限流調節器 的英文怎麼說

中文拼音 [xiànliúdiàojiéqì]
限流調節器 英文
current limiting regulator
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Adjustment is provided in the form of a needle-value or restrictor.

    流量調節採用針閥或限流器。
  2. The limit cycle oscillation is intermittent, so in the soft nonlinear regime the limit cycle oscillation can be avoided by slightly adjusting the current. detuning and length of the interaction region

    由於極限環振蕩是間斷出現的，所以在軟非線性區域，適當的調節電流、失諧量和相互作用區長度，可以避免器件工作在極限環振蕩態上。
  3. Two generating methods of compensation current are also proposed for the purpose of eliminating detuning or limiting harmonic voltage contents, in which the compensation current is the weighted superposition of filter harmonic currents or voltages and the regulating factor

    針對消除失諧或限制諧波電壓含量的不同控制目標，提出了諧波磁通補償電流的兩種生成方法，補償電流分別是濾波器電流或母線電壓中各次諧波分量與調節系數的加權合成。
  4. The study of the effect of material properties and dimensions and loading currents on liner buckling, using a capacitor bank as a driver, indicates that the mode number for buckling increases with the ratio of radius to thickness of a liner, and the yield strength to plastic hardening modulus, but keeps invariable with the increase of loading current, and that the magnitude of buckling increases with the loading current

    用電容器組脈沖發生器裝置作為驅動源，設計4種不同材料、不同尺寸的金屬套簡，通過調節電容器組的充電電壓得到不同的加載電流，研究材料及幾何參數、加載脈沖特性對套簡屈曲的影響；採用瞬態非線性有限元方法對實驗結果進行了數值模擬。
  5. With regard to the flow regulation of the best - effort traffic, the controllable traffic in high speed computer communication networks, the present paper proposes a novel control theoretic approach that designs a proportional - integrative ( pi ) controller based on multi - rate sampling for congestion controlling. based on the traffic model of a single node and on system stability criterion, it is shown that this pi controller can regulate the source rate on the basis of the knowledge of buffer occupancy of the destination node in such a manner that the congestion - controlled network is asymptotically stable without oscillation in terms of the buffer occupancy of the destionation node ; and the steady value of queue length is consistent with the specified threshold value

    本文從控制理論的角度出發，針對計算機高速網際網路中最大服務交通流即能控交通流的調節問題提出了一種基於多速率采樣的具有比例積分（ pi ）控制器結構的擁塞控制理論和方法，在單個節點的交通流的模型基礎上，運用控制理論中的系統穩定性分析方法，討論如何利用信終端節點緩沖佔有量的比例加積分的反饋形式來調節信源節點的能控交通流的輸入速率，從而使被控網路節點的緩沖佔有量趨于穩定;同時使被控網路節點的穩定隊列長度逼近指定的門限值。
  6. The unified power flow controller ( upfc ) is one of the most enterprising realizations of the idea of flexible ac transmission system ( facts ). having the ability of controlling most of the basic power system parameters, upfc can flexibly adjust the real and reactive power through the transmission line, damp the oscillation, and enhance the stability of power system and so on

    統一潮流控制器（ upfc ）是靈活交流輸電系統中最有代表性的成員，具備控制多種電力系統參數的能力，因而可以靈活地調節線路有功和無功功率、阻尼系統振蕩、增強電力系統的穩定性和提高輸電線路的傳輸極限。
  7. 4. through using the concept of logic balance, a high performance telecommunication switch network test chip is accomplished by using xilinx virtex 300e - 6 and the working clock frequency is up to 125mhz. this chip can give an exact test for the network delay time, throughput, network delay time dither, rate of errors and lost data

    4 ）結合邏輯平衡的思想，採用xilinxvirtex300e - 6器件，為一家著名的通訊技術有限公司設計了速度達125mhz的交換網測試晶元，能夠對交換網的吞吐率，網路延時，網路延時抖動，數據包錯誤率，包丟失率等進行嚴格的測試，並根據當前網路的流量大小自動調節網路負載。
  8. In order to enhance the rapid reaction performance and regulate the current of main circuit in real time, a current loop ' s controller is set up inside the speed loop, it takes the pi regulator for the current loop ' s controller, which can make the output limited

    為了能夠盡量的提高伺服控制系統的反應快速性，並且能夠為了實時的對主電路的電流進行檢測調節，系統在速度環的內部設置一個電流反饋環並且以帶輸出限幅的pi調節器作為電流環的控制器。
  9. Limited by time this paper focused on three areas : ( 1 ) basic dtc principal study and research ( 2 ) the design of speed regulator of dtc ( 3 ) a new kind of stator flux observer because the dtc system is a nonlinear system and we ca n ' t grasp the parameters completely, the classic speed regulators design method is not fit for dtc system

    由於時間有限，本文所進行的研究工作主要集中在三個方面： （ 1 ） dtc基本原理的學習與實現（ 2 ） dtc中轉速調節器的設計研究。 （ 3 ）新型定子磁鏈觀測器的研究。 dtc所具有的非線性和參數不可知的特性決定了直流調速系統的轉速調節器的設計方法不能完全適合於dtc系統。
  10. With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style

    控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。
  11. By studying the characteristics of the eddy displacement sensor, it adopts the control method which include using the fitting line of sensor ' s output characteristic curve in certain block as control characteristic curve, and stipulating door limit district and a certain of backward overshoot, the stabilization of welding torch is gained under the certain track precision

    摘要通過對渦流式位移傳感器的特性研究，採用以傳感器輸出特性曲線在一定區間內的擬合直線作為控制特性曲線、設定規定門限區和一定反向調節量的控制方法，得到了在保證一定的跟蹤精度條件下的焊槍穩定。
  12. Based on the analysis and comparison of the peak current - injection mode and average current mode control strategies, the method of designing average current control mode pi regulator is obtained. the digital simulation of the converter has been done with the help of matlab software. the good transient and stable character of the converter is attained while rated load

    在分析與比較峰值電流模式與平均值電流模式控制策略的基礎上，給出平均值電流模式pi調節器的設計方法，利用matlab軟體對變換器進行了數字模擬，證實了變換器在額定功率范圍內動、靜態特性良好；過載情況下變換器具有自動限流、保護主功率器件的特性。
  13. The temperature coefficients of voltage reference and current reference circuits are 18ppm / and 36. 2ppm / respectively. the combination of current - limited comparator and current - limited statemachine reduces the noises generated by transformer. the leading edge circuit could avoid ldmos premature shutdown

    論文著重介紹了該單片開關電源電路中部分子模塊:基準源電路、電流極限比較器電路、電流極限狀態機電路、前沿閉鎖電路和調節電路。
分享友人
分享到 Line

分享到臉書