電加熱鏡子 的英文怎麼說

中文拼音 [diànjiārèjìngzi]
電加熱鏡子 英文
electrically heated mirror
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 鏡子 : 1. （各種面鏡） mirror; looking glass 2. （眼鏡） glasses; spectacles
  1. The source of electrons in an electron microscope is a heated filament.

    電子顯微鏡中的電子源，是一加熱的燈絲。
  2. Then the molybdenum disulfide nanoparticles which size was in the range of 20 - 30 nm were prepared by the desulfuration of molybdenum trisulfide if taking hydrogen as a protection atmosphere at some temperature. the mos2 nanoparticles were then characterized by x - ray diffraction and transmission electron microscope. the mos2 nanoparticles and commercial common mos2 particles ( c. a

    將乾燥后的三硫化鉬粉末在氫氣保護氣氛條件下，加熱脫硫得到粒徑在20 30nm之間的納米二硫化鉬顆粒，用x射線衍射儀（ xrd ）和透射電子顯微鏡（ tem ）對二硫化鉬納米顆粒進行了表徵。
  3. The major performances of concrete and mortars, which are mixed with different quantities of expansion admixtures under the same mix proportions, are studied systematically and deeply in this work. sulphoaluminate mixed with a type of new expanding component by use of the composite methods are studied in the laboratory, and some achievements have been obtained. the service conditions, the characteristics and the shortcomings of expansion admixture in the concrete engineering are analyzed and summarized based on literatures, and the expanding mechanism of concrete is discussed

    本文試圖從膨脹劑不同摻量研究其對混凝土和砂漿主要性能的影響，進行了一系列宏觀力學性能試驗研究；利用差熱分析（ dta ） 、掃描電子顯微鏡（ sem ）等分析手段對鈣礬石等水化產物的結晶和生成量、形貌特徵進行微觀分析；並採用復合方法摻加新型膨脹組分對硫鋁酸鹽類膨脹劑（ uea ）進行了改性試驗研究，根據多因素模糊綜合評價方法就各類膨脹劑的主要性能進行綜合評價，得出摻加新型膨脹組分pt的膨脹劑性能較優，取得了明顯的效果。
  4. Bearings roller bearings and other components. bearing ring precision rolling production line ; a high - precision, super efficient grinding automatic production line ; bearing assembly line ; signal processing equipment ; blank processing equipment ; crowning roller grinder ; end - grinder ; coordinate precision grinder ;, cylindrical grinder ; surface grinder ; spherical roller processing equipment ; raceway grinder ; heat treatment ; needle processing equipment ; polishing processing equipment ; roller - seiki ; rolling auto - sorting machine parts bearing hardness sorting machine bearing cleaning equipment ; contact angle measuring instrument ; contour meter ; bearing life experimental device ; bearing packaging equipment ; roundness instrument ; dynamic vibration noise analyzer ; noise vibration test equipment ; printing machine measuring instrument ; roughness tester ; scanning electron microscope ; finish detector ; inverter ; spindle, wheel, whetstone and other grinding materials

    軸承套圈精密輾擴生產線高精高效磨超自動生產線軸承自動裝配線球加工設備毛坯加工設備凸度滾子磨床雙端面磨床高精度坐標磨床內外圓磨床平面磨床球面滾子加工設備溝道磨床熱處理生產滾針加工設備光飾加工設備滾道超精機滾動體自動分選機軸承零件硬度選別機軸承清洗設備角接觸測量儀輪廓測量儀軸承壽命實驗裝置軸承包裝設備圓度儀振動噪音動態分析儀振動噪音測試裝置印字機加工測量儀粗糙度測試儀掃描電子顯微鏡光潔度檢測儀變頻器電主軸砂輪油石和其他研磨材料
  5. Furthermore, the growth and the study of self - organized quantum dots structures become more and more important recently, and the application of self - organization technique become wider and wider in this thesis, we address the theory of film growth and the growth technique firstly more, the ways and characteristics of surface detection are prescribed we mainly report the growth process, results and discuss of self - organized quantum dots structures in the a12o3 substrates by s - k mode using ecr - mocvd, in the espd - u device the growth art of ain epilayer which is the preliminary foundation of self - organized gan / ain quantum dots structures, including the substrate cleaning, nitridation, the growth of buffer and the growth of gan and ain epilayer, is discussed we deliberately compare the test result of rheed xrd and afm and achieved the optimalized condition of ain at last we have successfully realized the growth of ain which is much smooth and better crystal quality moreover, we grow the self - organized gan / ain quantum dots structure in s - k mode because the limits of the heater temperature, we can not grow the atom - smooth epilayer of ain until now so we could not grow better quantum dots which have small diameter and big density but the self - organized quantum dots structures with better quality will be realized successfully if the substrate temperature is increased the thesis study belong to my tutor subject of national nature science foundation ( 69976008 )

    本論文主要論述了在espd - u裝置上，採用電子迴旋共振等離子體增強mocvd （ ecr - pamocvd ）方法，在藍寶石襯底上通過s - k模式自組裝生長gan aln量子點結構的生長工藝、結果及討論。而重點分析了自組裝生長量子點之前的aln外延層生長工藝，包括襯底清洗、氮化、緩沖層的生長和gan 、 aln外延層的生長；通過高能電子衍射、 x射線衍射和原子力顯微鏡測試，並且對這些測試結果進行了詳細的比較研究，得出了較優化的工藝條件，生長出了晶質較好、表面較平整的aln外延層；進而採用s - k模式自組裝生長了gan aln量子點結構。由於實驗裝置加熱爐溫度的限制，我們沒有能夠生長出原子級平滑的aln外延層表面，因而沒能夠生長出密度比較大和直徑比較小的量子點。
  6. Microstructural change and thermal shock performance of metal / ceramic graded thermal barrier coatings in thermal shock experiments were studied by scanning electron microscope and energy - dispersive spectrometry. the results showed : 1 ) metal microstructure kept intact while ceramic microstructure had been destroyed ; 2 ) thermal shock performance of coatings was interrelated with its function to relax residual stresses, therefore thermal shock performance of gradient thermal barrier coatings was better than that of terraced thermal barrier coatings ; 3 ) thermal shock performance was concerned with metal content in metal / ceramic thermal barrier coatings, which would be improved when metal content was increased

    利用掃描電子顯微鏡和能譜成分分析技術研究了金屬/陶瓷梯度熱障塗層在熱震過程中的顯微組織變化及其抗熱震性能.結果表明： 1 ）金屬顯微組織保持完好，陶瓷顯微組織有明顯的破壞； 2 ）塗層抗熱震性能與其熱應力緩和功能密切相關，梯度熱障塗層比階梯熱障塗層具有更高的抗熱震性能； 3 ）金屬/陶瓷熱障塗層抗熱震性能與其中金屬相含量有關，金屬相含量增加可改善塗層抗熱震性能
  7. The data of mechanical properties test proved that the composite materials compounded with 0. 39 ~ 0. 46um ps organic rigid particles at 0. 2 % ( wt ) and pp have excellent strength and toughness. sem photograph found that the organic rigid particles were separated into 60 ~ 80nm size in the composite by melting process, which has belter toughness compare with the pp compounded with ultra - fine organic rigid particles

    用2粒徑為0 . 39 0 . 46um的xps復合pp ，經力學性能測試，有最好的增韌效果； sem掃描電鏡發現，經熱加工的復合材料中最小的有機剛性粒子粒徑可部分分散到60 80nm ，該復合材料比超細有機剛性粒子復合的pp有更好的沖擊韌性。
  8. Using the microwave selective heating property for materials, by setup equivalent equation, and first time inducing the electromagnetic field perturbation theory to the design of heating materials for substrate in mpcvd, three temperature distribution modes were established, including temperature distribution comprehensive mode of inhomogeneous plasma, temperature distribution composite mode of composite substrate materials, temperature distribution perturbation mode of composite materials, which ii provided an whole new technology route to the design of substrate heating system in mpcvd and guided the preparation of heating materials for substrate. and then the heating materials for substrate were designed and optimized to obtain large area homogeneous temperature distribution even larger than substrate holder ' s diameter. as an important part, this thesis researched the nucleation and growth of diamond films in mpcvd, systematically researched the effects of substrate pretreatment, methane concentration, deposition pressure and substrate temperature etc experimental technologic parameters on diamond films " quality on ( 100 ) single crystal silicon substrate in the process of mpcvd, characterized the films qualities in laser raman spectra ( raman ), x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), infrared transmission spectra ( ir ), atomic force microscopy ( afm ), determined the optimum parameters for mpcvd high quality diamond in the mpcvd - 4 mode system

    該系統可通過沉積參數的精確控制，以控制沉積過程，減少金剛石膜生長過程中的缺陷，並採用光纖光譜儀檢測分析等離子體的可見光光譜以監測微波等離體化學氣相沉積過程；利用微波對材料的選擇加熱特性，通過構造等效方程，並首次將電磁場攝動理論引入到mpcvd的基片加熱材料的設計中，建立了非均勻等離子體溫度場綜合模型、復合介質基片材料的復合溫度場模型及復合介質材料溫度場攝動模型，為mpcvd的基片加熱系統設計提供了一條全新的技術路線以指導基片加熱材料的制備，並對基片加熱材料進行了設計和優選，以獲取大面積均勻的溫度場區，甚至獲得大於基片臺尺寸的均勻溫度區；作為研究重點之一，開展了微波等離體化學氣相沉積金剛石的成核與生長研究，系統地研究了在（ 100 ）單晶硅基片上mpcvd沉積金剛石膜的實驗過程中，基片預處理、甲烷濃度、沉積氣壓、基體溫度等不同實驗工藝參數對金剛石薄膜質量的影響，分別用raman光譜、 x射線衍射（ xrd ） 、掃描電鏡（ sem ） 、紅外透射光譜（ ir ） 、原子力顯微鏡（ afm ）對薄膜進行了表徵，確立了該系統上mpcvd金剛石膜的最佳的實驗工藝參數。
分享友人
分享到 Line

分享到臉書