隨機程序試驗 的英文怎麼說

中文拼音 [suíjīchéngxùshìyàn]
隨機程序試驗 英文
randomized program test
  • 隨 : Ⅰ動詞1 （跟; 跟隨） follow 2 （順從） comply with; adapt to 3 （任憑; 由著） let （sb do as he li...
  • 機 : machineengine
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 隨機 : random stochasticrandom
  • 程序 : 1 （進行次序） order; procedure; course; sequence; schedule; ground rule; routing process 2 [自動...
  • 試驗 : trial; experiment; test
  1. Basic environmental testing procedures. test methods. test fdc : random vibration wide band. reproductibility low

    基本環境試驗程序.試驗方法. fdc試驗.寬帶的隨機振動.可再現性低
  2. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - examinations and measurements - attenuation of random mated connectors

    光纖互連設備和無源元件.基本試驗和測量程序.檢驗和測量.隨機配合連接器的衰變
  3. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 3 - 34 : examinations and measurements - attenuation of random mated connectors

    纖維光學互連器件和無源器件基本試驗和測量程序第3 - 34部分：檢查和測量隨機配接連接器的衰減
  4. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 3 - 34 : examinations and measurements ; attenuation of random mated connectors

    纖維光學互連器件和無源元件.基本試驗和測量程序.第3 - 34部分:檢查和測量.隨機插合連接器的衰減
  5. According to the geological data which was gained by exploration investigation, establishing a geological model which can reflect rock mass characteristics ; with analyzing the internal and exterior factors synthetically, the deformation and possible failure mechanism and mode of the cut slopes was confirmed which combines with stereoic projection and other techniques ; the stabilities of the 14 high slopes are estimated synthetically by applicable design codes and guidelines. with the estimate result and some other analysis methods, the rock mass mechanical parameters of slope are identified ; as a results, 14 high slopes fall into 4 categories based on rockmass characteristics and discontinuities. the stability and deformation of some typical slopes was analyzed with distinct element method by udec ; the safety factor of some dangerous slopes are calculated by rigid limiting equilibrium method for comparison

    首先著重研究影響邊坡穩定性的內在因素，主要是通過地質勘探、測量、現場觀測等手段取得研究區地質體的基礎地質資料，建立起能夠反映地質體結構特徵的地質模型;隨后綜合分析潛在的內外部影響因素，並結合赤平投影對邊坡可能的失穩模式或破壞機製作出判斷;運用已有巖體質量分類方法對沿線14個高陡邊坡穩定性進行初步的評價，並結合試驗研究、經驗判斷、工程類比等手段確定了坡體的巖體力學參數;根據穩定性初步評價結果將研究區14個高陡邊坡按開挖方式分為4大類，並利用離散元程序udec對各類典型高陡邊坡進行了穩定性計算分析;對潛在危險邊坡利用剛體極限平衡法求出了不同工況下的安全系數。
  6. With the development of computer technology and modeling technology, the numerical control simulation technology has become a kind of effective method of foreseeing machining process performance, product quality and processing efficiency in the present production machining. it not only could inspect the rationality and correctness of nc program as a result it avoids the breakdown of nc equipment because of knife moving by error but also reduced the consumption and cost that test cutting brought before and shortened the development period of new product greatly

    在現代生產加工中，伴隨著計算機技術與建模技術的發展，數控模擬技術已成為能夠預測加工過程表現、產品質量及加工效率的一種有效方法，不但可以檢驗數控程序的正確性和合理性，避免由於機床走刀錯誤造成的數控設備損壞的危險，而且大大降低了以往採用工藝試切方法所帶來的高消耗和高成本，大大縮短了新產品的開發周期。
  7. By means of trigonometrical progression method and the mainline track spectrum, the sample function of the chinese mainline railway track random geometric irregularity is simulated. with the data obtained from track geometry inspection car on qinhuangdao - shenyang special line for passenger transport and arma time series model, the sample function of high - speed railway track random geometric irregularity are simulated. based on existing literature, the artificial bogie crawl waves at various different speeds are randomly simulated

    根據我國干線鐵路軌道譜，採用三角級數法模擬出干線鐵路和準高速鐵路軌道不平順的樣本函數；根據秦沈客運專線高速試驗段軌檢車資料，採用arma時間序列模型模擬了高速鐵路軌道不平順隨機樣本函數；在既有研究資料的基礎上模擬出各種速度客車構架人工蛇行波；用隨機變量描述道床橫向剛度，並進行了隨機模擬；將振動理論和穩定理論結合建立系統的分析模型和運動方程；根據monte ? carlo法編制了車輛?軌道耦合系統隨機振動分析程序，進行了無縫線路隨機動力響應分析，通過試驗對計算模型、計算方法進行了驗證。
  8. Automatic docking is one of the most important actions for msr robot ’ s self - reconfiguration and is one of the technologys about the robot researching, because it supports almost all practical advantages of such robot. in this thesis, automatic docking system and the module structure are first analyzed ; for searching the reason why the actual docking system run unsteadily, some validate and test thing are done, such as docking algorithm test, sensor unit test, drive unit test, and so on

    自動對接是模塊化自重構機器人完成自重構的一個基本步驟，也是這種機器人研究的關鍵技術之一，是模塊化自重構機器人具有實際應用價值的基礎。本文對自動對接系統結構進行了分析，為尋找實際對接系統工作不穩定的原因，做了一些驗證與調試方面的工作，包括自動對接演算法正確性與有效性的驗證，串口電路設計，編寫實時跟隨對接模塊運動的程序以及傳感器建模程序等。
  9. Basic environmental testing procedures. test methods. test fdb : random vibration wide band. reproducibility medium

    基本環境試驗程序.試驗方法. fdb試驗.寬帶的隨機振動.可再現性中等
  10. 1 ) realization of software packet embedded in m - es and md - is respectively to accomplish main function of mdlp, including assignment of tei ( temporary equipment identifier ), establishment of multiple frame operation, framing, flow control and error - free transmission of packets, is detailed. 2 ) a test model is established to evaluate the robustness and stability of mdlp and verify the validity of software packets. 3 ) according to the design of radio modem construction used in m - es, the modules of interface between data terminal equipment and radio modem are achieved to enable transmission of short message and continuous pseudo - random bit stream via rs232 uart

    本文首先概述了蜂窩數字分組數據網的結構和空中協議，詳細分析了移動數據鏈路協議，並在此基礎上，重點敘述了以下方面的工作： 1 ）設計並完成了分別應用於m - es和md - is端無線控制器的兩套程序實現數據鏈路層的主要功能，包括分配臨時設備號、建立鏈路、組幀和面向連接的服務保證分組正確無誤地傳輸，並進行適當的流控； 2 ）建立測試模型測試移動數據鏈路協議的可靠性和穩定性，證明了程序包的效用； 3 ）根據cdpd系統無線數據機的軟硬體總體設計方案，完成了介面模塊，實現了rs232異步串口通信，使用戶可以根據需要發送短消息或連續的偽隨機比特流； 4 ）在tms320c54x的軟體、硬體模擬平臺上，建立了cdpd試驗模型，實現了cdpd系統的mdlp基本功能。
  11. To test the randomness, we introduced the " a statistical test suite for random and pseudorandom number generators for cryptographic applications ", which was published by the nist ( national institute of standard and technology ) and as the criterion to test the candidates of aes

    在檢驗序列的隨機性方面，本文詳細討論了由nist提出的作為測試aes加密演算法的16中隨機性測試方法。對于其中的遊程測試，離散傅立葉變換測試和lempel - ziv壓縮測試，討論了其不恰當的地方。
分享友人
分享到 Line

分享到臉書