附著量 的英文怎麼說

中文拼音 [bùzhāoliáng]
附著量 英文
adhesion amount
  • 附 : Ⅰ動詞1 （附帶） attach; add; enclose 2 （靠近） get close to; be near 3 （依從; 依附） agree to; ...
  • 著 : 著助詞1. （表示動作的持續） 2. （表示狀態的持續） 3. （用在動詞或表示程度的形容詞後面, 加強命令或囑咐的語氣） 4. （加在某些動詞後面, 使變成介詞）
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 附著 : adhere to; stick to ; adhering; sticking; insertio; capture; attachment; adherence; adhesion
  1. Using your thumb and palm ( use appro. 20 kgs strength ) to press it evenly on the product for about 60 sec. and wait until all glue stay on the wall surface

    以拇指及手掌平均用力（約20公斤的力量）施壓于產品背座60秒以上，務必使膠條完全附著于強面，再將產品上蓋掛上。
  2. The single function of biological reaction filler had been applied widely, which merely supplied the reaction place and the large amounts of microbe for biological reactor, though it had the large specific area and the surface character suitable for conglutinating microbe

    目前應用的生物反應填料作用單一，只是通過較大的比表面積和宜於生物附著的表面性質，為生物反應裝置提供較高的生物量及為生物反應提供場所，但不能為生物反應裝置創造良好的傳質擴散條件。
  3. The rising temperature in the cave, the lamp - light ' s toasting and the convictive air made the humidity of the whole or part of the cave descend, which made the speleothem sightseeing dry, cracked and weathering. the acid air from the outer and the highly dense co2 would cause acid erode action to the speleothem sightseeing with water vapor. the existence of lamp - light offered a good chance for the lightloving plant to grow up, thus a lot of bryophyte covered the speleothem sightseeing

    洞穴升溫、燈光的烘烤及空氣的對流致使洞穴濕度或局部濕度降低，使景觀產生乾裂、風化；氣流帶入的洞外酸性氣體及高濃度co _ 2在高濕的條件下，結合水汽對洞穴景觀產生酸侵蝕作用；燈光的存在為燈光植物生長提供了條件，使大量的苔蘚類植物生長于鐘乳類景觀的表面；洞外大氣粉塵的進入，給洞穴帶來了非常嚴重的破壞，粉塵在洞內高濕的環境下大量沉降，附著于鐘乳類景觀的表面，致使受污染面發黑，毫無光澤。
  4. Cylinder dryer is a dind of rotatin continuous drying equipment with internal heating conducting - style, certain thickness of materials film theres to the lower trough of materials under the rotating cylinder. heat is transferred to the internal wall of the cylinder through pipes and misfired ahain to the external wall and to materials film, to evaporate and damnify moisture in materials film so as to dry materials

    滾筒乾燥機是一種內加熱傳導型轉動連續乾燥設備。旋轉的滾筒通過其下部料槽，粘附著一厚度的料膜。熱量通過管道輔送至滾筒內壁，傳導到滾筒外壁，再傳導給料膜，使料膜中的濕度得到蒸發、脫濕、使含濕份的物料得到乾燥。
  5. Butyl acrylate was selected as the tender monomer in prepared bpua, and when the viscosity of middle multipolymer is 800 - 1000mpa. s, the last prepolymer had good capability. in the applied research, some influencing factors such as diluent, photoinitiator and photoinitiators that match to different pigments on the coating film were studied

    根據研究的結果，進行大量的配方實驗，研製了適合於皮革使用的uv上光油，經性能測試顯示：光澤度110 、耐折性3萬次、耐溶劑性200次、附著力合格，達到皮革上光油的使用要求。
  6. A particular description of the application of taguchi methods to antiradar coating is introduced through the system design and parameter design, the antriadar coating with excellent flexility and adhesion is developed through experiment

    通過系統設計及參數設計詳細地介紹了「田口方法」在吸波塗料中的應用，通過大量實驗研製了一種柔韌性好、附著力高的吸波塗料。
  7. The equipment adopts centrifugal sliding plow groove rotor and is the newest structure evaporator at present. it can form membrane under the condition of small flow. comparing with that of fixed space drag evaporator, its evaporation capacity can increase 40

    本設備採用離心式滑動溝槽轉子，是目前國外最新結構蒸發器，在流量很小的情況下也能形成薄膜，在簡體蒸發段內壁表面附著處理液中的淤積物可被活動刮板迅速移去，和固定間隙的刮板蒸發器相比，蒸發量可提高40 69 。
  8. Fabrication of the box beam is divided into such parts as reinforcement, formwork, concreting, prestressing, moving and storing of beam, pipe grouting under pressure, end sealing of the beam, water - proof layer on the bridge surface system, protective coating etc. the paper makes description of effective box beam construction technology and workmanship which can be adopted in other projects, such technologies as : manufacturing and fixing of reinforcement, steel reinforcement fixing baseplate, web plate and top plate respectively and lifting the steel skeleton into form, requirements of design and manufacturing and way of utilization for dismantling - erection type formwork and hydraulic formwork, optimization of concrete ratio, concrete pouring process of two ends of beam in priority over the middle, in sequence of first baseplate followed by web plate and top plate at last, concrete pouring in inclined section and in horizontal layer, concrete vibration mainly by external vibrator in assistance with internal vibrator, methods and regulation for steam curing of concrete, dual controls over stress and strain to ensure quality of prestressing workmanship, construction method of effective beam moving by heavy - weight special moving facility, some regulations and key notes about construction of grouting under pressure, beam ends sealing, water - proof layer on the bridge surface system, protective coating

    箱梁製造由鋼筋工程、模板工程、混凝土工程、預應力工程、移存梁工程、孔道壓漿工程、梁體封端工程、橋面防水層和保護層工程等施工環節組成。文中介紹的採用胎具製作和綁扎鋼筋，分底腹板和頂板分別綁扎並吊裝鋼筋骨架入模；拆裝式和液壓式兩種模板的設計、製作要求和使用方法；綜合考慮、優化混凝土配合比，混凝土灌注從兩端至中間、先底板、后腹板、再頂板的施工順序和斜向分段、腹板水平分層、附著式振搗為主、插入式搗固為輔的施工工藝，蒸汽養護的方法和規定；應力應變雙控制確保預應力施工質量的施工技術；採用重物移運器有效移梁的施工方法；壓漿、封端、橋面防水層和保護層施工的一些規定和注意事項等都是對箱梁製造行之有效的施工技術和施工方法，並可為以後類似施工作借鑒。
  9. Self adhesive tapes - measurement of static shear adhesion

    自膠粘帶.靜態剪切附著力的測量
  10. Conclusions : eccentric loading as applied in the present study showed inferior results to low - energy shock wave therapy as applied in patients with chronic recalcitrant tendinopathy of the insertion of the achilles tendon at four months of follow - up

    結論：本研究表明，四個月隨訪時，偏心負荷治療慢性頑固性跟腱附著點病變的結果不如低能量沖擊波治療。
  11. With the recently demonstrated effectiveness of eccentric loading and of repetitive low - energy shock wave therapy in patients with midsubstance achilles tendinopathy, the aim of the present randomized, controlled trial was to verify the effectiveness of both procedures exclusively in patients with insertional achilles tendinopathy

    最近有研究表明偏心負荷和重復低能量沖擊波療法對跟腱中部病變的病人有效，本隨機對照研究的目的是為了證實這兩種手段對跟腱附著點病變病人的療效。
  12. Fillers for interior use. measurement of adhesion - cohesion by a pull - off test

    室內用填充物.用撕裂試驗法對附著粘合力的測量
  13. Fillers for interior use. measurement of adhesion. cohesion by a conventional stripping process

    室內用填充物.用常規剝離程序對附著粘合力的測量
  14. By translating autocad files into maplnfo format files and using cis technique for linking information, building technicians visually acquire all kinds of quality control information, easily carried out the control in advance as well as under construction, greatly improve construction project quality, therefore avoid project quality defect as possible as they can

    將目前設計院常用的autocad圖形文件轉換到mapinfor平臺上，利用gis技術使質量控制信息附著在該施工圖上，施工人員可以方便地獲得各種質量控制信息，從而更好地實行了事前、事中控制，顯著提高施工項目質量，減少施工質量事故的發生。
  15. A monte carlo model was developed for simulating the adsorption behaviors of linear macromolecule chains on the solid - liquid interface. the simulations were performed on a simple cubic lattice, which was 50 50 50 sites in size. the concentration profiles of total segments, tails and loops in dilute solutions were used to analyze the influences of simulation parameters ( body concentration, interaction energy between segments, adsorption energy of interface, and macromolecule chain length ) on various adsorption configurations

    本文採用montecarlo方法構造了水溶性均聚鏈狀高分子固液界面吸附模型，在50 50 50簡單立方格子上模擬研究了高分子稀溶液中鏈節濃度、鏈尾和鏈環分佈，並結合真實高分子鏈的吸附行為，討論了模擬參數（鏈節間相互作用能、界面吸附能、體相濃度與鏈長）對各種吸附構型分佈、吸附量、表面覆蓋度和附著分數的影響。
  16. Waxes for sealant : this series product divides the wax for sealant tape and the wax for container primer, the former can provide the reasonable molecular weight distribution and the normal and isomerism proportion, obviously enhances the sealant tape the anti - oxidized ability ; latter has gentle viscosity - temperature curve, which can improve products ' adhesion, sagging property and bears the weathering ability

    密封膠用蠟系列：本系列產品分密封膠條用蠟和集裝箱底漆用蠟，前者能提供合理的分子量分佈和正異構比例，明顯提高膠條的抗氧化能力；後者具有平緩的粘溫曲線，改善目的產品的附著性、流掛性能和耐侯能力。
  17. And the mechanism was discussed. the form of the gold electrode was designed so as the reference capacitor cr can correct the non - linearity of the main variable capacitor cp. the characterization on absorbability and erosive - proof to ceramic of gold conductive sol was studied

    對金電極的形狀進行了設計，設置參照電容cr ，可較好地修正測量電容cp的非線性；研究了金導電漿料的配方、組成，通過調節漿料的成分，加入部分添加劑，提高了燒結后的電極對瓷體的附著力和耐腐蝕性。
  18. 1enviromental protection neutral oil cleaning technology : european general - purpose neutral oil treatment technology is used for cleaning before spray coating instead of using acid o alkali agents. this pollution - free cleaning technology ensures that no acid or alkali substances are left on plate surtace after cleaning, and further guarantees the quality of later spray coating for stronger powder adhesion without blistering or coming off

    1環保中性塗油清洗技術：在噴塗前的清洗技術，採用歐洲通用的中性塗油處理技術杜絕使用酸堿類試劑，對環境無污染，並保證清洗后的板面無酸堿殘留，保證后續噴塗質量，使粉末附著力更強，不易起泡不易脫落。
  19. In addition, it has been found that the number of attached spores on the surface of ionic hydrogels was affacted by the crosslinking density of gels, but the germination ratio of attached spores and growth of gametes have nothing to do with the crosslinking density of gels

    此外，離子型凝膠表面孢子的附著量受凝膠的交聯度影響，而孢子的萌發率以及配子體的生長發育均與凝膠的交聯度無關。
  20. The korea consumer protection board tested six items that are commonly handled by the public and ran tests for their bacteria content

    韓國消費者保護委員會檢驗了六項公眾經常觸摸的物品，並測試出這些物品的細菌附著量。
分享友人
分享到 Line

分享到臉書