陀螺儀漂移 的英文怎麼說

中文拼音 [tuóluóyíbiāoyí]
陀螺儀漂移 英文
gyro drift
  • 陀 : 名詞[書面語]1. （山岡） low hill; hillock2. （團狀物） lump
  • 螺 : 1. [動物學] （軟體動物） spiral shell; snail; conch 2. （螺旋形的指紋） whorl （in fingerprint）
  • 儀 : 名詞1 （人的外表） appearance; bearing 2 （禮節; 儀式） ceremony; rite 3 （禮物）present; gift 4 ...
  • 漂 : 漂動詞[方言] （事情、帳目等落空） fail; end in failure
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 陀螺儀 : gyroscope; gyro; top
  • 陀螺 : [物理學] top; whipping top; gyroscope; scopperil
  • 漂移 : 1 （漂流移動） be driven by the current; drift about2 [電子學] drift; shift; shifting; shunt runn...
  1. Dynamics model of mechancically dithered rlg

    陀螺儀隨機漂移建模
  2. Thirdly, in the environment of labview, several kinds of vis used for sensor signal test are designed, including wave generation, time domain measurement, filter disposal, frequency analysis, etc. after that, wavelet analysis in the application of one - dimensional signal de - noise is studied, threshold and translation invariance wavelet de - noise are realized, and wavelet de - noise vi for zero drift signal of the fiber optic gyro in fcs is designed using labview

    接著，在labview環境下開發了多種用於傳感器信號測試的虛擬儀器，具有波形發生、時域測量、濾波處理、頻譜分析等多種功能。隨后，研究了小波分析在一維信號消噪中的應用，實現了labview環境下的閾值法和平移不變量法小波消噪，並利用labview設計了飛控系統中光纖陀螺零漂信號的小波消噪儀。
  3. So the drift error of gyro is always the main source of error in the control and navigation system, the study of technology of measurement and compensation plays more and more important part in this field

    由於陀螺的漂移誤差是整個控制和導航系統的重要誤差源，所以，對陀螺儀漂移的測試及補償技術的研究具有越來越重要的意義。
  4. Then the gyro ’ s working theory and cause of drift are summarized

    並對液浮力反饋速率陀螺儀的工作原理和產生漂移的原因進行了概述。
  5. The effect of flexure support to the dtg precision is studied, and the drift equation of dtg is give

    研究了撓性支承特性對動力調諧速率陀螺儀精度的影響，推導了動力調諧速率陀螺儀的漂移公式。
  6. Application of wavelet ' s real - time filter in silicon micromachined gyroscope

    陀螺儀短時漂移特性實驗研究
  7. A brief introduction of gyro ’ s development process and conception of drift is presented on the paper

    本文首先簡要介紹了陀螺儀的發展歷程以及漂移的概念。
  8. Because of the limited rigidity in every direction of the flexure joint, the gyro drift must be existed. the simulation analysis for this drift is done. 5

    研究了由於撓性軸在所有方向上均存在有限剛度而引起的陀螺儀漂移，並進行了模擬分析； 5
  9. And the basically methods of gyro ’ s drift testing are introduced. the characteristics of force feedback method and servo turntable method are clarified. and the basic principle and method of feedback are emphasized

    然後介紹了陀螺儀漂移測試的主要方法，闡明了力反饋法和伺服轉臺法各自的特點，重點介紹了力反饋法的基本原理和方法。
  10. A better engineering method for measuring gyro drift in initial alignment of ins

    慣導對準過程中陀螺儀漂移測量研究
  11. The kinematic model of inertial measurement unit ( imu ) with mdrlg has been analyzed theoretically, the coning drift caused by dithering has been calculated, and some problems including the assembly of inertial sensors have been discussed

    本文對機抖激光陀螺捷聯慣導系統慣性測量單元的運動模型進行了理論分析，對抖動作用下的圓錐漂移進行了理論計算，對儀表安裝形式等問題進行了探討。
分享友人
分享到 Line

分享到臉書