電壓饋電 的英文怎麼說

中文拼音 [diànyākuìdiàn]
電壓饋電 英文
voltage fed
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 壓 : 壓構詞成分。
  • 饋 : 動詞（饋贈） make a present of
  • 電壓 : voltage; electric tension; electric voltage
  1. In this paper, a kind of output current feed - forward circuit is added into the input of the current loop. by adding this compensatory circuit, the output character of the inverter is improved greatly

    本文還研究了一種提高逆變器輸出電壓外特性的思路，通過將負載電流正反饋給逆變器的電流環輸入端，從而達到提高輸出電壓的外特性的目的。
  2. A circuit topology of the inverter with duty cycle extended active clamp forward style high frequency pulse dc link is adopted by each independent inverter. each inverter is cascaded by a circuit with duty cycle extended active clamp forward style high frequency pulse dc link and a dc / ac inverting bridge. the control strategy of voltage mode pwm forwardback is adopted by the former, and the control strategy of three - state discrete pulse modulation ( dpm ) hystersis current is adopted by the later

    每個獨立的航空靜止變流器採用占空比擴展有源箝位正激式高頻脈沖直流環節電路拓撲，由占空比擴展有源箝位正激式高頻脈沖直流環節電路與dc ac逆變橋級聯而成，前級採用電壓型pwm前饋控制技術，后級採用三態dpm電流滯環控制技術。
  3. It is fed into the grid at this voltage.

    它是以這種電壓饋入電力網。
  4. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。
  5. The " parafeed " ( parallel feed ) uses a large choke to provide the dc voltage to the anode

    旁饋耦合使用一個大型的扼流圈來為屏級供給直流電壓。
  6. It is necessary to control the mechanical stimuli precisely in the studies of cardiac mechano - electrical feedback ( mef ). in the present study a ventricular pressure - clamping system has been developed, which can be applied to isolated - perfused rabbit hearts. controlled by a computer, this system not only can make the left ventricle follow a command defining the same pressure wave as that during a beating cycle under physiological condition, but also deliver mechanical stimuli with a proper waveform to the ventricle at a particular time phase. this system integrates multiple functions, including perfusing, pacing, recording of electrocardiogram and monophasic action potentials, and clamping and measuring of ventricular pressures in isolated - perfused hearts. thus, it is a distinct system for investigating the phenomena and mechanisms of cardiac mef at organ level

    在心臟機械電反饋的研究中準確控制機械刺激是非常重要的.本研究室構建了一套適用於離體家兔心臟的心室壓力鉗系統.該系統通過計算機控制壓力鉗，不僅能模擬正常生理條件下左心室的壓力波形，還能在心室活動周期的特定時相、以適當波形對心室施加機械刺激.該系統集心臟灌流與起搏、表面心電圖記錄、單相動作電位記錄、心室壓力鉗制與測定等多種功能於一體，特別適用於器官水平上觀察機械電反饋現象並探討其機制
  7. Abstract : it is necessary to control the mechanical stimuli precisely in the studies of cardiac mechano - electrical feedback ( mef ). in the present study a ventricular pressure - clamping system has been developed, which can be applied to isolated - perfused rabbit hearts. controlled by a computer, this system not only can make the left ventricle follow a command defining the same pressure wave as that during a beating cycle under physiological condition, but also deliver mechanical stimuli with a proper waveform to the ventricle at a particular time phase. this system integrates multiple functions, including perfusing, pacing, recording of electrocardiogram and monophasic action potentials, and clamping and measuring of ventricular pressures in isolated - perfused hearts. thus, it is a distinct system for investigating the phenomena and mechanisms of cardiac mef at organ level

    文摘:在心臟機械電反饋的研究中準確控制機械刺激是非常重要的.本研究室構建了一套適用於離體家兔心臟的心室壓力鉗系統.該系統通過計算機控制壓力鉗，不僅能模擬正常生理條件下左心室的壓力波形，還能在心室活動周期的特定時相、以適當波形對心室施加機械刺激.該系統集心臟灌流與起搏、表面心電圖記錄、單相動作電位記錄、心室壓力鉗制與測定等多種功能於一體，特別適用於器官水平上觀察機械電反饋現象並探討其機制
  8. From the simulation results, we can see that, for the presented cmos preamplifier - latch comparator, its transfer delay time is 231ps, and the power dissipation is 118. 6 w

    時，其回饋噪聲對輸入信號和電阻串參考電壓產生的毛刺峰值分別是6 . 35mv ， 1 . 57mv ;各級子adc的總功耗為5 . 57mw 。
  9. The voltage of bridge capacitor will become unbalanced, when inverter ' s input side is a single source. this phenomenon is inherent with the control of voltage feedback. a balance winding can overcome this shortcoming and widen the application of this circuit

    採用單電源供電的半橋電路，如僅採用電壓反饋控制方案無法克服橋臂電容電壓的不平衡，通過加入平衡繞組可以克服這一缺陷，擴大電路的應用場合。
  10. The full - bridge converter was controlled with the pid strategy based on the feedback of voltage output

    電源的全橋功率變換器採用基於電壓瞬時值反饋的數字pid控制。
  11. First, it analyzes the working principle and some features of the system, such as the circulating current characteristics, power distribution characteristics, and characteristics about closed loop regulation of voltage. then it goes on to the study of some typical control methods, and designs on this basis, a parallel controller using a synchronization control strategy of racing to merging and a load - sharing strategy combined with feedback control and drooped control

    文中，首先通過建立系統的數學模型，分析了逆變電源並聯運行的工作原理以及並聯系統的一些主要特性，包括它的環流特性、功率特性和電壓閉環調節特性；在此基礎上，又研究了幾種典型的並聯運行控制方式；然後，採用搶占與並發相結合的同步控制方式和反饋與下垂特性相結合的負載均分控制設計了並聯控制器。
  12. Secondly, compared with some other kinds of comparator structure and based on the preamplifier - latch fast - compare theory, a novel topology of cmos preamplifier latch comparator circuit is presented. considering trade - off between kickback noise and power dissipation, reference resistance value is optimized. according to the encode demands of different stage resolution, clock - control encode circuit is designed

    其後，在具體的子adc設計中，對比各比較器類型的優缺點，並基於預放大鎖存快速比較理論，提出一種新型高速低功耗預放大鎖存比較器電路拓撲;根據adc系統所允許的參考電壓最大波動限制，在回饋噪聲對輸入參考電平的影響和功耗之間折衷，確定優化的參考電阻串阻值;根據不同級精度的編碼要求，設計出時鐘控制編碼電路。
  13. Current feedback vs. voltage feedback operational amplifiers

    電壓反饋和電流反饋運算放大器的比較
  14. Based on output voltage and capacitor - current feedback current spwm control, the inverter is modeled and the prototype is made

    並對採用輸出電壓和電容電流瞬時值反饋的電流spwm控制技術逆變器建立了模擬模型，製作了原理樣機。
  15. Current - mode dc / dc converter adds a current feedback loop on the base of voltage - mode control, achieving both current and voltage feedback loop control

    電流模式dc / dc變換技術是在電壓模式控制的基礎上，增加了電流反饋環，實現了電壓和電流的雙環反饋控制。
  16. Hand crimping tools - tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - part 2 - 5 : particular requirements for the termination of twin - ax cable for databus applications

    手工壓接工具.低頻和射頻設備用電纜和電線的壓接終端工具.第2 - 5部分:數據總線設備用屏蔽雙導線饋電線電纜的終端的特殊要求
  17. By comparing and analyzing the advantages and disadvantages of three kinds of voltage reference circuits, type of current density ratio compensation 、 weak inversion type and type of poly gate work function, a cascode structure of type of current density ratio compensation is chosen to form the core of voltage reference circuit designed in this paper. applying the negative feedback technology, an output buffer and multiply by - 2 - circuits are designed, which improve the current driving capability

    然後通過比較和分析電流密度比補償型、弱反型工作型和多晶硅柵功函數差型三種帶隙電壓基準源電路結構的優缺點，確定了電流密度比補償型共源共柵結構作為本設計核心電路結構，運用負反饋技術設計了基準輸出緩沖電路、輸出電壓倍乘電路，改善了核心電路的帶負載能力和電流驅動能力。
  18. Voltage feed dipole

    電壓饋電偶極子
  19. Burnout failure analysis of low - voltage feed switch in movable substation

    移動變電站低壓饋電開關燒毀事故分析
  20. According to the present actual underground power system which neutral point is grounded through arc suppression coil in many supper big shaft, the development history and present situation of synthetic protection system used in hv flameproof switchgear are reviewed, and on the basis of analyzing the problems existed in high voltage flameproof switchgear, the selective leakage protective method based on the detecting harmonic direction of zero sequence current as well as the value of zero sequence voltage is proposed in this paper, and at the same time, harmonics extracting schematic and transforming circuit are also designed

    本文深入系統地研究了基於intel80c196kb單片機控制的6kv防爆開關綜合保護系統，主要內容如下：針對大型及特大型礦井供電系統中性點普遍採用消弧線圈接地方式的現狀，回顧了國內外礦用高壓防爆開關保護系統的發展歷史，分析了目前國內高壓饋電開關保護系統所存在的問題，提出了「基於零序電壓基波啟動，五次諧波功率方向比較」的選擇性漏電保護原理，設計了相應的五次諧波提取電路和功率方向鑒別電路。
分享友人
分享到 Line

分享到臉書