電導性塗料 的英文怎麼說

中文拼音 [diàndǎoxìngtúliào]
電導性塗料 英文
conducting paint
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 塗料 : coating material; paint; coating; daubing; dope; moldwash
  1. Indium stannum oxide ( ito ) as semiconductor have caused a great deal of interest due to their prominent electro - optical behavior. ito has high prominent transmittance, high infrared reflectance, good electrical conductivity, ito applied as gas sensors, photovoltaic devices, heat reflecting mirrors, solar cells, flat panel displays, liquid crystal displays, electroluminescent, devices and organic light - emitting diodes ( oled ) etc. although preparations and applications of ito films have been studied deeply. nano - ito composites hardly studied

    氧化銦錫（ ito ）是一種高簡並的n型半導體，由於具有導電性，可見光高透過率，紅外反射性，穩定的化學性，被廣泛應用於熱反射建築玻璃、抗靜電塗層，太陽能電池，熱發射鏡，平板顯示器和液晶顯示屏，傳感器，有機光致二級管（ oled ）等方面，國內外對高質量的ito薄膜的制備和應用進行了深入的研究，但是很少有ito納米粒子與高分子材料復合的報道。
  2. Using diethanolamine as aminating agent and glacial acetic acid as neutralizing agent, aminated epoxy acrylic cationic resin was prepared. the effect of technology of aminated epoxy acrylic resin on properties of eletrodeposition was studied by conductivity meter and electrophoresis apparatus. it was shown that, conductivity firstly decreased, and then increased with aminating temperature increase. in contrast with putting polyacrylic resin into thin acetic acid solution, the more compact film could be achieved by neutralizing polyacylic resin with glacial acetic acid and then add it into water. when neutralizing temperature was enhanced, the speed of electrodepsidon was found to increase, and the film was also more compact. increasing the dn leads to enhanced conductivity and smaller particle size. when dn equaled to 80, the smoothest film could be achieved

    以二乙醇胺為胺化劑、冰醋酸為中和劑，合成了胺化環氧丙烯酸陽離子樹脂.採用電泳儀和電導率儀，研究了胺化環氧丙烯酸樹脂合成工藝對陰極電泳塗料電沉積性的影響.結果表明，隨著胺化溫度的增加，電泳液電導率先下降後上升.將冰醋酸加入樹脂中中和，後用水稀釋，比樹脂在醋酸稀溶液中中和，電沉積性能更好.電沉積速率隨著中和溫度的上升而增加，電沉積膜緻密性相應增加.中和度（ dn ）愈高，電泳液電導率愈大，粒徑越小，而塗膜外觀在中和度為80時達到最佳
  3. Preparation of steel substrates before application of paints and related products - tests for the assessment of surface cleanliness - field method for the conductometric determination of water - soluble salts

    塗料和有關產品使用前鋼襯底的制備.表面清潔度評定試驗.水溶性鹽電導測定的現場方法
  4. Formulation design of alkaline batteries conductive coatings

    堿性電池導電塗料的配方設計
  5. By test and analysis of property, it is no influence for coating conductivity to use natural mineral

    通過性能檢測與分析，採用天然礦物原料及不同的生產工藝對塗層的導電率幾乎沒有影響。
  6. Diamond is a remarkable material due to its special crystal structure, which shows high hardness, low friction coefficient, high thermal conductivity, high optical transparency, low permittivity and high band gap etc. cvd diamond films are widely used in mechanical coating, heat sinks, optical window, semiconductor devices and other application fields because of its low price and high performance

    金剛石的特殊晶體結構使其成為一種性能優異的功能材料，它具有高硬度、低摩擦系數、高熱導率、高透光率、低介電系數和高禁帶寬度等性質。化學氣相沉積制備金剛石膜成本低、質量高，廣泛應用於工具塗層、熱沉、光學窗口、半導體器件等方面。
  7. On the basis of plenty of relative references about conductive composites of polymer matrix / carbon black. a new idea has been put forward for conductive composites, that is, by adding organic crystals into amorphous pu matrix ( coating ) without ptc effect to prepare coatings with ptc effect

    本文在查閱大量國內外有關聚合物cbptc導電復合材料文獻資料的基礎上，提出向無ptc效應的非結晶性聚氨酯（ pu ）塗料基體中加入有機晶體以獲得具有ptc效應的塗料的設想。
  8. Semiconductor materials was laid on the base, and the corresponding electrode was lead to. the semiconductor material has selective adsorption to the gas that changes the electronic concentration which also raises hall coefficient, corresponding changes the export of hall electromotive force, so the gas sensors which is based on hall effect was made

    當我們把半導體材料塗敷到基片上，並引出相應的電極，由於氣敏材料對個別氣體有選擇的吸附特性從而改變了材料中的電子濃度，也就引起了霍耳系數的相應變化，輸出的霍耳電動勢也跟著變化，就製成了基於霍耳效應的氣敏傳感器。
  9. Firstly, this paper dealt with the preparations of conducting electrostatic coating, which was used on large petroleum storage tanks, by using the modified epoxy and polyamide resin as the film forming resin and the carbon nano tubes and mica as conducting carrier, through an analysis of its composition and its mechanism of action

    通過分析塗料各組成成分的作用機理，制備了以改性環氧樹脂/聚酰胺為成膜樹脂，以碳納米管與復合導電雲母粉作為導電填料的大型儲備油罐用導電塗料。
  10. The general applications for spme are that fused silicate fibers were coated with various liquid polymeric coatings, such as polydimethylsiloxane ( pdms ) and polyacrylate ( pa ). lately, other more specialized materials have been developed, including ion - exchange coatings, liquid crystalline films, carbowax and nafion coatings

    后來又發展了一些有特點的塗層材料，如離子交換塗層、極性的nation全氟化樹脂塗層、導電聚合物聚吡咯（ ppy ）和聚- n -苯基吡咯（ pppy ）等。
  11. Fabrication and properties of acrylate carbon nanotube conductive coatings

    碳納米管導電塗料的制備及其性能研究
  12. Preparation of steel substrates before application of paints and related products - test methods for non - metallic blast - cleaning abrasives - determination of water - soluble contaminants by conductivity measurement

    塗料和相關產品應用前鋼基體的預處理.非金屬噴砂清理磨料試驗方法.用電導性測量測定水溶性雜質
  13. The paper discusses the specific problems about the conductive light - solidification composite material ( clscm ) deeply in theory ; presents the coat process of manufacturing clscm and some simple experiment methods creatively. we use several different fillings and different technics to make different clscm, and test some performances. in addition, we confect a kind of fiber - resin composite, and research the relationship between the performance of the material and the distortion of parts

    從理論上深入探討了開發導電性光固化復合材料應注意的問題，指出了填料的性能與添加量對復合材料性能的影響；提出了開發導電性復合材料的塗層工藝及一些簡易的實驗方法；利用不同的填料、不同的工藝方式開發出不同的導電性光固化復合材料，並對其多種性能進行了實驗測定或估測；根據理論分析，研究了材料性能與零件變形的關系，配製出纖維?樹脂復合材料。
  14. Materials for interconnection structures. part 8 : sectional specification set for non - conductive films and coatings. section 8 : temporary polymer coatings

    互連結構用材料.第8部分:不導電薄膜和塗層用分規范集.第8節:暫時性聚合物塗層
  15. Carbon coat electrical film was made and was tested in stability. the process of sputtering micro - wave conduct wave - guide compound metal - carbon film series on columned ferrites which used compound target was studied. micro - wave conducting performance of film was measured, feasibility as the micro - wave conducting compound film series was proved

    本論文用碳化的秸稈為主原料制備了碳靶及復合靶；制備了碳基塗層導電膜，並進行了穩定性試驗；研究了復合靶材在圓柱鐵氧體基體上濺射微波傳輸金屬-碳系復合波導薄膜的工藝，測量了膜層的微波傳輸性能，證實了復合膜系作為微波傳輸波導膜的可行性。
  16. The ilmenite compound is a sort of inorganic function material, which behaves superior absorbing property in given electroconductibility and can be used as absorbent in stealthy technology, the study about it ' s absorbing property starts not long before. a great variety of possible methods that may synthesis ilmenite compounds had been tried to get a easy and practical way synthesizing studied samples, for example : high - temperature solid - state method ; chemical co - precipitation method ; sol - gel method

    鈦酸亞鐵類化合物是一種潛在的具有特徵吸波性能的無機功能材料，在特定的電導率范圍內表現優越的吸波性能，可以作為塗層型吸波材料的吸收劑用於隱身技術的研究和應用中，這方面的研製開發在國內外剛剛開始。
  17. Conducting electrostatic coating, a new kind of functional coating, has been rapidly developed in the past two decades. it is mainly used in the petroleum storage facilities and can prevent the fire hazard and explosion caused by electrostatic charge

    導電塗料是近20年來迅速發展起來的一種功能性塗料，用於儲油設施，作為安全防護塗層，可避免由於靜電引起的火災爆炸事故。
  18. The main producing methods of conductive paper are as follows : mix papermaking of conductive materials and pulp fibers ( wet process ), conductive fibers adhered by adhesives or fusing with meldable fibers ( dry process ), papers coated with conductive coaters, electroless plating, situ adsorption and polymerization of conductive polymers onto pulp fibers, etc

    導電紙的主要製造方法有：導電材料與紙漿纖維混抄（濕法） 、導電纖維用膠黏劑黏合或與熱熔性纖維熔合（干法） 、紙基用導電塗料塗布、化學鍍和導電聚合物紙漿纖維現場吸附聚合等。
  19. Tio _ 2 has been known as an n - type metal oxide semiconductor and an important inorganic function material. it can be used in fabricating medium material, photocatalytic films, reducing reflect coat, gas sensor, etc. tio _ 2 films had excellent performance with photocatalysis, resisting photo erode, difficult dissolution in acidity condition, innocuity and stabilization in light and soon on

    Tio _ 2是n型金屬氧化物半導體，是一種重要的無機功能材料，可用於製作電介質材料、光催化薄膜、減反射塗層、氣敏傳感器等。 tio _ 2薄膜具有優異的光催化性能，抗光腐蝕，在酸性條件下難溶，對光穩定，無毒等。
分享友人
分享到 Line

分享到臉書