離心式制動機 的英文怎麼說
中文拼音 [líxīnshìzhìdòngjī]
離心式制動機
英文
centrifugal brake- 離 : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
- 式 : 名詞1 (樣式) type; style 2 (格式) pattern; form 3 (儀式; 典禮) ceremony; ritual 4 (自然科...
- 制 : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
- 機 : machineengine
- 離心 : 1 (不是一條心) be at odds with the community or the leadership2 (離開中心) centrifugal; eccen...
-
The core part does n ' t use the protocol of tcp / ip, and it transfers especial format data defined by myself by a serial port / parallel port or a usb port with driver software researched by myself and keeps isolated state which is equal to physical disconnect when one side exchanges data with the part of the core by the circuit locking each other
這個核心部分不使用tcp / ip協議,用自主獨立研發的驅動程序軟體,通過串並口或者usb口將自定義格式的數據進行傳輸。在數據傳輸過程中,通過電路互鎖機制使內網或外網任何一方與隔離交換器進行數據交換時,另一方保持相當於物理隔離的隔離狀態。The development of the dynamic test - bed for fluid flow machine, one of the sub - projects within the " national 211 project ", can carry out the tests on the static and dynamic properties of not only both the hydraulic turbine units and water pump flits with the types of axial - flow, mixed - flow and inclined - flow, but also the centrifugal pump unit ; of which the testing process is automatically controlled by a pc with higher testing precision
摘要流體機械動態試驗臺是國家「 211工程」建設項目之一,可以進行軸流式(貫流式) 、混流式、斜流式水輪機組的靜特性、動特性試驗,也可以進行軸流式(貫流式) 、混流式、斜流式、離心式水泵機組的靜特性、動特性試驗,試驗過程由微型計算機自動控制,試驗精度高,操作方便、靈活。This paper introduces control area network ( can ) into intelligent reclose controller, so it is very easy to construct multi - master system and multi - machine backup system. in feeder automation, after the intelligent reclose controller isolate faults, controller use the can to report fault message to dispatch center, helping determining the reason and fault point
將can總線引入重合控制器,不僅實現控制單元的多主式通訊系統及多主機備份,而且往饋線自動化系統中,在重合控制器無通道自動隔離故障的基礎上,實現故障信息的匯總,便於調度中心及時的掌握故障原因及查找故障點。Automatic mechanical transmission as so called amt, accomplishes automatic gearshift based on manual fixed - shaft and dry clutch, which takes ecu as kernel, and then uses hydraulic system to control clutch, gearshift and manipulates throttle by adopting electronics technique and automatic gearshift theory
電控機械式自動變速器( amt )是在傳統固定軸式變速器和乾式離合器的基礎上,採用電子技術和自動變速理論,以電子控制單元為核心,通過液壓執行系統控制離合器的分離與接合,選換檔操作以及發動機節氣門的調節來實現起步、換檔的自動操縱。Microprocessor ' s i / 0 is the seria1 interface chip, making the system simplified and reliability increased. the state and seat of throttle. clutch and brake, the rotates speed of engine, the direction of motive force etc are the paraneters
自動控制系統硬體電路以at89c52為核心,沒有外擴ram 、 rom , i / o介面晶元採用串列工作方式,接線簡單,可靠性高;設置油門、離合器、剎車狀態和位置,發動機轉速,動力流向等傳感器獲取運行參數。分享友人