電力分佈 的英文怎麼說

中文拼音 [diànlìfēnbù]
電力分佈 英文
electric power distribution
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 電力 : [電學] power; electric power電力變阻器 power rheostat; 電力捕魚 electrofishing; 電力潮流 directio...
  1. For confirming the results, a full - size model ( dj / dj = 0. 6, t / t = 1. 5 ) was analyzed by means of strain gauge test. the reliability of finite element analysis was proved because the results basically accorded with that of the test. secondly, in this paper, in order to carry out a fair assessment of the reinforcement design on spherical shell with transnormal nozzle, a comparison of reinforcement method was done between jb4732 - 1995 steel pressure vessels ? esign by analysis appendix a4 and hg20582 - 1998 specification for stress calculation of steel chemical vessels

    為了驗證ansys分析結果的可靠性，對其中一組參數下（開孔率0 . 6 、厚度比1 . 5 ）的模型容器，採用電測法進行了應力測試，並將得到的實驗結果與有限元結果進行了比較，二者在應力分佈狀況和大小上均基本吻合，證明此種結構運用ansys進行分析，其結果是完全可靠的。
  2. The aim of this study is to explore the concentrating effects of both the electric current density and the stresses in the plate due to the existence of the elliptic hole

    其研究重心是定量計算橢圓孔對電流密度以及板內應力分佈在橢圓長軸端點處的集中效應。
  3. A comparison of the electric field distribution in a cable termination with several different stress control tubes is presented

    摘要利用時域有限元方法分析了含不同應力控制管時的電纜終端電場分佈。
  4. A comparison of the electric field distribution in cable terminations with several different stress control tubes is investigated under impulse voltage

    利用暫態有限元方法分析了含不同應力控制管時的電纜終端沖擊電壓下的電場分佈。
  5. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in improving electric field distributions in cable terminations

    分析結果表明，採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時，電纜終端的電場分佈最為均勻。
  6. The result reveals that the stress control tube comprising a composite structure of the nonlinear resistive and capacitive material shows the best performance in uniforming the electric field distributions in cable terminations under impulse voltage

    分析結果表明，在沖擊電壓下電纜終端採用由電容性和非線性電阻性材料復合絕緣結構的應力控制管時，電場分佈最為均勻。
  7. And we consider sufficiently all kinds of factors, such as conductance of tube, leak and deflate of system, pump speed, ionization and re - ionization of high - energy ion taking place in the process of transmission. furthermore, we take two ways to discuss pressure distribution of cell

    在系統軸線上壓力分佈分析過程中，綜合考慮了管道的流導、系統的漏氣和放氣、泵的抽速、高能離子在管道內漂移過程中發生的電離和再電離等因素的影響。
  8. But due to the difficulties of the theoretical calculation and the limitation of the technique of image display, only some two - dimensional graphs of electromagnetic field of a planar set of point charges or symmetrically and uniformly charged bodies, which ignores the boundary effect, are introduced in the present electromagnetics teaching materials, which brings much incovenience for the acquaintance of the electrostatic field

    然而，由於受理論計算和圖象顯示技術等因素的限制，目前的電磁學教材中，通常只能給出平面分佈的點電荷系或具有較強對稱性、忽略邊界效應的帶電體的電力線和等勢線的二維平面圖，這給靜電場分佈的感性認識帶來了一定不便。
  9. Analytical solutions of thermal stress distribution in plastic encapsulated integrated circuit packages

    塑料封裝集成電路結構熱應力分佈的解析解
  10. 4. combined with the design of the three gorges prestressed concrete penstock with steel liner in the three gorges power. station, the consistence among the results of theory calculating, the analysis of plane finite element and three dimensional finite element is proved, the concrete stress distributions of the prestressed concrete penstock are analyzed with different steel liner thicknesses, different crack resistances, different concrete thicknesses and different initial radial gaps between steel liner and concrete. the feasibility of the design method of prestressed concrete penstock with steel liner is proved

    結合三峽電站鋼襯預應力混凝土聯合受力壓力管道的設計方案選擇及論證分析，對比分析了鋼襯預應力混凝土壓力管道理論計算、平面有限元和管壩整體三維有限元分析結果的一致性，確定了管道結構在不同鋼襯厚度、不同抗裂度要求、不同外包混凝土厚度及不同鋼襯與管壁混凝土間初始徑向間隙等因素影響下的內力分佈規律，驗證了鋼襯預應力混凝土壓力管道的設計方法。
  11. In this paper, with the available computer method, theauthors have obtained the stress distribution acrosssections of reinforced concrete composite beams under two stages ofloading, and show that the stress redistribution under two stages ofloading results in a reduction of stress discrepancy in thetensile steel and of strain discrepency in the compressed concrete between thecomposite beam and the corresponding casting beam

    本文運用成熟的電算模擬方法，計算得到二階段受力鋼筋砼疊合梁在不同受力階段的截面應力分佈規律及鋼筋的應力變化規律，分析得到二階段受力時鋼筋砼疊合梁1的受拉鋼筋應力超前、受壓區砼應變遲后逐漸緩解的實質為截面應力重分佈的結果
  12. D finite element local analysis is done for hv porcelain post insulator by abaqus finite element software. the stress distribution of one - piece structure under dead weight, erection deviation, temperature change, wind load and short - circuited load is analyzed, which provides the scientific basis for security assessment of post insulator

    以高壓瓷瓶支柱絕緣子為研究對象，採用abaqus有限元軟體進行三維有限元局部分析，分析了整體結構在自重、安裝偏差、溫度變化、風載以及短路電流載荷作用下的應力分佈，為支柱絕緣子的安全性評定提供了科學的依據。
  13. In this thesis, scanning force microscopy ( sfm ) was used to study the nanoscale electric phenomena of the surface and interface properties of ferroelectric thin films. the experimental setup was calibrated by measuring potential distribution of the working resistance of integrated chip

    在實驗儀器的驗證方面，選用集成電路晶元測試單元中的埋置條形電阻作為檢測對象，在電阻兩端外加直流偏壓后檢測電阻的電勢分佈，在已知電阻上電勢分佈的前提下，驗證了開爾文力顯微鏡檢測微區表面電勢的可靠性。
  14. The traditional level measuring methods can n ' t meet our demand because the subjective investigated is in such a poor systemic condition that the temperature is a little high and there ' s so many mill dust and steam there. in this article we perform systemic discuss and research against the dynamic level measuring method under special working condition on the basis of analyzing kinds of level measuring technique in and abroad. first we establish the pressure distribution mathematic model in storage bin and then deduce the mathematic relation between level height and the uniform stress on the bottom of the bin and designed a resistance compressive stress sensor used for the special condition and put forward a resoivement according to its zero excursion existing in practical use

    由於本研究系統被測對象環境溫度較高且潮濕，同時料倉中有大量粉塵及蒸汽，因此傳統的料位檢測方法不能滿足本測試要求。本文在分析國內外各種物位檢測技術的基礎上，針對特殊工況下動態物料高度的檢測進行了系統的探討與研究。首先建立了料倉中的壓力分佈數學模型，推導出料位高度與倉底均布壓力間的數學關系式，並據此設計了中溫電阻應變式壓力傳感器，同時對它在實際應用中存在的零點漂移等問題提出了改進措施，提高了傳感器性能，解決了上述特殊工況下動態物料檢測的技術難題。
  15. Thirdly, the stress distribution in the human body exposed to stable plane wave is calculated in different incident direction and different polarized. also the stress exerts on the surface between human skull and brain tissue is calculated when the human body is exposed to nuclear explosion electromagnetic pulse or microwave weapon electromagnetic pulse in left incident direction and parallel polarized

    再次，分析了振幅為100 、隨正弦規律變化的穩態平面波沿不同方向或場極化方向不同時人體內的電場應力分佈，結果表明，波沿不同的方向入射或場極化方向不同時，對人體的作用是不同的。
  16. 6. since the reactor has the structure of multi - layer in parallel, the axial electric stress of coil is zero. under steady operation voltage, the voltage is distributed evenly along axial direction of coil

    6 .由於電抗器採用多層並聯結構，線圈的軸向電應力為零，在穩態工作電壓下，沿線圈軸向高度方向的電壓分佈均勻。
  17. On the basis of these conclusions, the stability of natural 2 # landslide body of hongjiadu hydraulic power plant is analyzed with this finite element iteration method and the uniform value off on the sliding surface of the landslide body is inversed. meanwhile, the stability of scaled 2 # landslide body of hongjiadu hydraulic power plant is analyzed and downslide force of scaled 2 # landslide body and normal stress and shear stress on the sliding surface are obtained. in addition, the results provide a reference for reinforcing structure ' s layout

    在此基礎上，文中用該方法對天然狀態的洪家渡水電站2 #塌滑體進行了穩定分析，反演了塌滑體滑動面上均化的f值，對部分削坡后的洪家渡水電站2 #塌滑體進行了穩定分析，獲得了部分削坡后塌滑體的下滑力和滑動面上的正、剪應力分佈，為加固結構布置提供了依據。
  18. Present the experimental research carried out on strain and stress by applying the resistance strain surveying technique to the big hole sealed heads in the new fire - tube heating boilers with the laws of strain and stress distribution obtained and allowable working pressure given because there is no applicable standards or specification for calculating the strength of crude oil heating boiler heads perforated by densely distributed big - holes, which, to a certain extent, hampered the further development of crude oil heating boilers in china, and concludes from experimental results that strain and the stress of circumference are fairly large near the edge of big - hole, and the cross ribs enhance strength of sealed head to a certain degree

    油田火筒加熱爐密集大開孔封頭的設計計算，因沒有相應的強度計算標準在一定程度上限制了我國油田火筒加熱爐技術的發展.採用電阻應變測量技術，對新型火筒加熱爐大開孔封頭進行了應力應變試驗研究，得到了封頭的應變和應力分佈規律，給出了大開孔封頭允許的工作壓力.試驗結果表明，大孔邊緣圓周處應力應變較大，十字筋板對封頭有一定加強作用
  19. We now focus attention on electron 1 and regarded electrons 2, 3…n, as being smeared out to form a static distribution of electric charge.

    我們現在把注意力集中在電子1，而把電子2，3…，n看成是彌散開形成一個穩定的電荷分佈。
  20. First, we extended the liberman model of collisionless rf sheath. taking into account elastic collisions and charge - exchange collisions between ions and neutral particles, we established a self - consistent model describing the dynamics of rf sheath driven by a sinusoidal current source. the effects of collisions and rf - biased source power on the instantaneous thickness of the rf sheath and the sheath electric fields were studied

    首先將liberman的無碰撞射頻鞘層模型進行推廣，考慮了離子與中性粒子的電荷交換碰撞效應，建立了描述碰撞射頻等離子體鞘層動力學特性的自洽模型，研究了碰撞效應，射頻偏壓，電源參數等對射頻鞘層的瞬時厚度及電場分佈的影響。
分享友人
分享到 Line

分享到臉書