隨爐冷卻 的英文怎麼說
中文拼音 [suílúlěngquè]
隨爐冷卻
英文
furnace cooling-
The results show that it is an effective method for acquiring better electrical properties that the pressed bodies were sintered at 1150 in furnace with the temperature raised dilatorily, heat preserved for 2. 5 hours and furnace cooled to room temperature
研究結果表明，氧化鋅壓敏閥片的最佳燒成制度為：隨爐連續緩慢升溫至1150進行燒結，保溫2 . 5小時后，隨爐緩慢冷卻。The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine
用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。The curing of the magnets always in the vacuum circumstance. as far as the mixture cohesion is concerned, the optimized curing temperature and time are 120 and 120min
所用粘結劑合適的固化溫度是120 ，合適的固化時間是120min ，固化后磁體應該隨爐冷卻。Zn0. 6 ni0. 4 fe2o4 soft ferrite has been prepared by shs in his paper. the sem and xrd has been studied for zno. 6 ni0. 4 fe2o4 annealed in different temperature and time
通過對比退火產物的xrd和sem圖譜，確定了最佳的退火工藝： 300 h的升溫速率到1100 ，保溫2h ，隨爐冷卻到室溫。分享友人