電容補償裝置 的英文怎麼說

中文拼音 [diànróngchángzhuāngzhì]
電容補償裝置 英文
capacitor compensation device
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動詞1 (修理; 修補) repair; mend; patch 2 (補充; 補足;填補) fill up; add supplement; supply; ...
  • : 動詞1. (歸還; 抵補) repay; compensate for 2. (滿足) meet; fulfil
  • : Ⅰ名詞1 (服裝) dress; outfit; attire; clothing 2 (演員的化裝品) stage makeup and costume Ⅱ動詞...
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  • 電容 : electric capacity; capacitance; capacity
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  • 裝置 : 1 (機器設備的配件)installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. Single - phase earthed capacitance current automatism compensate device of 6kv electricity - net

    網單相接地流的自動
  2. The main computer is programmed under windows, while the assistant computer is programmed under dos. the last, based on the idea of module - structure, the software of the testing system are designed, thus this software system is compatible and transplantable to design again. the experiment of measuring principle is taken : take the xy flat of lathe as the parallel - pole device and adjust the angle of sensor, the rotating - probe can test the felloe mould in scanning way

    藉助虛擬儀器的思想,對測控系統進行了設計:採用光柵尺、光編碼器測量可動部件的運動量,解析度高、誤差小;採用細分驅動的步進,控制性能好;系統實施環境溫度的檢測、,提高了檢測精度;基於兩級微機組建測控系統:主機為人機界面,採用windows編程,從機用dos編程,實時性好;軟體設計採用兼性和移植性好的模塊式結構,便於二次開發。
  3. With the development of the electric power system, static - state reactive power compensators ca n ' t have met the requirements of the actual production and operation, and the trend to the fast and dynamic compensation for reactive power become greater and greater. since ertan hydroplant and 500kv transmission systems in sichuan power system have been operated, many power plants of load center are forced to halt during the high - water period, because the great deal of power is transmitted to far - distance load center. thus the load center loses voltage sustentation and the level of the system stabilization is debased greatly

    四川網的二灘水站和500kv輸變系統投入運行后,由於二灘水站的大量力遠距離輸送至負荷中心,迫使負荷中心的火機組在豐水期大量停機,使負荷中心失去壓支撐,大大降低了網的壓穩定水平;同時,因為四川網中的無功全為靜態無功器(或抗器) ,這些設備只能在系統正常運行狀態下起到無功壓支撐的作用,而在網出現事故時,不但不能起到壓支撐作用,反而會促使壓崩潰事故的發生。
  4. The reasearch about both function device of compensate and line selection about single - phase grounding capacitire current for small current grounding system

    流接地系統單相接地與選線雙功能的研究
  5. On the base of widely investigating and researching, author deems that the conventional reactive power compensation devices used by consumer had many defects with among others : lower response time, remaining residual voltage on the compensation capacitors, and so on. because of existing improper trigging time, it is impossible to realizing balance compensation for 3 - phrase unbalance loads

    本文在充分調研的基礎上,認為目前採用的傳統的無功功率存在響應速度慢、觸發時刻不合適、器上有殘壓、不能實行三相平衡、對網產生污染、不能消除負荷本身產生的高次諧波等弊病。
  6. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步動機變頻調速技術的發展概況,在回顧梯液壓控制系統節能技術的基礎上,介紹了本課題研製的「採用蓄能器的液壓梯變頻節能控制系統研究」的基本原理,分析了動力系統在梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式;詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計,重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其的設計、蓄能器-泵馬達壓力能量轉換的設計、多功能集成控制閥組的設計等內;最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件氣接線、計算機控制及數據採集系統的硬體設計等內
  7. Hv - tsc is an important and typical component of svc. its application in power systems provides an effective means for the safety and economic operation of the system. hv - tsc can also provide a good solution to voltage and power quality problems

    高壓tsc是指額定工作壓為6kv 35kv可控硅投切,其是一種典型靜止無功器,其對增強系統穩定性、提高系統運行經濟性,保證壓質量及改善能質量都能發揮良好的作用。
  8. This modeling method is applicable to most of facts and hvdc devices, not only to those devices including thyristor - controlled reactor ( tcr ), such as thyristor - controlled series capacitor ( tcsc ) and static var compensator ( svc ), but also to those devices including converter bridge, such as hvdc device and static synchronous compenstor ( statcom ), etc. it deduces the mathematical models of tcsc, hvdc, svc and statcom devices with the proposed method

    該方法能適用於大多數facts和hvdc,不僅可用於含有晶閘管可控抗器( tcr )元件的如可控串聯( tcsc ) 、靜止無功器( svc )等的建模,也可用於含換流橋的如hvdc、靜止同步器( statcom )等的建模。本論文採用動態相量法建立了tcsc 、 svc 、 hvdc及statcom的數學模型。
  9. By simulating, this paper compared the effect of capacitor compensation to that of svc compensation, the results showed that capacitor compensation add the voltage flash, and svc was the optimal equipment to restrain the flash. furthermore, the smaller value of ks and tf, the better effect of svc

    通過數值模擬曲線分析,對比了和靜止無功器( svc )的效果,得到的結論是有擴大閃變的影響,而靜止無功器( svc )是抑制閃變的最佳,並且調差系數ks和時間常數t _ f越小, svc效果越好。
  10. The reactive power optimization compensation is to find the suitable compensation place and the best compensation capacitance by adjusting the generator bus voltages, transform taps and reactive compensation capacities in the condition of satisfying power load requirement, which can guarantee the secure and high quality power for consumers. the improved genetic algorithm is applied in this thesis according to the features of reactive power optimization of high voltage transmission bus, which are the non - linear problems with multi - variables and multi - restrictions

    網無功優化是在有功潮流調度給定的情況下,以負荷節點壓和線路輸送無功功率作為狀態變量,運用優化演算法,調節發機節點壓、變壓器可調分接頭和無功,在滿足力負荷的要求下,尋求合理的無功點和最佳量,保證網能夠安全、優質地向用戶供
  11. By analyzing the load factor and unbalance factor of distribution transformer, the method of calculating and selecting the low voltage reactive power compensation capacity and compensation equipments, and the connection mode of capacitors were presented

    摘要通過對配變壓器負載率和不平衡率的分析,提出低壓無功量的計算選擇方法和器的接線方式。
  12. Abstract : the underground load characters in yinshan mine were analyzed. based on the technical features of various kinds of reactive compensation devices, it was proposed that low voltage capacitance dynamic compensation mode shall be adopted for compensating reactive power and lowering voltage fluctuation

    文摘:對銀山鉛鋅礦井下負荷性質進行了分析,根據各種無功的技術特點,提出採用低壓動態方式對該礦井下無功進行和降低壓波動。
  13. The testing hall is equipped with 1, 800kv impulse voltage generator, 2, 000 4, 000kw 50 100hz frequency conversion generator group and 30, 000kvar capicitor compensation device and so on

    試驗大廳安有2400kv沖擊壓發生器2000 4000kw 50 100hz變頻發機組及30000kvar電容補償裝置等。
  14. Equipment of power quality dynamic compensation control realization can be either digital or analogical. the advantage of digital compensation control ( dcc ) is that it can compensate harmonics to a precision level and is independent of the surrounding environment. but dcc need high - speed real - time chips to deal with digital signal processing, so it has high price

    能質量動態的控制是影響能質量動態的性能的重要因數,能質量動態的諧波主要有數字控制和模擬控制兩種,數字的優點是可以對網諧波的達到很精確的程度,不易受到外界運行環境的影響,但是要求運行速度很高的實時數字信號處理器,因此造價較高,模擬控制對硬體要求比較嚴格。
  15. In this paper, the research was made to solute these problems. the peterson coil compensation system has been designed which can measure capacitor current and damp degree ; a fault selection method of distribution network which was put forward that based on ftu

    本課題就這兩方面的問題進行了深入研究,設計了一種消弧線圈自動,該可測量系統對地流和阻尼率,具有響應快、準確性高的優點;同時提出了一種基於ftu的配網接地選線方法。
  16. The principle of voltage adjustment and power factor improvement in capacitor were analyzed, and the choossing approach was introduced

    摘要本文分析了器作為無功壓調整和功率因數提高方面的作用原理,同時介紹了具體應用中器的選擇方法。
  17. Abstract : many rural systems are short of compensation devices of reactive power. it results in low quality of voltage and excessive loss in power lines. this paper proposes to install capacitors on power lines and theoretically analyzes the optimal scheme of compensation and obtained benefits

    文摘:針對許多農網缺乏無功,造成壓質量低劣、線損偏大的問題,提出了在線路上加器進行,並理論分析了的最佳方案及其取得的效益
  18. Considering the actual condition and development of the 35kv distribution network in changzhi district ? a new type of automatic resonance devices with on - line tap - changer is developed for the capacitive current compensation and faulted line selection in case of an earth fault

    結合長治地區35kv配網的實際情況和發展趨勢,研製了新型調匝式自動跟蹤調諧消弧線圈接地,用於網單相接地故障時的流和接地選線。
  19. It is researched for the influence of the existing reactive power compensators in sichuan power to system voltage under different disturbances. it is constituted the capacitance and place of installing the dynamic reactive power compensators in sichuan power system

    研究四川網現有的無功網發生各種擾動時對壓的影響;研究動態無功對提高壓穩定水平的作用;制定動態無功在四川網中的量和地點。
  20. In term of the actuality of var compensation in power system and the disadvantages of the existing high - voltage var compensation equipments, the paper presents the design of a new kind of high - voltage intelligent var compensation controller applying to the 10kv distribution network. the basic concept of the reactive power and the essential principle of var compensation are reviewed and the modes, the capability and the economic and technical benefits of var compensation are analyzed

    本文針對我國網無功的現狀和現有高壓無功的缺陷,設計了一種以10kv配網為對象的智能型高壓無功控制器,並且介紹了無功功率的基本概念和無功的基本原理,對無功方式的選擇、無功量的確定以及無功的經濟技術效益等問題進行了分析。
分享友人