電極合金 的英文怎麼說

中文拼音 [diànjígějīn]
電極合金 英文
electrode alloy
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 電極 : electrode; pole
  1. Tin - based alloy anodes for lithium ion batteries

    鋰離子電池錫基合金體系負極研究
  2. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相；在（ 600 1000 ）范圍內，以燒結體作為電解質隔膜，多孔性pt黑為正、負電極， pt - rh合金網為集電極，分別組成氫濃差電池、氧濃差電池及氫?空氣燃料電池並測定了它們的性能，研究了不同氣氛下樣品的離子導電特性及影響燃料電池性能的因素。
  3. For electrodeposition by dc methods, the metals deposite uninterrupted and the particles were also embeded uninterrupted into the coatings ; for electrodeposition by pc method, the particles with biggish volume were desorbed from the coatings and returned to the electrolyte again owing to the presence of pulse interval ; for electrodeposition by prc method, the particles carried positive charges are much more easy to desorb from the coatings owing to the effecf of reverse pulse current combined with pulse interval, in addition, the reverse pulse current also could dissovle the metals, further accelerates the desorption of particles, thus the particles size embeded in the coatings by prc method is the least

    直流電沉積時，基質金屬的沉積連續進行，粒子在電極表面不間斷嵌入鍍層;單脈沖電沉積由於脈沖間歇的存在使得具有較大體積的粒子會脫附，重新回到溶液中;採用周期換向脈沖時，反向脈沖電流使表面荷正電的較大的粒子更易從電極表面脫附，同時，反向脈沖電流對基質金屬的溶解作用，也會促進粒子的脫附，因此鍍層中復合粒子尺寸最小。隨著鍍層中粒子復合量的增加，三種鍍層的晶粒都明顯細化，說明al _ 2o _ 3的存在阻止了晶粒的長大，提高了電沉積過程中晶核的形成速率。
  4. Recent progress in metal hydride electrode materials

    貯氫合金電極材料進展
  5. Performance improvement in mg - ni hydrogen storage alloys

    貯氫合金電極性能的因素
  6. The potentiostat is one of the principal instruments used to control an anodic dissolution process accurately in electrochemical experiments

    摘要恆電位儀是在合金相電解提取中精確控制陽極溶解過租的重要儀器。
  7. One was using the cyclic ether to pretreat the lithium metal electrode. and a favorable surface sei film was wished to form on the lithium metal, to enhance the interface stability of lithium electrode and the cycleability of lithium battery

    方法一:嘗試採用環醚類化合物對金屬鋰電極進行表面預處理，預先在金屬鋰表面形成良好的表面sei膜，提高鋰電極界面穩定性和鋰負極的電化學性能。
  8. Study on adsorption property of oxygen on pt - rh alloy

    鉑銠合金電極上氧吸附特性的研究
  9. Effect of alkanethiol self - assembled monolayers on the electrochemical polymerization of pyrrole on the gold electrodes

    硫醇自組裝膜對金電極上吡咯電化學聚合的影響
  10. Is a hard, brittle, corrosion - resistant, gray to white metallic element extracted from wolframite, scheelite, and other minerals, having the highest melting point and lowest vapor pressure of any metal

    顏色呈灰色或棕黑色，硬度高，延性強，熔點極高，常溫下不受空氣侵蝕主要用途是製造燈絲和高速切削合金鋼，各種鎢電極，也用於光學儀器，化學儀器方面。
  11. The results show that : nano - nickel powder is not useful for mh electrode during the high rate discharge phase as a conductor or additive ; superfine nickel powder is applicable for the conductor of the negative because of the good performance especially the cyclic stability at 1c rate by using 5 % ( mass percentage ) nickel powder ; the utilization of alloy, specific mass and volume capacity are increased with the decreased particle size of nickel powder in negative, however, the capacity fading rate at 1c discharge rate is also increased, so the capacity and the cyclic stability should be taken into account to make a choice of the particle size

    結果表明： mh電極中加入納米鎳粉對負極的大電流放電性能不利。 mh電極中加入超細鎳粉后電極綜合性能好，尤其是1c循環穩定性，其最佳添加量為5wt 。減小鎳粉粒度提高了電極合金利用率、質量比容量、體積比容量，但增大了負極1c容量衰減率，因此鎳粉粒度的選擇應綜合考慮mh電極容量和循環穩定性。
  12. And the impact of processing conditions on the electrochemical performance of the porous sn - cu alloys was investigated. results showed that it was good to add more verdigris and to make the annealing time longer for improving the performance. however, the problem of capacity fading can not be solved completely by this method

    並對制備合金材料過程中所添加物質的種類和比例、燒結時間等工藝參數對合金的性能的影響進行了分析，發現添加堿式碳酸銅，並且增大添加比例以及延長燒結時間對電極材料的循環壽命有利，但是不能根本解決容量衰減的問題。
  13. Surface treatments. anodized aluminium and aluminium alloys. measurement of total reflectivity using a photoelectric reflectometer

    表面處理.陽極氧化鋁和鋁合金.總反射率的測定.用光電反射系數計測量總反射系數
  14. The result shows that with the addition of rare earth elements, ultrasonic irradiation and magnetic field, the chemical component, surface configuration, microstructure and properties of electroless co - ni - b and co - fe - b alloy changes remarkably. such kind of change can be described as the followings. firstly the depositing speed of electroless alloy bath is raised while the polarizability and cathodic overpotential are reduced ; secondly the surface quality of the alloy coating and adhesion of the coating and matrix are improved ; thirdly in the coatings the content of the elements in the transient group increases, but the content of cobalt decreased ; fourthly the amorphous structure is transformed to microcrystal structure and polycrystal structure ; fifthly the microhardness and wear resistance of the coating are enhanced ; sixthly coercitive force is reduced, and magnetoconductivity of the coating is increased ; lastly the magnetic intensity of the coating increases with the addition of energy and light rare earth elements such as ce, la and decreases with the addition of heavy rare earth elements such as y. on the other side, when the alloy coatings passes through the heat treatment under the temperature of 250 or 500, their properties will change

    結果顯示化學沉積co - ni - b 、 co - fe - b工藝在稀土元素（ ce 、 la 、 y 、 dy ） 、能量（超聲波、磁場）介入后，沉積過程、合金成分、鍍層形貌結構和性能都有顯著變化，表現在：鍍液的陰極極化過電位和極化度降低，沉積速度提高；鍍層的結合力、表面質量改善；鍍層中過渡族元素的含量增加，輕元素硼的含量降低，同時證實了稀土元素與過渡族元素共沉積的可能性；鍍層的顯微結構由非晶態向微晶和多晶態轉變；鍍層的顯微硬度與耐磨性提高，力學性能優化；鍍層的矯頑力降低；磁導率提高；鍍層的磁化強度在能量（超聲波、磁場）和輕稀土元素ce 、 la介入后提高，重稀土元素y介入后降低。
  15. We think increase of the internal resistance of battery is the main problem to the recycle life deteriorating at high rate, besides the influence of the materials. decomposition occurred on positive and negative electrode at high rate current and the interspaces increased. the restrains of swelling and the increase of an oxygen overvoltage can improve the performance of recycle life

    對于電池性能衰減的原因，認為除了所使用的材料是影響電池性能的重要因素之外，在溫度和大電流作用下，電池的正負極材料發生裂解，極片內空隙增大，電池內阻性能惡化是引起電池高倍率循環性能惡化的關鍵;通過抑制正極析氧和膨脹，並降低負極合金材料的粉化過程，將有望緩解電池內阻特性的惡化，從而提高電池高倍率充放電循環性能。
  16. Study on property of new electrode alloy with low be element and no co element

    新型無鈷低鈹銅基電阻焊電極合金性能研究
  17. Overview of studies on hydrogen storage electrode alloys

    貯氫電極合金研究概況
  18. Effect of temperature on electrochemical properties of hydrogen storage alloy

    儲氫電極合金的溫度特性研究
  19. Alloy wires for spark plug

    火花塞電極合金線
  20. The effect of electrode metal microscopic structure change on welding performance

    電極合金顯微組織結構變化對焊接性能的影響
分享友人
分享到 Line

分享到臉書