阻抗變壓器 的英文怎麼說

中文拼音 [zǔkàngbiànyāqì]
阻抗變壓器 英文
impecance tansformer
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 壓 : 壓構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 阻抗 : [電學] impedance
  1. The main operating transformer connected by a adscititious tandem on - load - tap - changing one is the important mode. about this question readers can get a correct and detailed answer from this paper

    通過基本定義和有關名牌值進行了計算和分析，認為在正負極限檔，外加串聯調壓變的阻抗值相對額定檔的偏差很小，所以可不必在意這種變壓器整體阻抗的偏差值。
  2. In this thesis, the author analyses the deficiency in detecting and controlling function of the computer detecting and controlling system utilized in present transforming station. the strategy of design of software on operation and direction of 5 00kv transformer station is presented. it points out that we can deduce the mathematic analytical formula using the current, voltage and power of two terminals of transmission line as input. on this basis, we do realtime calculation of 500kv transmission line ' s parameter. we can also deduce the linear analytical formula of three - winding autotransformer ' s resistence using its current, voltage and power as input. the corresponding software is programmed on this basis

    論文提出以輸電線路本端和對端電流、電壓、功率作為輸入量，導出了超高壓長線的波阻抗和傳播常數的數學解析式，在此基礎上進行了500kv輸電線路實時參數計算；提出以三繞組自耦變壓器的電流、電壓、功率為輸入量，導出了自耦變壓器繞組的電阻、電抗的線性解析式並進而對變壓器的實時參數進行計算；在此基礎上編制了相應的軟體。
  3. The electromagnetic unit is composed of medium - voltage transformer, compensation reactor, damper etc., the casing is filled with insulation oil

    電磁單元由中壓變壓器、補償電抗器、阻尼器等器件組成，箱體內充絕緣油。
  4. An ideal transformer, voltages are transformed in the direct ratio of turms, currents in the inverse ratio, and impedances in the direct ratio squared ; power and voltamperes are unchanged

    理想變壓器電壓與匝數成正比，電流與匝數成反比，阻抗與匝數平方成正比，功率不變。
  5. In the models, the iron core nonlinearly of the traction transformer and the magnetic hysteresis effect without the b - h curve are considered. having tested by digital simulation, the winding parameter has not changed in the state of external fault or magnetizing inrush etc. but the winding parameter has obviously changed in state of inter fault or inter - turn fault. ( 3 ) the rules three phases converted to two phases of traction transformer in electric railways are developed in this paper

    （ 3 ）利用牽引變壓器磁鏈平衡方程，建立了基於系統辨識理論的雙繞組單相接線牽引變壓器、阻抗匹配平衡牽引變壓器及scott （斯科特）接線牽引變壓器的「灰箱」模型，該模型考慮了牽引變壓器鐵芯非線性和磁滯效應，但又不直接反映在模型中，並且無需鐵芯的b - h曲線數據。
  6. Di - on electric one of the beijing hi - new - tech enterprise develop and manufacture lots of equipment like sf6 dewpoint meter dp100, cable fault location system cfl6000 and more. di - on electric supply the most advanced technology and equipment on such as gis surge arrestor on line monitoring, resistance measuring, ac dc metrology, thermal - temperature bridge, power transformer diagnostic and testing, cable diagnostic and fault location, sf6and oil moisture measuring, oil treatment and testing, optic fiber temperature monitoring, circuit breaker testing, relay testing and more

    迪揚電氣在gis和避雷器的帶電測試與故障診斷分析，電力電纜的故障定位與局放檢測，變壓器電抗器的各種測試診斷與溫度監測， sf6的水分測量與回收，絕緣油的測試分析與濾油處理，紅外測溫與光纖在線測溫，以及各種電阻測試與計量，溫度計量與電能計量等方面擁有世界一流的技術與成熟的儀器設備。
  7. 3. we do short circuit analysis upon multiple magnetic circuit transformers by use of steady non - linear analysis and get the leakage reactance respectively between high voltage and high voltage 、 high voltage and low voltage 、 two high voltage and low voltage 、 low voltage and high voltage and low voltage and two high voltage. what ’ s more, we do finite element analysis upon the temperature field of transformers and according to its distribution we get the wind speed to forced air cooling

    3 、採用穩態非線性分析法對多磁路變壓器進行短路阻抗計算，利用能量法計算出變壓器高壓與高壓、高壓與低壓、兩高壓與低壓、低壓與高壓以及低壓與兩高壓之間的漏感;對變壓器的溫度場進行有限元分析，確定溫度場分佈情況。
  8. In accordance with the driving characteristics of ac driving locomotive, the working status of its traction transformer is analysed. the questions that should be considered in the traction transformer design of ac driving locomotive are mentioned. these questions are the large short - circuit impedance of traction winding, higher harmonic current, over - excitation and dc magnetization caused by large variation of the network voltage, etc. some disposal methods are given

    針對交流傳動電力機車的傳動特點，對其中的牽引變壓器的工作狀態進行了分析，指出交流傳動電力機車用牽引變壓器設計時需考慮的牽引繞組的短路阻抗大、電流的高次諧波、網壓波動大可能引起的過勵磁以及直流磁化等問題，同時給出了相應的一些解決方法。
  9. The negative sequence current of impedance - matching balance transformer

    阻抗匹配平衡變壓器的負序電流
  10. Applying relative arithmetic to all kinds of faults and calculating off - line, we can master time - distance relation chart for all kinds of faults. computation indicates : when transmission lines occur faults, the data window of protection algorithm consisting of prefault and postfault data at the same time has important significance. the following methods are useful to achieve the inverse time characteristic : calculating impedance by using flourier in a full cycle, calculating work voltage by using fault component, calculating the torque created by a phase comparator or a magnitude comparator

    實際的計算表明：輸電線路發生故障后，用故障前後的數據同時充滿保護演算法的數據窗，對于快速切除近區故障具有很重要的意義；同時利用故障前後的數據，下述方法可以比較好地實現距離保護的反時限特性：直接用全周傅里葉演算法進行阻抗計算；採用工頻變化量阻抗繼電器進行工作電壓的計算；採用轉矩的思想進行轉矩的計算。
  11. Impedance - matching balanced traction transformers ( balanced transformers in this paper for short ) are step - down transformers, they transfer symmetrical three phase voltage in primary side to perpendicular two phase voltage in secondary side. they are different from any other transformers, so their short - circuit current analysis and short - circuit test method must be taken into special account

    阻抗匹配平衡牽引變壓器（本文中簡稱平衡變壓器）是一種將一次側三相對稱電壓變換為二次側二相垂直電壓的降壓變壓器，它不同於已有的任何一種變壓器，短路電流的分析計算和短路試驗必須予以重新研究。
  12. Traditionally, the resolving - transformer consists of former windings and vice windings. but the resulting output voltage will have aberrance owing to the existence of winding resistors and reactance leakage

    傳統上的旋轉變壓器常採用原副線圈來組成，由於線圈電阻和漏抗的存在，將使最終輸出電勢出現畸變。
  13. As a result, this paper gives a corresponding harmonic prevent me asure. finally, according to the asymmetrical characteristics of electrical traction loads, this paper studies the negative sequence currents under different loads and makes a piece of advice for reducing the negative sequence currents produced

    最後，還根據電力牽引負荷三相不對稱的特點，分析了阻抗匹配平衡變壓器在不同負荷條件下的負序電流，對如何減小電力牽引負荷的負序電流提出了一點建議。
  14. The basic software consists of topology analysis, on - line load flow computation, state estimator, security analysis, dispatchers training simulator, short circuit current computation, and voltage / reactive power optimize, etc. the derived softwares consist of load control, capacitor optimizer configuration, transformer and feeder load distribution, impedance computation of generator, etc. network analysis software is powerful dispatch tool, though witch the current state of the power system can be realize, then improve the security and economic potential

    Dms網路分析的基本軟體有：網路結線分析、潮流計算、狀態估計、負荷預報、短路電流計算、電壓無功優化等。派生軟體有：負荷控制、電容器優化配置、變壓器與饋線負荷分配、電源阻抗計算等。網路分析軟體是有力的調度工具，通過它可以了解和掌握當前的運行狀態，從而挖掘安全和經濟方面的巨大潛力。
  15. Two design plans and structure charactristic of high impedance transformer are introduced. its charactristics are compared. its structure is analyzed

    摘要介紹了高阻抗變壓器的結構特點及兩種結構的設計，並對其進行了性能比較和結構分析。
  16. The low voltage impulse method, frequency response analysis method and short - circuit reactance method, which can be used to measure and diagnose the deformation of power transformer winding, are introduced in the paper

    目前，監測變壓器繞組變形的方法主要有低壓脈沖分析法（ lvi ） ，頻率響應分析法（ fra ）和阻抗分析法。這些方法都需使變壓器退出運行，在變壓器離線情況下對變壓器繞組變形進行測量的。
  17. Then, based on the estimation algorithm decomposing the measurement of voltage scope and power scope, the problems of the location of transformation tap settings and the tide current estimation of zero - impedance branches in state estimation are solved ; and detection and identification of bad data in state estimation are deduced and stimulated, also a hybrid method of detection and identification is brought forward

    隨后，在基於分解電壓測量量和功率測量量的估計演算法的基礎上，對狀態估計中經常出現的變壓器抽頭位置問題和零阻抗支路潮流估計問題進行了分析和處理；對狀態估計的不良數據檢測與識別方法進行了推導和模擬，並提出了一種混合檢測方法。
  18. How to retrofit a off - load - tap - changing transformer into a on - load - tap - changing one

    外加串聯變調壓是主變壓器無載調壓改有載調壓的重要模式，正確認識其整體阻抗特性十分重要。
  19. Because the harmonics in tangyin substation are primarily from electric traction loads, this paper gives the structures of several main locomotive models and general harmonics they produce. the harmonics produced by electric locomotive have a characteristic that their range and phase are both dispersive. this paper also analyzes the impedance - matching balance transformer ' s structure and harmonics injected into the power system at its primary side, and sums up the characteristics of the harmonics from electric traction loads in the tangyin traction substation

    鑒于湯陰變電站的諧波主要來自電力牽引負荷，本文列舉了電力機車幾種主要車型的結構以及它們產生諧波的概況，得出了電力機車的各次諧波電流幅值和相角具有較大分散性的特點。針對湯陰牽引變電站的牽引變壓器，分析了阻抗匹配平衡變壓器的結構及其高壓側注入電網的諧波，推導了有關計算公式。通過理論分析並結合湯牽線的實測諧波數據，歸納了電力牽引負荷注入湯陰變電站的諧波的特點。
  20. The equilibrium current in 24 - pulse traction rectifier system is analyzed. the relation between critical load and resistance of traction rectifier transformer is discussed

    摘要分析了24脈波牽引整流系統中的均衡電流，討論了臨界負載與牽引整流變壓器阻抗參數的關系。
分享友人
分享到 Line

分享到臉書