電子液壓計 的英文怎麼說

中文拼音 [diànziyèyājì]
電子液壓計 英文
electromanometer
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 液 : 名詞（液體） liquid; fluid; juice
  • 壓 : 壓構詞成分。
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 電子 : [物理學] [電學] electron
  • 液壓 : hydraulic pressure液壓泵 hydraulic pump; 液壓表 hydraulic pressure gauge; hydraulic pressure indi...
  1. A lot of experiments have been done in the process of exploiture soft packaging li - ion battery about how to choice the rational arts and crafts. the content include : how to deal with the collector, add how much pvdf in the material, how long the material need to stirring and the right viscidity, how much condubtivity agent the electrode need, what theckness is best, choice different collectors, the degree of dryness of the electrode, theckness of pressed model, how much electrolyte will be added, placement how long after added the electrolyte, system of formation how to influnce the battery, in formation the battery need or not need preesure from outside, how to vacuumize and the optimize matching positive pole and negative pole. with these practice make sure the parameter of the positive pole should less than 90 m ; according to different vacuumize order the conduc - tivity agent in anode will be 5mass % and 9mass %, respectively, and in cathode the data is 2mass % ; every 100mah added to 0. 4 ml electrolyte ; before formation the battery should be placement 8 hours and the system of formation must be less than 0. 01c before the voltage reach to 3. 0v ; should press in outside when battery in formation ; to these batteries which capacity more than 350mah the vacuum time not excess 15s ; the optimize matching positive pole and negative pole between 2. 10 : 1 and 2. 15 : 1. finally make out the battery which cycling performance and security are all very well

    液態軟包裝鋰離子電池的研究主要是對關鍵工藝進行了優化設計，具體包括:集流體的處理、 pvdf的加入量、漿料攪拌時間和粘度、導電劑的加入量、電極膜的厚度、不同集流體的選擇、電極膜的乾燥程度、壓型的厚度、電解液的加入量、注入電解液后靜置時間的長短、化成制度的影響、化成時電池所具有的壓力影響、抽真空的處理、正負極活性物質的匹配。最後確定出液態軟包裝鋰離子電池最佳工藝參數:正極膜的厚度小於90 m ;根據化成時不同抽真空順序，確定正極膜中的導電劑的加入量分別為5mass %和9mass % ;負極膜中導電劑的加入量為2mass % ;電解液的加入量為每100mah添加0 . 4ml ;化成前電池的靜置時間應當大於8h ;電池在3 . 0v之前採用小於0 . 01c的化成制度;在化成過程中應當施加一定的外部壓力;對於350mah的電池抽真空的延時不應大於15s ;而正負極活性物質的質量比應當在2 . 1 : 1 2 . 15 : 1之間。
  2. Electro - hydraulic servo control ' s technology becomes an important constitute of modern time control technology as a bridge between the micro - electronics, computer technology and electro - hydraulic control technology. for electro - hydraulic servo control ' s technology has the advantage of fine linearity, little deadband, high sensitivity, fine dynamic performance, rapid respond, high precision and so on, it is used in many fields

    電液伺服控制技術作為現代微電子技術、計算機技術和液壓技術的橋梁，已經成為現代控制技術的重要組成部分。由於它具有線性好、死區小、靈敏度高、動態性能好、響應快、精度高等顯著優點，因而得到了廣泛的應用。
  3. At the same time, liquid crystal science harvests satisfyingly, its research field has extended to physics, chemistry, electronics, biology, etc. surface orientation of liquid crystal molecule ( lcm ) is a key technique in the application of lcd, the effect of orientation plays an important role in the basic performances, such as uniformity, visual angle, aberration, response, threshold of voltage and so forth

    液晶自1976年在世界上首次應用於計算器的顯示屏以來，就以其輕量、薄型、能耗低、顯示面積大等優勢在顯示應用方面得到迅猛發展，而同時，液晶科學也得到了全面發展，研究領域遍及物理、化學、電子學、生物學等各個學科。液晶分子取向控制技術是液晶板顯示應用中的一個關鍵技術，取向程度的好壞對液晶顯示器的均勻性、視角、色差、響應速度、閾值電壓等基本性能都有重要影響。
  4. In the way based the scientific and tecdrical talks on i presided at and panicipated in, the graduation theis included a p1entful thets in recent years wtll be divided into three parts for depiction conxteniently and clearly, according to the content as fo1lowsf ( l ) the study of shock compression properties with the drixtiir - liquid co and n, experimentally ( 2 ) the study of the phenomenon of excess heat produced by deuteriurn atoms entering into the lattice of titaluxn experimentally ( 3 ) the calcujation for the electronic structure and energy of hydrogen atoms cluster ffi. the mainstream in the first part of the paper is to exposure some experimental tecndques in high pressure and high temperatur shock compression physics, including by using a cryo - target cooled down circulating steaxned n, to condense the well - proportioned mixed liquid sample from pure gas co and n = with equal molar voiurne

    根據近幾年所承擔和參加的科研任務，將研究成果總結寫成的論文按以下三個部分敘述： （ 1 ）液體co和n _ 2混合物沖擊壓縮特性的實驗研究（由國防科技重點實驗室基金項目96js75 . 2 . 1 . jw1902資助） （ 2 ）重氫原子進入鈦晶格中引起過熱現象的實驗研究（由國家自然科學基金10145002資助） （ 3 ）氫原子團簇h _ 9的電子結構與能量計算第一部分以高溫高壓沖擊波物理實驗為主，採用自行研製的低溫循環汽冷靶冷凝制樣技術由高純co和n _ 2氣體獲取等摩爾體積均勻混合的液體沖擊初態樣品。
  5. The hydraulically actuating, electronically controlled variable valve actuator, the common rail hydraulical source and the electronic control unit have been designed and developed. the primary control strategies of the valve timing in different conditions have been discussed. the performance of the system has been researched deeply by experiments, from which, plenty of rules have been obtained, and the way to adjust valve timing, lift and duration has been put forward

    研製了電控可變氣門系統的執行器? ?電控可變氣門驅動機構，設計了電控可變氣門系統的液壓驅動源? ?中壓共軌液壓源，開發了電控可變氣門系統的電子控制單元，實現了在不同工況下，氣門正時、氣門開啟持續期、氣門升程柔性的電子控制，並對不同工況下配氣正時的控制策略進行了初步探討。
  6. Firstly, the current testing localization in the detection of electric bow is analyzed and the new system ' s whole construction developed in this thesis is introduced ; in the 2rd chapter, the embedded 110v dc power supply is analyzed and constructed, and with experiments, some dissonant results such as the fluctuation of output pwm ( pulse width modulation ) pulses, the power noise added to output voltage, and the drop of output voltage have been analyzed and the problems have been broken down one by one ; in chapter 3, stepping motor ' s drive has been systematically dissertated, and combing stepping motor ' s subdivided drive technology, the author develops an intelligent mini - step driving circuit using a main - sub microprocessor structure, which is validated in the hybrid stepper based system ; in the 4th chapter, liquid crystal driving and displaying technology is specified in detail, with one sort of lcd modules ( tlm12864h ), the author develops an feasible circuit for the new testing system, designs a menu mode based program struc ture and brings here some programming codes using franklin c51 programming language ; in chapter 5, the above built system is used in the electric bow ' s practical detection, and the differentiating rate of this system is analyzed

    論文首先分析了目前機車受電弓檢修方式存在的局限並概述了本論文研製的受電弓測試系統的體系架構；第二章對系統內置110v直流控制電源進行了分析和設計，結合試驗對輸出pwm振蕩、輸出電源噪聲大、輸出電壓下跌等現象進行了分析並提出解決措施；第三章論述了步進電機的驅動，結合步進電機微步驅動技術研製了基於上下位單片機組的混合式步進電機智能驅動電路，並在試驗中得以驗證；第四章詳述了液晶驅動及顯示技術，利用一款液晶顯示模塊tlm12864h研製出本系統用液晶顯示電路，設計了菜單式的程序結構並以franklinc51編程方式給出部分子程序代碼；第五章則將以上構建的整個系統應用在機車受電弓的實測中，並對測試解析度進行了分析。
  7. The development of ship automation puts more requirement on the quality of electricity, whose standard can no longer be met by the traditional mechanical hydraulic pressure or analog speed regulator of marine diesel - engine generator system. as a result, speed regulator based on electronics and microcomputer appeared

    船舶輪機自動化的發展，對船舶的供電質量的要求也越來越高，傳統的柴油發電機組的機械、液壓或模擬式調速器已不能滿足這種要求，因而出現了電子的基於微計算機的雙脈沖調頻調載調速器。
  8. Industrial controlling equipment and its system, sensor, converter, factory / process automation technology and equipments, distribution control system ( dcs ) / analytical controlling system / intelligent controlling system / process automation controlling system / automatic controlling system / test and control system / supervision system / numerical controlling system / digital display equipment / frequency speed control, servo - control, computer aided design and control, various specialized systems, power transmission techniques, programmable controller / hydraulic pneumatic element, automatic storage retrieval system, logistics, other electronic devices, communication, electric controlled equipments, various fitting, whole - set system and installation

    工業控制機及其系統、傳感器、變頻器（培訓） 、工廠/過程自動化技術與設備、集散控制系統/分析控制系統/智能控制系統/過程自動化控制系統/自控系統/測控系統/監控系統/數控系統/數顯設備/變頻調速與伺服控制、計算機輔助設計與控制及各類專用系統、動力傳動技術、可編程序控制器/液壓與氣動元件、自動化立體倉庫、物流、其它有關電子、通訊、電控設備、各類配件及成套系統和裝置。
  9. We adopt double alkali cathodal tube 9789qb, which was made by emi corporation in england, as our photomultiplier, whose spectrum ranges between 300nm to 650nm, with less noise counters and single - photon apices, which make it suitable as a single - photon - counter. the disparted - voltage device is designed in a reasonable way and the cooling system of iquefied nitrogen which makes it small in size, simple in structure, easy in processing, cheap in cost and good in performance

    該管型的光譜范圍在300 650nm ，具有暗計數少，有單光子峰的特點，適于做單光子計數器；本文的光電倍增管分壓器設計合理而冷卻系統採用液氮，該系統體積小、結構簡單、加工便利、成本低廉且性能良好。
  10. Combined with advanced technique, hcq3. 0 testing table constructed an integrated system, which included mechanism, hydraulic component, gas component, electricity, electron, sensor, road spectrum, computer control and analysis

    Hcq3 . 0試驗臺結合國內外先進技術，建立了一套包括機械、液壓、氣動、電氣、電子、傳感、路譜、計算機控制與分析系統在內的完整系統。
分享友人
分享到 Line

分享到臉書