電弧分光分析 的英文怎麼說

中文拼音 [diànhúfēnguāngfēnxī]
電弧分光分析 英文
arc spectrum analysis
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 弧 : 名詞1. [數學] （圓周的任意一段） arc2. （古代指弓） bow
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  1. Partial spectrum analysis of active flux tig welding arc of ti alloy

    鈦合金活性焊劑氬弧焊電弧局部光譜分析
  2. Abstract : the image of arc zone of flux - cored underwater wet welding was developed with underwater ccd camera system and composed filter technology. the discussion is mainly focused on the theory of edge detection. an image edge detection method based on median filter and grads algorithm was developed to detect the arc burning zone and arc bubble zone efficiently, which laid the foundation for further analysis of underwater wet welding arc mechanism and process control

    文摘:通過復合濾光技術和水下ccd攝像系統，採集出了藥芯焊絲水下濕法焊接電弧區域圖像，重點論述了邊緣檢測理論，確定了基於中值濾波和梯度運算元的電弧區域圖像邊緣檢測方法，有效地區分了電弧燃燒區域和電弧氣泡區域，從而為水下濕法焊接電弧的機理分析及水下焊接過程式控制制奠定了基礎。
  3. Standard test method for determination of metallic impurities in uranium metal or compounds by dc - arc emission spectroscopy

    用直流電弧發射光譜分析法測定鈾金屬或化合物中金屬雜質的標準試驗方法
  4. By adjusting the automatic tracing coil of arc extinction for switch stand and analysing technical parameters of arc extinction coil in normal operation, the paper indicates some problems should be taken care of, so as to operate properly automatic tracing coil, to remove the excess voltage of grounded arc and to ensure reliable power supply

    摘要通過調試開關站自動跟蹤消弧線圈，分析自動跟蹤消弧線圈正常運行技術參數，指出設計運行中應注意的問題，保證自動跟蹤消弧線圈正常運行，消除弧光接地過電壓，保證可靠供電。
  5. 1 、 the activated process of the metal halide lights is analyzed. the processes mainly include four - discharged stage : breakdown ? glow discharge sputtering ? the glow transition to the arc - - arc discharge sputtering

    1 .分析了金屬鹵化物燈的啟動過程，金屬鹵化物燈的啟動過程主要包括:擊穿? ?輝光放電? ?輝光向弧光的過渡? ?弧光放電四個放電階段。
  6. Through studying the principle of dimmer and switch power supply, it was found that in some frequency points, by analyzing the phase of electric voltage and current it can tell if arc faults occur

    研究調光燈及開關電源的工作原理可以發現，通過分析迴路中電壓電流在某些頻率點的相位信息，可以有效判別是否發生了故障電弧。
分享友人
分享到 Line

分享到臉書