電壓測量 的英文怎麼說

中文拼音 [diànyācèliáng]
電壓測量 英文
voltage measurement
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 電壓 : voltage; electric tension; electric voltage
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. The instrument is integrated with a multi - channel high precision open circuit potential measurement system for the ion selective electrode and a potentiostat used in voltammetry, an analog lock - in amplifier is also presented to measure the response of light addressable potential sensor

    對于不同的測量技術，儀器中集成了用於測量電極的多通道高精度開路電壓測量系統和用於溶出伏安法測量的多路電化學測量系統，以及用於測量光尋址電位傳感器的鎖相放大器。
  2. Additional voltage measurement at other frequency settings as well as frequency accuracy check may be offered at extra charge

    本所亦可提供在其他頻率的電壓測量服務及頻率準確度檢查，但須另行收費。
  3. Voltage measurement by means of standard air gaps

    高電壓測量標準空氣間隙
  4. Railway applications - fixed installations - d. c. switchgear - measurement, control and protection devices for specific use in d. c. traction systems - isolating voltage transducers and other voltage measuring devices

    鐵路設施.固定設備.直流開關裝置.直流牽引系統專用測量控制和保護設備.絕緣電壓傳感器和其他電壓測量設備
  5. The main contributions to the study on the flashover of insulators in vacuum are as follows : 1. a set of test system for the studies on flashover of insulators in vacuum has been developed, which consists of vacuum system, electrode system, e - dot pulse voltage measurement system, surface charge measurement system, current monitor system and luminescence signal measurement system

    本文主要完成了以下工作： 1 .通過設計加工真空及試驗電極系統，研製e - dot沖擊電壓測量系統、真空中表面電荷測量系統、沖擊電流和表面微弱光信號測量系統，建成了國內第一套用於研究真空中絕緣子沿面閃絡現象的試驗平臺。
  6. Rules for capacitors ; part 3 : rules for capacitors for coupling, voltage measurement and overvoltage protection

    電容器規范.第3部分:耦合電壓測量超壓保護用電容
  7. That test part of the software is primarily used to complete the test of some parameters, such as time base, time - expand, time interval, voltage interval, vertical, stable state, transient state and scanning linearity. the result of the test needs to be analyzed and judged. clear user interface and timely warnings for mistakes of testing process inside because of the user ' s fault operating make whole test process more easier than it did on a time

    該軟體的測試部分主要用於完成對示波器掃描時間系數、擴展掃描時間系數、 t時間測量、 v電壓測量、垂直偏轉系數、頻帶寬度、校準信號、脈沖瞬態響應、掃描線性誤差時等參數的測試檢定任務，並對測試結果進行及時的分析和判斷，由於界面清晰，而且對測試過程中由於用戶的誤操作都有及時的錯誤提示，使得整個測試過程簡單易行，對于用戶來講掌握起來也更為方便些。
  8. Abstract : the paper proposes a mathematical model of a / d converter with quantizing error, nonlinearity and differential nonlinearity errors for computer simulation, and based on the model, the errors caused by voltage change, current change and phase change in the power measurement are analyzed by computer simulation for both the asynchronous and quasi - synchronous sampling algorithms

    文摘:本文提出了具有量化誤差、非線性誤差和微分非線性誤差的a / d轉換器的數學模型，在該數學模型的基礎上，模擬分析了非同步采樣法、準同步采樣遞推演算法各種情況下的誤差，包括功率測量中電壓線性、電流線性、相位變化誤差及電壓測量的誤差。
  9. Input impedance for dc voltage measurement

    電壓測量輸入阻抗
  10. The paper recommends that the placement of voltage - electrode is 0. 509s when the distance from the border of grounding grids to current - electrode is s that is the long border length of grids. ( 3 ) the paper use two - layer theory to describe non - uniform soil. with the different two - layer soil model, some conclusions and formula that have great reference value are presented numerically

    綜合各種因素考慮，推薦在距離地網邊緣距離為地網長邊長度s的位置布置電流極，並在0 . 509s布置電壓測量極，在滿足工程精度要求的同時也極大的提高了測量效率。
  11. Then, based on the estimation algorithm decomposing the measurement of voltage scope and power scope, the problems of the location of transformation tap settings and the tide current estimation of zero - impedance branches in state estimation are solved ; and detection and identification of bad data in state estimation are deduced and stimulated, also a hybrid method of detection and identification is brought forward

    隨后，在基於分解電壓測量量和功率測量量的估計演算法的基礎上，對狀態估計中經常出現的變壓器抽頭位置問題和零阻抗支路潮流估計問題進行了分析和處理；對狀態估計的不良數據檢測與識別方法進行了推導和模擬，並提出了一種混合檢測方法。
  12. Voltage measurement at each additional frequency voltage combination

    每一額外頻率電壓組合的電壓測量。
  13. The meter can be measured as in all kinds of ac / dc ampere 、 ac / dc voltage

    本儀表適用各種工業用電的交流直流電流電壓測量顯示。
  14. Gallium arsenide epitaxial layer - determination of carrier concentration - voltage - capacitance method

    砷化鎵外延層載流子濃度電容-電壓測量方法
  15. This paper designs a device of testing the arc shield voltage in the vacuum interrupter, and makes a study of the arcing and after - arcing recovery characteristics of the arc shield by measuring the arc current, the arc voltage, the recovery voltage and the arc shield voltage

    本文設計了真空滅弧室屏蔽罩電壓測量裝置，並對真空滅弧室在燃弧和弧后介質強度恢復過程兩個階段的電弧電流、電弧電壓、恢復電壓和屏蔽罩電壓進行了全面、系統的波形測試，研究了真空滅弧室蒸汽屏蔽罩在燃弧和弧后介質強度恢復過程的特性。
  16. Principle of the reaction of the mh / ni battery, the characteristics and existed problems of different kinds of soc measuring methods are compared, such as use voltage or resistance of the batteries to get the soc, then put forward the way of ann to estimate soc of the batteries in this research

    研究了鎳氫蓄電池soc的幾種預測方法：即通過計算電池在充放電時的累積電量來估計電池的soc的電量累積法：通過計算鎳氫電池的內阻來計算電池soc的電阻測量法和通過測量電池的開路電壓來估計soc的電壓測量法，比較了它們的優缺點，並提出了本文的基於人工神經網路的soc測量方法的思想。
  17. The virtual oscillograph to measure voltage is brought into the system. its daq board is based on epp and 8051 is used as the controller

    本系統集成了虛擬儀器完成電壓測量，製作了基於增強并行口epp 、以8051為控制核心完成量程自動轉換的數據採集板。
  18. Voltage measurement method with sphere gap

    電壓測量方法
  19. In this paper, a method to measure background harmonic voltages is proposed on the basis of users harmonic current characteristics, and magnification of background harmonic voltages in small power supply networks is analyzed preliminarily

    本文提出一種根據用戶諧波特徵進行背景諧波電壓測量的方法，並對一些小電網背景諧波電壓放大現象進行初步分析。
  20. Measuring devices for x - ray tube voltage

    X光射線管電壓測量裝置
分享友人
分享到 Line

分享到臉書