電動機轉速 的英文怎麼說

中文拼音 [diàndòngzhuǎn]
電動機轉速 英文
motor speed
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : machineengine
  • : 轉構詞成分。
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • 電動機 : electric motor; motor (俗稱「馬達; 電滾子」)電動機並聯法 parallel connection of the motors; 電...
  • 電動 : motor driven; power driven; power operated電動擺 motor pendulum; 電動扳手 electric wrench; 電動泵...
  • 轉速 : speed; revolution; rotation rate; speed of revolution; rotating speed; rotational speed轉速指示器...
  1. Aiming at permanent brushless dc motor in mini - bev ( battery electric vehicle ) with torque ripple and violent noise during low speed running, the fuzzy control method is combined with slide mode control method to suppress the influence due to un - modeling parameters, and to ensure the robustness in the process of reaching slide mode plane

    摘要針對微型車用永磁無別矩脈大、低運行時噪聲明顯等主要問題,採用模糊控制和滑模控制相結合的方法,克服了未建模參數的影響,保證了滑模到達階段的魯棒性,同時抑制了矩脈
  2. The experiment results indicate that this method is more effective in the brushless direct current motor ' s low speed torque ripple attenuation, and its more effective in improving system dynamic performance

    運行結果表明,此方案能有效地抑制無刷直流時的矩脈,更好地改善系統的態性能。
  3. The dynamo runs at rull speed to drive main shaft, then the main shaft makes the emulsifying wings in emulsification grove rotate, which absorbs the liquid in its brand groove into ring groove through guide vanes on upper and lower sides of the groove. the vanes spins circularly at high speed with the main shatf as center, and the blade and emulsificaton groove cut and crush it continuously. after that. it gers squeezed by the vanes highspeed centrifugal rotation. at last, it finishes isotropt emulsification tratment within extremely short time after continuous circulating mixing

    主軸,經主軸乳化框槽內之乳化翼片,使其將桶槽內之液體經框槽上、下兩側之導流葉片吸入環狀框槽內,經以主軸為中心高圓周旋葉片;連續使乳化翼端刀面與乳化框間極小之間系高頻率之強力切割剪斷、粉碎,再借葉片高離心旋排擠,持續循環混合,以極短之時間即可完成均質乳化之處理。
  4. Finally, we can not use electric power but the engine of bus or subsidiary engine to drive air compressors of bus air conditions. because the change range of turnaround speed of engine is very wide, that brings difficulties in controlling the rate of flow of cold - producing medium. in the control of bus air - conditions, preventing evaporator from freezing to make the air - conditions work with high efficiency and controlling the temperature of railway carriage are the basic tasks in air - condition control

    與一般的建築空調相比,汽車空調的工作環境惡劣,條件差,控制難度要增加很多,主要體現在以下幾個方面:一是車外熱負荷變化大,難以確定控制參數;二是要求空調負荷大,而且要控制空調使其降溫迅:三,不便於用力作為力源,必須用汽車發或輔助發來帶壓縮,當採用汽車發作為力源時,由於汽車的車變化大,發的變化可從600r min到4000r min ,壓縮與發成正比,其變化高達7倍,給空調系統製冷劑流量控制帶來困難。
  5. Engine was motored by a 37kw electric engine and the s. i. engine ' s revolution was change by a 4 - position transmission

    由37kw,使用4檔變器改變發
  6. Besides to control rotate speed of electromotor, the control system adjusts wind speed, substantively it is the control of speed press ( v2 = 2q / p ). so, flow field control system adjusts speed press through the control of rotate of electromotor

    風洞流場控制系統除對電動機轉速調節外,主要控制風v ,實質上就是控制其壓q ( v ~ 2 = 2q p ) ,所以,風洞流場控制系統是通過控制電動機轉速,來調節實驗段內的壓。
  7. Design of fuzzy control system on motor rotating speed

    電動機轉速模糊控制系統設計
  8. In the process of parameters identification, the stator voltag is considered as input quantity and the stator current and motor rotate speed are considered output quantities. the rotor resistance and leakage inductance are estimated on - line and the identification results is got at last

    在參數辯識過程中,以時的定子壓為輸入量,定子流和為輸出量,對復合籠條子感應阻和漏感進行在線估計,最後得到阻和漏感的辨識結果。
  9. Modified formula for sensorless dc motor speed estimation was proposed through the test for relationship between the current ripple frequency and the rotation speed in a 4 - pole dc motor

    摘要根據4極直流與脈流頻率關系的實驗結果,對現有的無傳感器直流公式提出了修正意見。
  10. The new modified formula not only meets with our experiment result, but also can explain the examples of relationship between the speed and the current ripple frequency of dc motors in the literature

    新的修正公式不僅能夠解釋文中的實驗結果,也能滿足以往文獻提出的直流電動機轉速與脈流頻率之間的關系。
  11. This paper mainly focuses on the fluctuation of velocity and torque of the electromotor because of the variational load in the pumping unit equipment

    摘要抽油中載荷變化大,易引起電動機轉速矩的波
  12. The dissertation deals in details with the basic principle of direct torque control. according to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy change the method of regulating stator flux to make its path approximate to a circle as possible as could. to get quickly torque control, use a three - value regulator

    本論文介紹了直接矩控制的基本原理,並根據傳統直接矩控制存在的缺點以及對調性能的要求,改變對定子磁鏈的調節方式,使定子磁鏈軌跡近似為一圓形,對矩採用三值調節器進行調節,以實現矩的快調節。
  13. According to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy, the author changes the method of regulating stator flux to make its path approximate to a circle as possible as could and put forward a new way to use a three - value torque regulator

    本論文研究了異步的數學模型,介紹了直接矩控制的基本原理,並根據傳統直接矩控制存在的缺點以及對調性能的要求,改變對定子磁鏈的調節方式,使定子磁鏈軌跡近似為一圓形。
  14. Estimation of rotation speed for induction motor under non - sinusoidal power supply based on modified bp network

    神經網路非正弦供下異步電動機轉速估計
  15. Development of dynamic measuring system for small - motor torque - moment

    小型態測試系統的研製
  16. The paper lucubrated the control theory of induction motor ' s vector transform and the method of calculating speed by induction motor ' s torque current weight, based on which, the paper designed a close - loop speed - sensorless vector control vwf system and realized the system in matlab / simulink

    本文深入研究了感應矢量變換的控制理論和利用流分量進行度推算的方法。在此基礎上設計了一個閉環的無度傳感器矢量控制變頻調系統。
  17. When cruising under low power demand conditions, the engine & motor will turn relatively slowly, while they will turn faster when accelerating or climbing a hill

    在低功率條件下巡航時,發電動機轉速相對較慢,然而,加和爬坡時,旋快。
  18. Step motor has the advantage of the reliable, simple and high accurately control in the control system. as industrial controlling computer, plc can control the rotation and feed

    摘要步進在開環控制系統中具有作可靠、控制簡單、控制精度高等優點, plc作為工業控制計算,可實現步進電動機轉速和進給量的控制。
  19. It is indicated that, when a two - speed motor is used for driving oil transfer pump, the motor with the characteristic of torque reduction on square rotary speed should be chosen ; the working economy of the variable speed pump is restricted by the characteristic curves of pipeline resistance, and its speed control range is restricted by the pipeline resistance characteristic curve, the pressure head needed by the system and the working characteristic of the pump ; when several pumps work in parallel, the pump with better performance should be changed into speed - variable pump

    指出雙用於輸油泵的調時,應選用矩按平方降低特性的;調泵的運行經濟性受到管路阻力特性曲線的限制,其調范圍受到管路阻力特性曲線、系統所需揚程和泵運行特性的限制;在母管制系統中把部分定泵改為調泵時,應將性能較高的定泵改為調泵。
  20. The concrete design method of the votating speed difference frequency fuzzy controller is studied in detail. based on single - chip microcomputer 8031, using table look - up method, votating speed difference frequency fuzzy controller applied to induction motors is implemented. simulation result demonstrates that the control result for the producing plastic flat yarn of votating speed difference frequency fuzzy control to the speed of induction motors is idealer

    本文對差頻率模糊控制器的具體設計方法進行了討論:以單片為核心,用查表法實現異步差頻率模糊控制;最後,結合工廠塑料平膜拉絲參數對系統進行了模擬,分析了差頻率模糊控制對異步電動機轉速的控制效果,結果是比較理想的。
分享友人