的英文怎麼說

中文拼音 [kàngdiàopèi]
阻抗調配器 英文
impedancetuner
  • : 動詞(阻擋; 阻礙) block; hinder; impede; obstruct
  • : Ⅰ動詞1 (抵抗; 抵擋) resist; combat; fight 2 (拒絕; 抗拒) refuse; defy 3 (對等) contend with...
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : Ⅰ動詞1 (兩性結合) join in marriage 2 (使動物交配) mate (animals) 3 (按適當的標準或比例加以...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 阻抗 : [電學] impedance
  • 配器 : orchestrate; arrange配器法 orchestration; 配器者 orchestrator; orchestrater; instrumentator
  1. The research for impedance matching algorithm of liquid stub tuner

    關于液調演算法的研究
  2. Water dielectric pulse power modulator has been widely applied because of its merits of high energy storage density, compactness, and capability to drive low impedance high power microwave sources. research for multi - pulse operation of high power spark gap switch with high current and comprehending its physical properties are the basis to study multi - pulse operation or repetitive operation of water dielectric pulse power modulator

    水介質脈沖功率調具有儲能密度高,結構緊湊、與低微波源較好匹的特點,因此得到廣泛的應用,但是受到高功率、大電流氣體開關的絕緣恢復的影響,水介質等低脈沖功率調的重復頻率運行或多脈沖運行受到較大的限制。
  3. After analyzing the noise in the high frequency carrier channel and computing the parameter of channel, we solved the kernel problems of coupling and matched impedance. separate designing the power, power amplification, port, transceiver and other circuits, we fitted together all circuits become the whole lonworks node circuit, and then triumphantly debugged it

    經過對高頻載波通道的干擾特性分析和線路參數的計算,解決了耦合和等核心問題,並對電源、功放、介面、收發等部分電路分別設計,最後形成了完整的lonworks節點硬體電路,並調試成功。
  4. The basic software consists of topology analysis, on - line load flow computation, state estimator, security analysis, dispatchers training simulator, short circuit current computation, and voltage / reactive power optimize, etc. the derived softwares consist of load control, capacitor optimizer configuration, transformer and feeder load distribution, impedance computation of generator, etc. network analysis software is powerful dispatch tool, though witch the current state of the power system can be realize, then improve the security and economic potential

    Dms網路分析的基本軟體有:網路結線分析、潮流計算、狀態估計、負荷預報、短路電流計算、電壓無功優化等。派生軟體有:負荷控制、電容優化置、變壓與饋線負荷分、電源計算等。網路分析軟體是有力的調度工具,通過它可以了解和掌握當前的運行狀態,從而挖掘安全和經濟方面的巨大潛力。
  5. Changing the depth of penetration of the three dowels results in the variation of the reflection coefficient ( s1 1 ) at the port 1. using matlab, we can calculate different equivalent impedance of port 1 which resulted from the variation of dowels depth. the purpose of my work strike up a relationship between the depth of dowels and equivalent impedance at port, thereby accomplish matching rapidly, simultaneously and stably

    在構建了自動系統的基礎上,本文提出了一種新的快速匹方法;此方法是將模擬軟體hfss和系統設計相結合,用hfss模擬系統中完成變換作用的銷釘匹,獲得銷釘插入波導深度變化時的埠等效特性,並將模擬得到的數據用matlab組織起來,分析銷釘插入波導的深度變化時埠等效特性的變化,來達到對調試變化規律的認識,快速的實現銷釘插入深度與反射系數間的統一。
  6. It has been shown by our calculations that conductor loss is greatly reduced under velocity matching with relatively thick coplanar waveguide electrodes and thick buffer layer, but the characteristic impedance can not match with that of the external circuit at the same time, and the modulation bandwidth is confined in this case

    然後,用一般的橢圓積分計算了普通共面波導型調的有效折射率、特徵和導體損耗系數。通過計算發現,採用厚電極和厚緩沖層結構,在實現速度匹的情況下,可以大大減小導體損耗,但是由於不能同時滿足匹調制帶寬受到限制。
  7. Presents the simple but highly reliable on - line detection of ultrasonic transducer clamping capacitance based on the impedance circuit model constructed through the impedance characteristics of the ultrasonic transducer under triple harmonics, and concludes from experimental results that this method can be used to effectively detect the variation of clamping capacitance while the transducer is operating, and the matching inductance can be dynamically regulated according to the results of detection, and dynamic matching can therefore be achieved in the real sense at the end of the transducer to improve the overall performance of the whole system

    為了解決大功率超聲應用的換能電端匹問題,分析了超聲波換能在諧振頻率三次諧波下的特性,給出了超聲換能三次諧波下的電路模型.並根據電路模型建立了對超聲換能的夾持電容實現在線檢測簡單、可靠性高的方法,實驗證明該方法有效的.該方法可以在換能工作過程中隨時檢測夾持電容的變化,根據檢測結果對匹電感進行動態調整,實現真正意義上的換能電端的動態匹,從而大大改善匹質量,提高系統的工作性能
分享友人