電壓波節 的英文怎麼說

中文拼音 [diànyābōjié]
電壓波節 英文
voltage node
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 節 : 節構詞成分。
  • 電壓 : voltage; electric tension; electric voltage
  1. The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor

    文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。
  2. When the voltage of the primary fluctuated is within the range of 5 %, with mediating the saturation of the magnetic flux, this new interfluent stable power supply can retain the outputting power of the secondary invariable

    當一次側電壓在5 %額定電壓范圍內波動或偏移時，通過調節磁路的飽和程度，保持二次側輸出電壓不變。
  3. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。
  4. Then novel circuit structure of bi - directional voltage mode ( based on forward converter ) inverters with high frequency link, are proposed, which is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filter ; the circuit topologies family of this bi - directional voltage mode inverters with high frequency link include six circuit topologies, such as push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controlled bi - directional voltage mode inverters with high frequency link is introduced

    本文首先論述了dc / ac逆變技術的應用前景及發展現狀。基於正激forward變換器的雙向電壓源型高頻環節逆變器電路結構，由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成;雙向電壓源高頻環節逆變器電路拓撲族，包括推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式六種電路。
  5. ( 8 ) by studying match between the electronic system and catalytic converter on the base of electronic controlled bypassing air system, conclusions having been gotten as follows : higher conversion efficiency of emission have gotten when a / f fluctuates at definite scope and frequency, by controlling the comparing voltage of 02 sensor, the working scope of catalytic converter can be controlled and the matching that can fulfill the high efficiency of hc, co, nox at same time has been optimized

    （ 8 ）進行基於所開發的電控補氣系統上的催化器與電控系統的匹配研究，當控制系統調節空燃比在一定范圍按照一定頻率進行波動時，可以提高催化轉化器的轉化效率；通過控制氧傳感器的比較電壓，可以控制催化轉化器的工作窗口，實現排放污染物中， hc 、 co 、 nox轉化的最優匹配。
  6. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電動勢類似正弦的準正弦波反電動勢無刷直流電動機，本文提出一種基於六個離散位置信號的自同步svpwm （電壓空間矢量法）控制方法，用以削弱電磁轉矩脈動，分析了實現這種方法的主要控制環節，包括起動時電壓空間矢量的初始定位，阻抗角與電流超前角的合理選擇以及連續轉子位置的估計等。
  7. The pwm control of duty cycles acts as an electric transformer which regulates the amplitudes of equivalent input voltage and equivalent output voltage, so that both positive and negative amplitudes of equivalent input voltage are equal to those of equivalent output voltage

    對器件占空比的pwm調節，相當于在電路中加入一個電子變壓器，使得輸入方波電源和輸出方波電源的正負電壓幅值分別匹配。
  8. Voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  9. Abstract : voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    文摘:採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  10. The control method was introduced and the hardware of the controller was designed. the controller uses the 89c52 and 89c2051 as the main control unit and produces the on and off and angle signal of each phase. combined with protecting signal and current chopping signal, it can control the igbt on and off

    介紹了srd的控制方式和本系統所採用的控制策略，對控制器的硬體電路進行了設計，控制器以89c52和89c2051雙cpu為主控單元，採用模糊調節，發出相通斷信號和角度信號，並和電流、電壓等保護信號以及斬波信號相結合，實現對主功率元件的通斷控制。
  11. The generator is verified to be of well performances by experiment. the third part concerns the control system of pm generator in vehicle application by commutating and inversion. considering the development of future power supply of auto electric system and the economizing on energy, the multi - voltage power supply system for future autos power supply system is introduced, and the design is given in detail

    最後，結合現代電力電子技術，利用整流橋、逆變器、 mosfet等元器件設計並實現了車用永磁發電機恆壓輸出控制；從未來汽車電氣系統的發展方向和高效節能方面考慮，提出未來汽車的多電壓供電系統的典型配電模型，並對該模型進行具體設計，實現多電壓供電的功能，並給出了控制線路中各主要部分的波形。
  12. 3. the new microwave power supply ( mps ) can work in vacuum and its power measurement is convenient. the output power could be adjusted with the change of control voltage, and the reflecting power could be gotten by measuring the output voltage of attenuator and detector

    （ 3 ）可在真空下穩定工作的新型微波源功率的測量較為方便，通過改變控制電壓的大小可以調節輸出功率，通過測量衰減檢波器的輸出電壓信號可實現反射功率的測量。
  13. Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead

    通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定
  14. On account of the disadvantages of the feedback reactive power compensator, a device of its simplified scheme is studied in this paper, in which the reactive power is adjusted by regulating the voltage of the low - voltage side of the transformer

    由於這種反饋式補償方案存在一些問題，本文分析了它的簡化形式，即通過調節降壓變壓器低壓側的母線電壓來調節濾波器的無功出力的補償方案。
  15. Based on iec standards, the methods of designing square demodulator, bandpass - weighted filter, and smoothing filter are presented. besides, the signal conditioning circuits and online statistical analysis methods of instantaneous flicker value are given. matlab simulink is also used to simulate the measuring process of voltage fluctuation and flcker

    基於iec標準要求，設計了實現數字式電壓閃變測量的平方解調器、帶通加權濾波器、平滑濾波器等各環節，給出了信號調理電路和瞬時閃變值在線統計分析方法，並應用matlab系統模擬工具simulink對電壓波動和閃變測量全過程進行了數字化模擬。
  16. Under the control of microcomputer, the sine vave output is produced. base on the result, the spwm wave is static and reliable

    從逆變環節的實驗結果來看，產生的spwm波穩定、可靠，輸出電壓波形失真度小，電壓波動率僅在2左右。
  17. In this paper, pwm double - bridge superposition regulator, ac chopping regulator and series voltage regulator were analyzed

    摘要分析了pwm雙橋疊加型、交流斬波型和串聯型3種變頻型交流電壓調節電路。
  18. The inverter apparatus controlled by pre - set voltage adjustment project has the advantages of low harmonic content, high output frequency precision, simple control circuit. therefore, this kind of project is the hot point in inverter power studying field

    用「開關預置式電壓調節方案」控制的逆變電源具有輸出諧波含量低、輸出頻率精度高、控制電路簡單等優點，是逆變電源研究領域的熱點。
  19. The voltage is manually regulated by non - load machine switch, which is apt to be burnt. as a result, frequent fixing is inevitable ; moreover, these methods of controlling cannot meet the needs of processing certain work pieces

    電壓調節通過人工轉換無載分接開關機械觸點實現，造成無載分接開關容易燒壞，維修頻繁，並且溫度波動大，有時不能滿足某些工件的加工要求。
  20. As a result, there are some disadvantages for its large size, heavy weight and lower efficiency. in this paper, phase - shifted zero - voltage - switching pwm converter is presented, which is help to ruduce the size and improve the efficiency of inverter. in the later stage, we adopted a pic microcomputer as the control chip, whose low price decreases the price of the inverter

    在逆變環節中，本文採用體積小、功能全、價格便宜而且簡單易學的單片機pic16c72作為控制晶元，對前級直流電壓進行spwm正弦脈寬調制，從而產生了高質量的正弦輸出電壓波形，減小了輸出電壓中的諧波含量。
分享友人
分享到 Line

分享到臉書