電子蒸發 的英文怎麼說

中文拼音 [diànzizhēng]
電子蒸發 英文
electron evaporation
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 子Ⅰ名詞1 (兒子) son 2 (人的通稱) person 3 (古代特指有學問的男人) ancient title of respect f...
  • : Ⅰ動詞1. (蒸發) evaporate2. (利用水蒸氣的熱力使食物熟或熱) steam Ⅱ名詞[中醫] (將藥物隔水蒸熟) steaming
  • : 名詞(頭發) hair
  • 電子 : [物理學] [電學] electron
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2控單元路連接器設計製成輸入輸出控制檢測端,並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對動機的燃油系統、直接點火系統、怠速控制系統和燃油氣排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端和故障模擬處理單元實現對動機控系統各傳感器、控單元、執行器進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了傳感器和執行器典型故障波形。
  2. Azo is deposited by electronic beam evaporation on the k9 substrates

    本文用的方法在k9玻璃上制備了azo薄膜。
  3. The cathode at the left is raised to a high temperature by the heater, and electrons evaporate from its surface.

    左邊的陰極被燈絲加熱到高溫,同時從陰極表面出來。
  4. Under the assumption that the inner surface of stator sleeve and outer surface of rotor are smooth, taking the fact into account that the temperature of stator sleeve of evaporation cooling motor keeps almost the same, horizontal evaporation cooling motor is simplified as a physical model of two coaxial sleeves, with outer sleeve ( the stator ) holds still and keep at constant temperature and inner sleeve ( the rotor ) is rotating and heated

    本文通過數值和實驗手段研究了臥式冷卻機楔形氣隙中的流體流動、傳熱現象。本文在定套筒和轉表面光滑的假設下,針對冷卻機定套筒壁面基本恆溫的特點,將實際冷卻機簡化為同軸套筒內筒加熱旋轉、外簡靜止定溫的物理模型。
  5. It is the first time in china to set the speed increase gears form in the new compressor and to adopt several new techniques including the condenser with oil - separator built - in, jet exhauster and electrical expansion valve used to supply liquid for the flooded evaporator in the unit

    本壓縮機在國內首次採用了帶增速齒輪的形式,冷水機組在國內內首次採用了內置油分冷凝器、引射器和膨脹閥對滿液式器供液等新技術。
  6. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時,壓縮機採用低速運轉,吸氣壓力升高,這對系統降低能耗是有利的;變頻控制時,器製冷劑流量的變化並非線性;系統中採用膨脹閥進行過熱度控制,被控對象具有參數時變的特性,相應地宜採用變結構的控制器。
  7. The main scattering mechanism is ionized impurity scattering and acoustical phonon scattering. the experimental results show that the high quality of zno. al films were obtained

    實驗結果表明利用技術制備的zno : al薄膜材料,具有較好的結構及光特性。
  8. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統,膨脹閥應該根據具體製冷劑的熱力性質選取;膨脹閥流量系數對孔徑和脈沖數比較敏感;在結構固定時,流量系數隨溫度的降低而升高,隨冷凝溫度的增加而增大,受過冷度變化的影響較小;膨脹閥的容量受孔徑影響最大。
  9. Air conditioning, handicap facilities, idd, ddd, tv, travel service, bar lounge, coffee shop, complimentary daily newspaper, gymnasium, swimming pool, laundry, internet access, money exchange, credit cards, shopping arcade, baby sitter, massage room, sauna, clinic, steam bath, beauty centre, business centre, conference room, billiards, conference facilities, piano bar, restaurants, refrigerator, health fitness, car park

    粵菜西餐風味食街賓館設施中餐廳西餐廳扒房酒吧會議廳展覽廳商務中心停車場接受信用卡外幣兌換服務票務服務ddd話idd話洗衣服務客房送餐服務交誼舞廳迪斯科舞廳卡拉ok廳棋牌室撞球室游戲機室網球場壁球室小型高爾夫球場商場醫務室理美容室健身室按摩室桑拿浴室汽浴室日光浴場
  10. Such a light source is provided by any atomic vapour in which an electrical discharge is running.

    任何一種生放過程的原汽都能提供這樣一種光源。
  11. Automotive air conditioner accessories : automotive air conditioner cooler, evaporator, heat sink, air conditioner, temperature adjuster, heater, central cooler, air desiccators, cooling fan controller, internal heat exchanger, compressor, motor, air warmer, warm air device, electronic fan for cooling condenser, liquid can, thermal expansion valve, air condition pipeline, switch, clutch, connector, height valve, shunt valve and all kinds of automotive air conditioner production materials ( body aluminum, copper materials, etc ), production equipment, measurement equipment, etc

    車用空調配件:各種車用空調冷凝器、器、散熱器、空調器、調溫器、加熱器、中冷器、空氣乾燥器、冷卻風扇控制器、內部熱交換器、壓縮機、動機、暖風機、暖風裝置、各種冷凝器扇、貯液灌、熱力膨脹閥;各種車用空調管路、開關、離合器、接頭、高低閥、換向閥及各種車用空調生產材料(車用鋁材、銅材等) 、生產設備、檢測設備等。
  12. Study on evaporative - cooling technology for high - power power electronic components

    大功率器件冷卻技術研究
  13. Evaporative cooling has been regarded as a new cooling technology on hydro - generator, and it not only could increase the ratio of material utilization and reduce the difficulties of making large - scale hydro - generators, the running difference in temperature, the stress of the generator ' s stator and the possibilities of the incidental occurrences, but also has better performance than internal water cooling

    冷卻作為水輪機的一種新型冷卻技術,不僅可以提高材料利用率,減小特大型機製造難度,降低機定繞組運行溫差和機定的應力,減少事故隱患,更重要的是冷卻比水內冷具有更好的優越性。
  14. 3. polycrystalline lif thin films were grown by thermal evaporation on amorphous substrates. properties of broad band photo - luminescence at room temperature of active channel ( f2 and fa + ) produced by electron beam irradiation were studied

    首次用熱法在玻璃襯底上制備了多晶lif薄膜平面波導,研究了由束照射產生的有源( f _ 2和f _ 3 ~ +色心)溝道的室溫寬帶光致光特性。
  15. In this dissertation, high quality ( 002 ) textured zno films were prepared on silicon substrate using electron beam evaporation method. in addition, zno nano - particle material embedded into mgo thin films was prepared by a co - evaporation ( thermal and electron beam evaporation, simultaneously ) method and a following post - annealing process in oxygen ambient

    本文介紹了採用方法在si襯底表面上制備出了具有c軸擇優取向的高質量氧化鋅薄膜材料,另外,還採用共(通過與熱同時進行)及後退火的簡單方法制備出包埋到介物質mgo薄膜中的zno量點材料。
  16. L. ruan, g. gu, x. tian “ numerical simulation for circulating systems and experimental comparison of the closed - loop, self - circulating evaporative cooling of hydro - generators ” 《 electrical engineering 》 vol86, no. 3

    阮琳,顧國彪,田新東「大型冷卻水輪機的關鍵問題定空心導線內兩相流摩擦阻力放大倍數的比較及修正建議」 《大機技術》 , 2004 . 4
  17. The main products includes various steam and electric heating reaction vessel, conduction oil, outer coil reaction vessel, polyester and resin completed equipments, vacuum reducing concentration tank, methanol and ethanol recovery tower, various corrugated stuffing, high effective membrane evaporator, new - type centrifugal drag membrane evaporator, vacuum rake dryer, condensing drum cut - off machine, shell - and - tube condenser,

    本廠主要產品有各類加熱反應鍋,導熱油外盤管反應鍋,聚脂樹脂全套設備,真空減壓濃縮罐,甲醇乙醇回收塔,各類波紋填料,高效薄膜器,新型離心刮板式薄膜器,真空耙式乾燥機,冷凝滾筒切片機,列管式冷凝器,螺旋板式換熱器,外循環器,鋁制槽車貯罐,乳化設備,高速剪切分散機,種罐,酵罐,多功能提取罐,並承接各類非標設備。
  18. This paper briefly presents the theory of the inner evaporative cooling system with pump in generator and a suit of simulation software developed based on it using c computer language

    本文簡要介紹了汽輪機定繞組內部冷卻的技術原理,著重介紹了一套基於此基礎之上的用c語言開的模擬軟體。
  19. Apply to such industry as petroleum, chemical industry, textile, metallurgy, electron and atomic energy, etc., is it filter, charge dust, gas not to spread, is it steam take, catalysis reflect, electrolytic, eliminate noise, damping, hinder fire and sweat function of cooling etc. to flow to have

    應用在石油化工紡織冶金及原能等工業中,有過濾收塵氣體擴散流化催化反映解消聲阻尼阻火及汗冷卻等作用。
  20. In a word, the two type of voa both have valuable applicability and potential market. the author have done numerous processing to work out new processing such as polymer coating and cure and triple - layer - metal film vaporing. other new processing, polymer ultra - violet ( uv ) cure and inductively - coupled plasma ( icp ) etching were studied

    作者經過反復的工藝實驗,確定了聚合物波導塗膜和固化、三層金屬和腐蝕等新工藝的參數,並得到了聚合物紫外固化、等離體刻蝕等新工藝的初步數據。
分享友人