電抗性負載 的英文怎麼說

中文拼音 [diànkàngxìngfùzǎi]
電抗性負載 英文
reactive load
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 負載 : [電學] load
  1. Moreover, we mensurate the reactances of the experimental motor by the way of direct joad method, and verify the vaiidity of " electromotive force method "

    文章還運用直接負載法測定出樣機在不同負載下的電抗參數，驗證了「電勢法」的正確性。
  2. Great intermittent noise, wide variety of impendence along with the load and great attenuation of signals have restricted the further utilization of power line

    但是，電力線通信通道存在間歇性噪聲大、阻抗隨負載變化大、信號衰減大等缺點，嚴重製約了它的有效利用。
  3. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改變引起的負結深的變化對深亞微米槽柵pmosfet性能的影響進行了分析，對所得結果從器件內部物理機制上進行了討論，最後與由漏源結深變化導致的負結深的改變對器件特性的影響進行了對比.研究結果表明隨著負結深（凹槽深度）的增大，槽柵器件的閾值電壓升高，亞閾斜率退化，漏極驅動能力減弱，器件短溝道效應的抑制更為有效，抗熱載流子性能的提高較大，且器件的漏極驅動能力的退化要比改變結深小.因此，改變槽深加大負結深更有利於器件性能的提高
  4. To explain this, we ' re going to avoid the idea of impedance ( which has resistive, capacitive and inductive components, some of which vary in effect by frequency, thus varying the actual loading ) and use pure resistance to describe the concept

    為了便於解釋，我們準備暫時避免使用阻抗這一概念，因為它有電阻性、電容性和電感性成分，而其中一部分會隨著頻率的變化而變化，從而改變了實際的負載。
  5. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電阻及電源電阻均高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最高，在該頻率之半時則電壓均為最低。
  6. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最低，在該頻率之半時則電壓均為最高。
  7. It balls up well in ac welding and has a more stable arc than pure tungsten. especially with excellent performance in high load ac welding, it is not replacable by any other electrodes. it also resists contamination well in ac welding

    尤其在高負載電流的情況下，鋯鎢電極表現出來的優越性能，是其他電極不可替代的，在焊接時，鋯鎢電極的端部能保持成圓球狀而減少滲鎢現象，並具有良好的抗腐蝕性。
  8. Assuming the loop is known to be only a single straight segment of 26awg cable, there is no additive loop or afe noise, and the remote - end is terminated by a high - impedance load for all frequencies, figure 5 shows the resulting selt performance

    假定已知環路只有一個單個的直段26awg電纜，沒有附加的環路或者afe噪聲，對所有的頻率遠端通過一個高祖抗負載終止，圖5給出了selt的性能結果。
  9. The power angle characteristics are acquired and compared with the unsaturated curves. it is concluded that the stability limit of the power angle is less than 90 degree. reactive power regulating curves are calculated and compared with those curves when saturation effect is not considered, the result is that u type curves are deviated to the right

    通過對同步發電機各種運行曲線的計算，在已有文獻的基礎上更進一步分析了鐵磁材料飽和以及磁場畸變對同步發電機運行特性和參數的影響；求出了空載特性曲線和零功率負載特性曲線，在不同的電樞電流下計算得到的波梯電抗不同；求出了功角特性曲線，與不計飽和時的功角特性曲線相比較，功角穩定極限小於90 ；求出無功調節曲線，與不計飽和時相比較， u型曲線向右偏移。
  10. The effects of the error of ct and vt, hysteresis and load variation to short - circuit reactances are discussed also. by using error analysis and simulation analysis, this paper discussed the feasibility in engineering

    論文分析了互感器誤差在幾種情況下對短路電抗測量結果的影響；通過變壓器建模，分析了磁滯特性和負載變化量大小對短路電抗測量結果的影響，驗證了該方法在工程應用上的可行性。
  11. Introduced the antijamming in the numerical control system design, from the shield ( including electric field shield, magnetic screen and electromagnetic field shield ) designs mentions, added the absorbing circuit to the perceptual load to suppress the transient state noise to give the specify, might avoid the numerical control system which disturbed creates " softly " the breakdown

    摘要介紹數控系統中的抗干擾技術，對屏蔽（包括電場屏蔽，磁場屏蔽和電磁場屏蔽，正確的布線方式）和感性負載加吸收電路來抑制瞬態噪聲做了詳細說明，可避免干擾造成的數控系統的「軟」故障。
分享友人
分享到 Line

分享到臉書