電應力 的英文怎麼說

中文拼音 [diànyīnglì]
電應力 英文
electric stress
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  1. Delamination caused by electrical - over - stress ( eos ) and moisture expansion during reflow soldering have shown different delamination patterns

    由過電應力（ eos ）和再流焊中的水汽膨脹引起的分層會顯示出不同的失效模式。
  2. The technique plays an important role in the proper selection of parts ， thermal electrical stress control in the circuit design and derating

    說明這一方法對元器件的正確選擇、電路設計中熱電應力的控制和降額等可靠性設計起主導的作用。
  3. In order to investigate the effect of high - field hot - carrier on devices and circuits, the electrical stress experiment is carried out with 1. 2 n m, 1. 0 n m and 0. 8 u m channel length home - made mosfet ' s by the monitor system with ate and cat technology. by using the fresh and degraded experiment data, bsim2 model parameters are extracted

    為了分析研究高場熱載流子效應對器件和電路特性可靠性的影響，採用自動測試與cad技術相結合的監測系統，對國內溝道長度1 . 2 m 、 1 . 0 m和0 . 8 m的mosfet進行了電應力退化實驗，並根據實驗結果提取了退化前後器件的bsim2模型參數。
  4. In this thesis two reverse - bias electrical stress methods were used to investigate the reliability of the devices. one is a typical of oc stress method with collector open and reverse - bias emitter - base junction. another one, a new technique, is fc stress method with forward - bias collector - base junction and reverse - bias emitter - base junction

    本論文採用兩種反偏電應力方法考察器件的可靠性，一種為傳統的oc應力（集電極開路，發射結反向偏置）方法，另一種為新的方法fc應力（集電結正向偏置，發射結反向偏置）方法。
  5. Test method for thermal failure of solid electrical insulating materials under electric stress

    靜電應力下的固態電絕緣材料的熱損傷的試驗方法
  6. In the paper, the esd stressing tests for n - channel mosfets are performed, and main electrical parameters, 1 / f noise spectrum and its time series are monitored during the test. it is found that the 1 / f noise changes much more sensitive to the esd latent damage than the electrical parameters, at the same time, similarity coefficient also changes more quickly especially for smaller w / l devices

    通過對mos器件的靜電應力試驗，同時監測試驗過程中器件的電參數、 1 / f噪聲功率譜密度以及由1 / f噪聲的時間序列提取的相似系數變化，發現1 / f噪聲對于靜電應力引起的損傷要比電參數的變化敏感得多。
  7. Effect of the electric pre - stress on fissure of epoxy polymer

    預電應力對環氧樹脂固化物開裂的影響
  8. Methods for measurement of gassing of insulation liquids under electrical stress and ionization

    電應力和電離作用下絕緣液氣泡測定方法
  9. Standard test method for thermal failure of solid electrical insulating materials under electric stress

    在電應力作用下電絕緣材料的熱損壞的試驗方法
  10. Gassing of insulating liquids under electrical stress and ionization iec 60628 : 1985 ; german version hd 488 s1 : 1987

    絕緣液體的電應力和電離作用析氣
  11. Standard test method for gassing of insulating liquids under electrical stress and ionization modified pirelli method

    在電應力和電離作用下絕緣液體放氣的標準試驗方法
  12. The possibility of applying the electric pre - stress in some fields of engineering is studied through experiments in this paper

    本文針對預電應力效應在工程中應用的可能性進行了探索性研究。
  13. Electrical insulation systems - electrical stresses produced by repetitive impulses - general method of evaluation of electrical endurance

    電氣絕緣系統.由反復脈沖產生的電應力.電氣耐久性評價的一般方法
  14. This paper offers some experimental foundation for the further study about the application of electric pre - stress in the engineering field

    本文為預電應力效應進一步的工程應用研究提供了一定的實驗依據。
  15. Electrical insulation systems - electrical stresses produced by repetitive impulses - part 1 : general method of evaluation of electrical endurance

    電絕緣系統.反復脈沖產生的電應力.第1部分:耐電性評價的一般方法
  16. 6. since the reactor has the structure of multi - layer in parallel, the axial electric stress of coil is zero. under steady operation voltage, the voltage is distributed evenly along axial direction of coil

    6 .由於電抗器採用多層並聯結構，線圈的軸向電應力為零，在穩態工作電壓下，沿線圈軸向高度方向的電壓分佈均勻。
  17. Theoretically, it is possible to accelerate water move from outside of cable to inside and therefore to accelerate the cross - linking reaction of silane - g - pe by gradient force of electric field when electric pre - stress is applied in the process of warm water cross - linking of silane - g - pe cable

    由理論分析得知，在硅烷交聯聚乙烯電纜的溫水交聯過程中施加預電應力，通過電場梯度力來加速水由外向里的擴散遷移進而加速交聯反應速度是可能的。
  18. It is discovered that the diameters of silicon rubber decrease and the number of silicon rubber increase by the dc electric pre - stress applied during solidifying of silicon rubber - toughened epoxy resins. the effect is independent of the polarity of electric pre - stress, but it is dependent of the intensity of electric pre - stress

    本文通過實驗研究證實：在硅橡膠改性環氧樹脂的固化過程中所施加直流預電應力導致了固化物中硅橡膠相數量增多、尺寸減小；並且，預電應力的這種效應與預電應力的極性無關，但與預電應力的水平有關。
  19. Both electric stress and thermal stress had been considered comprehensively during the calculating process. according to the failure criterion, the temperature was chosen correspondingly. then using the energy integral way, the life of device can be deduced

    在計算壽命的過程中，綜合考慮了電應力和溫度應力，根據失效判據，選取實驗過程中相應的溫度段，採用能量積分的方法來外推器件的壽命。
  20. The degradation and lifetime model is deeply discussed, dynamic and static stress suffered by devices and circuits are compared and analyzed. a modified model for lc is proposed for better fitting the experimental data and the substrate current model parameters eerit and lc, degradation parameter h, m, n are extracted by the static stress experiment results

    詳細分析討論了mosfet的壽命與退化模型，並對電路中器件所受的動態應力與直流靜態電應力進行了分析比較：根據實驗結果改進了有效導電長度l _ c模型；應用直流電應力實驗數據進行了襯底電流模型中載流子速度飽和電子科技大學博士論文臨界電場e ； 、有效導電長度lc以及退化參數h 、 m和n的提取。
分享友人
分享到 Line

分享到臉書