電壓波 的英文怎麼說

中文拼音 [diàn]
電壓波 英文
voltage wave
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 壓構詞成分。
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • 電壓 : voltage; electric tension; electric voltage
  1. In addition, we analyse the dead time effects of pwm control on the output waveform

    另外還分析了逆變橋上下管驅動信號上的死區對輸出電壓波形的影響。
  2. Comparing with other current, the interfluent power supply has many merits such as simple structure, high precision and perfect voltage wave

    該交流穩源與現有交流穩源比較,具有結構簡單、精度高、電壓波形好等優點。
  3. Series reactor is applied to ac power system with rated voltage of 6kv - 63kv and series connected with shunt capacitor banks for restraining wave distortion in grid voltage so as to improving the quality of power system and ensure the safety of its operation. it can restrain harmonic current and surge current in capacitor banks so that the capacitor will operate reliably

    Ckdk型串聯抗器,適用於6 63 kv力系統中,與並聯容器相串聯,用以抑制電壓波形畸變,從而改變網質量和保證力系統安全運行抑制流過容器組的諧流和限制合閘涌流,從而保護容器的安全可靠運行。
  4. Dry - type air - cored series reactor is applied to ac power sys - tem with rated voltage of 6kv 10kv 35kv and series connected with shunt capacitor banks for restraining wave distortion in grid voltage so as to improving the quality of power system and ensure the safety of its operation

    乾式空芯串聯抗器適用於6kv 10kv 35kv力系統中與並聯容器組串聯,用於抑制電壓波形畸變,從而改善網質量和保證力系統安全運行,抑制流過容器組的諧流和限制合閘涌流,從而保護容器使之安全運行。
  5. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道機的設計進行了系統研究。首先對變頻器和變頻輥道機的運行特性進行詳細分析,變頻器輸出的電壓波形諧大,沖擊大,上升率高達6600v / s ,是普通正弦交流的20倍;軋機輔傳輥道對機提出了十分嚴格的要求:其運行頻率很低,額定頻率在8 - 20hz ;調速范圍寬,最低運行頻率低到0 . 5hz ,起動次數相當頻繁,每小時高達600 - 800次,沖擊負荷大,過載能力要求較高。
  6. Based on the new method, a digital meter of detecting voltage fluctuation and flicker is implemented with single chip microprocessor

    基於新的檢測方法,設計了用單片機系統實現的電壓波動與閃變微機檢測儀。
  7. The basic concepts and character values of voltage fluctuation and flicker are introduced firstly, and then the common methods of suppress the voltage fluctuation are discussed. further more, the process of extracting voltage fluctuation signal and calculating flicker values is analyzed, and the principle of detecting voltage fluctuation and flicker is detailed. by analyzing and comparing the features of the methods and devices in existence, a new digital detection method is present

    論文介紹了電壓波動和閃變的基本概念、特徵量以及抑制電壓波動與閃變的常用方法,從電壓波動信號的提取和閃變值的獲得兩方面系統地闡述了電壓波動與閃變的檢測原理,分析比較了現有測量方法和裝置的特點和優劣,在此基礎上,提出了一種新的數字式微機檢測方法。
  8. Electromagnetic compatibility - part 3 - 3 : limits - limitation of voltage changes, voltage fluctuations and flicker in public low - voltage supply systems for equipment with rated current inferior or egal to 16 a per phase and not subject to conditional connection

    磁兼容性.第3 - 3部分:限值.額定流小於或等於16a相併且在無條件連接情況下的設備用公共低系統的變化電壓波動和閃動的限值
  9. This paper introduces a power controlling system for electrosurgical generator based on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    介紹了基於可控硅整流路的高頻刀控制系統,並針對該類型刀的輸出功率隨電壓波動而發生漂移的問題,採用了一種功率補償的方法,實現輸出功率在不同的動下保持恆定。
  10. This paper introduces a power controlling system for electrosurgical generator baaed on thyristor, and proposes a power compensating method to maintain the output power invariable when the ac voltage fluctuates

    摘要介紹了基於可控硅整流路的高頻刀控制系統,並針對該類型刀的輸出功率隨電壓波動而發生漂移的問題,採用了一種功率補償的方法,實現輸出功率在不同的動下保持恆定。
  11. It is capable of detecting the value of both the fluctuation voltage and the fluctuant power

    該方法可檢測出每個調幅周期中的電壓波動值,並且能計算動功率。
  12. This will avoid the trouble of hand operation and protect people ' s eyes by its special fuction of maintaining the light stability under fluctuate voltage

    即可減少手動調光的麻煩,又可以保護視力,同時,它具有穩光功能,當電壓波動時,臺燈亮度保持不變。
  13. According to iec ' s standards involved, voltage fluctuation and flicker become a index of power quality. but the research in those aspects such as harmonic frequency excursion and ect

    然而,人們對于能質量中諸如諧、頻率偏移等方面的研究相對電壓波動和閃變來說要多得多,研究得也較成熟。
  14. You cannot switch thebutton to the faster level directly from the stop status to keep the voltage jump within usb limits ( 500ma ) during motor start up

    為了保證吸塵器機啟動時電壓波動在usb介面限制的范圍( 500毫安)內,不能直接將開關從停止位置打到快速檔。
  15. The instantaneous voltage inner loop is used to control output voltage waveform to track a sinusoidal waveform. and the outer average voltage loop guarantees accuracy of output voltage

    瞬時值內環保證輸出電壓波形的正弦度,平均值外環實現對輸出幅值的控制。
  16. ( 3 ) verifies the voltage wave, electrical current vuive and output power wave of asteroidal magneto, and the veracity of parameters by a series of experiments. the experimental result demonstrates that the error is less than 10 % between theoretic value and actual value

    ( 3 )通過一系列實驗驗證了星形磁機空載電壓波形、形、短路流倍數、輸出功率等形和參數的準確性,實驗結果表明,理論與實測值相差不到10 。
  17. Secondly, the math model of the high - speed pm generator with a shielding is deduced. the method of how to analyze the electromagnetic field of the generator is introduced. and with the help of a kind of fem software, the parameters of a model machine are calculated and simulated, including the electromagnetic field, no - load voltage, single - side magnetic force, loaded torque and axial force

    其次,對轉子帶防護罩的高速永磁發機數學模型進行了推導,介紹了利用有限元法對機磁場進行分析的方法,並運用有限元軟體對一臺樣機的參數進行了模擬,包括機磁場分析、空載電壓波形、單邊磁拉力、負載轉矩以及軸向力等方面的內容。
  18. Analyze item by item the position of unintact cycle, the running clearance of unintact cycle, locking - deform, datum dimension regulating, repeatly install, power voltage wave and marking running etc. at the same time, we give the calculating formula to calculating the running marking random error, and use it to calculate the system error of big diameter measure instrument - - datum dimension frame error, gyro - wheel diameter error, error caused by circumstance temperature, error caused by backing distance, angle error, delay error of data collecting circuit, lathe main shaft running error, workpiece install partial error

    對不完整圓的位置、不完整圓的轉動間隙、鎖緊變形、基準尺調整、重復安裝、電壓波動、標記轉動等隨機誤差進行了逐項分析,並給出轉動標記隨機誤差的計算公式。對大直徑測量儀的系統誤差?基準尺尺架誤差、滾輪直徑誤差、環境溫度引起的誤差、後退距離引起的誤差、角度誤差、數據採集路延時誤差、車床主軸回轉誤差、工件安裝偏心誤差分別進行了計算,最後對誤差進行合成。
  19. This paper simulates the effect of voltage fluctuation inspection through the tool of matlab. and proves the filters ' s stability. in the part of self - checkout, pi ( proportional integral ) control arithmetic is put forward to check the gain k and the calculated results show the method ' s effectiveness. then many comparements toward pst are done in different realization methods such as different interpolation points classification number and sample frequency. though simulation and calculation we can see the designed flicermeter can meet our country ' s standands

    文中利用matlab對電壓波動的檢測效果進行了模擬;並對涉及到的濾器的穩定性做了證明;在自校驗部分提出了將pi (比例、積分)演算法用於數字濾器增益k值的確定,取得了不錯的效果;然後分別從取不同插值點、不同分級數和不同采樣頻率這幾個方面出發,對計算出的p _ ( st )值進行了比較。
  20. For the improvement of reliability and stability of the whole apparatus, meanwhile, for eliminating various electric - magnetic disturbance within the power supply and ground, measures such as filter, grounding, shielding are all taken in technique. the special methods are lc filter for power supply, bypass capacitor for suppressing voltage surge in printed circuit board, shielding layer wrapped in sensor head and overall grounded

    通過採用合理的濾、接地、屏蔽等各種方法,尤其是採用源lc濾路、源上加旁路容抑制線路板上的電壓波動、傳感頭加屏蔽層、傳感頭總體接地結構等多種抗干擾辦法,減小了源和地線上的各種磁干擾,保證了系統的穩定性和可靠性。
分享友人