阻流板 的英文怎麼說

中文拼音 [zǔliúbǎn]
阻流板 英文
spoiler
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度，撞擊塊高度、隔板位置等因素對氣相速度場、隔板兩側配風均勻性、顆粒濃度、濃淡分離比和燃燒器內阻力特性的影響。
  3. The cause that causes cerebral blood - vessel block basically has two kinds : it is a head thrombosis, it is the pathological changes as a result of cerebral blood - vessel itself, often make the film inside tubal antrum coarse because of sclerosis of appearance of cerebral artery congee, be in charge of antrum stricture, below certain condition, if blood pressure is reduced, blood stream is slow, blood sticks consistency heighten, the cruor factor such as plaque, condense inside blood - vessel agglomerate, form cerebral thrombus

    引起腦血管阻塞的原因主要有兩種：一是腦血栓形成，它是由於腦血管本身的病變，常因腦動脈粥樣硬化使管腔內膜粗糙，管腔狹窄，在某些條件下，如血壓降低，血流緩慢，血液粘稠度增高，血小板等凝血因子，在血管內凝聚成塊，形成腦血栓。
  4. The application of focal hepatioc vascular clamping by hilar plate dissection

    游離肝門板病肝血流阻斷在肝切除術中的應用
  5. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆乾燥工藝作為電機、變壓器等電氣設備的修理、製造中的重要環節之一，對乾燥過程的質量要求有一定的特殊性。該文從乾燥爐的結構分析入手，聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷，提出了熱風循環乾燥的概念，同時，選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡，運用數字pid控制技術，構成了一個較有特色的計算機控制系統。此外，該文還從保證乾燥品質量的角度，採用智能化交流模塊和自製采樣調壓電路的方法，提出了在線檢測產修品的絕緣電阻的方法和手段，以確保企業產品質量不斷提高。
  6. Another common method is the semaphore spoiler which the french have used on most of their anti-tank missiles.

    另一種通用的方法是阻流板擾流片，此方法在法國已經用在大部分反坦克導彈上。
  7. It has been common practice to design a baffle system to suppress sloshing.

    一般的作法是設計一個擋流板系統來阻止晃動。
  8. It has been a common practice to design a baffle system to suppress sloshing.

    一般的作法是設計一個擋流板系統來阻止晃動。
  9. The sea was very rough in the straits, full of eddies formed by the counter currents, and the chopping waves broke her course, whilst it became very difficult to stand on deck

    海峽中的水流非常急湍，到處都是逆流造成的漩渦。唐卡德爾號走得非常吃力，急促的海浪阻礙旨它的前進。如今在甲板上，很難再站穩腳步。
  10. We have done a serial of experiments to study the pam and anode grid with the aids of the measurement such as constant current charge / recharge, cyclic voltammetric measure ments, electric impedance spectrum and so on

    我們通過恆電流充放電、交流阻抗和循環伏安等實驗方法和測試手段對鉛酸電池的正極活性物質和板柵進行了一系列的研究。
  11. The endplate change dramatically reduces the vortices created by the front wheels, while the reduced width of the main profile cuts drag, helping to boost top speed at the fast san marino circuit

    側板的改變戲劇性地減少了輪胎所產生的渦流，而長度的縮短則可以降低阻力，幫助車輛在高速的聖馬利諾賽道提升極速。
  12. And experimental study on the heat transfer performance and pressure drop characteristic of the process of bubbling evaporative cooling are carried. as there are so little attention and studies on the process bubbling evaporative cooling about heat transfer in the world at present, this paper mainly deals with the effects of the different bare tower velocity, weir height, heat flux density and plate perforation geometries on the heat transfer coefficient and the pressure drop of the process of air flowing

    由於目前國內外對鼓泡蒸發冷卻過程在換熱方面的關注和研究較少，本文對不同空塔速度、不同堰高、不同熱流密度、多孔板的不同幾何尺寸對換熱系數及空氣流動過程阻力的影響進行了實驗研究及理論分析，總結了本實驗條件下換熱及阻力的實驗關聯式。
  13. Circuit board, integrated circuit, resistor, capacitor, chips, rectifier, led, diode, transistor, laser pick - up head and all kinds of electronics component

    電路板集成電路電阻電容主晶元整流管發光管二極體三極體鐳射光頭等各類電子零件
  14. According to the working modes of mr devices, combining the ohm ' s law of magnetic circuit and the design theory of non - steady magnetic circuit, magnetic structures of the automotive damper have been worked out. to emulate the performance of conventional shock absorber, two automotive mr dampers were designed and fabricated at chongqing university. an applied magnetic field increase the yield stress of mr fluids in flow annular passages, which alters the velocity profile of mr fluid in the passages and raise the pressure gradient between low cavity and high one at some given flow rates

    根據磁流變阻尼器工作模式，利用磁路中的歐姆定律和動態磁路設計原理，結合汽車懸架的技術要求和結構特點，提出了基於剪切模式和流動模式共同作用（混合工作模式）的汽車磁流變阻尼器設計原理，討論了阻尼器動態磁路設計中的若干技術問題；根據流體力學navier - stokes方程，分別利用newton流體特性和bingham流體特性，推導了基於平板模型和軸對稱模型的流變學方程，得出了阻尼器阻尼力的計算方法。
  15. This paper analyzed the mechanism that gas and liquid flow through the holes according to the fluid characteristics of the compound tray, and put forward that there are three states of liquid flowing, gas flowing and blocked for the holes because of the foam fluctuating on the tray while the compound tray operates

    本文根據復合塔板的氣液流動特點，分析了氣液穿孔流動的機理。根據前人的研究結果，提出復合塔板在操作時，由於泡沫層的波動，其篩孔存在通氣、通液和阻塞三種狀態。
  16. After constructing a 35 - nanometer - high channel between two silica plates and filling it with potassium chloride saltwater, they demonstrated that voltage applied across this nanofluidic transistor could switch potassium ion flow on and off

    他們在兩片硅板之間製作35奈米高的通道，注入氯化鉀溶液，示範在這個奈米流體晶體管上施加的電壓可開啟或阻斷鉀離子流。
  17. No endplate of reasonable size will prevent tip flow.

    沒有一個合適的端板尺寸將會阻止翼根繞流。
  18. Choke control panel

    阻流控制面板
  19. We studied its characteristics of enhanced heat transfer and flow resistance. this article analyzed the influence of some parameters on channel ' s enhanced heat transfer and flow resistance. such as re, the hole ' s diameter with no unit d / 1, level center distance with no unit sl / 1 and vertical center distance s2 / l etc. and compared the characteristics with the no hole baffle

    本文對通道內設置多種開孔折流板的換熱與流動阻力特性進行了實驗研究，討論分析了雷諾數re以及通道內設置開孔折流板的無量綱孔徑d w 、無量綱水平中心距s1 w和無量綱垂直中心距s2 w等多個參數對通道強化換熱與流動阻力特性的影響。
  20. This study got a lot of test data about the characteristic of enhanced heat transfer and flow resistance. it has reference value to the different kind of heat exchanger

    本文得到了大量的設置折流板通道的有關強化傳熱與流動阻力特性的實驗數據，對各類換熱器的強化研究具有一定的參考價值。
分享友人
分享到 Line

分享到臉書