電極接頭 的英文怎麼說

中文拼音 [diànjíjiētóu]
電極接頭 英文
electrode connection
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 電極 : electrode; pole
  • 接頭 : 1 （連接起來） connect; join; joint 2 （找人聯系） contact; get in touch with; meet 3 （了解情況...
  1. Peter rosenfeld of northwestern university observed an interesting feature in the electroencephalograph, or eeg, a chart of the brain ' s electrical signals as detected on the surface of the skull

    他用腦電圖儀（ eeg ，直接貼在頭皮上的電極收集大腦電訊號的儀器）觀察到一個很有趣的現象。
  2. The drill isapplied to the cochlea, the inner ear hearing organ, is aligned to thecorrect place and then drills a hole less than a millimetre in diameterto enable the cochlear implant to be inserted

    該鉆頭適用於內耳聽覺器官耳蝸，它準確對齊到正確的部位，接著在該部位鉆一個直徑小於一毫米的洞使得耳蝸植入電極可以由此插入。
  3. Three - pole plug with n - and earthing contacts ac 400 230 v 16 a - principal dimensions

    帶n觸點和接地觸點的16a400 230v交流電用三極插頭.主
  4. The contact area between clamp and terminal is either silver or copper.

    夾頭和電極之間的接觸面是銀的或銅的。
  5. Resistance spot welding electrode adaptors

    電阻點焊電極接頭
  6. Connectors, electrical, circular, coupled by threaded ring, fire - resistant or non fire - resistant, operating temperatures 175 c continuous, 200 c continuous, 260 c peak - hermetic receptacle with round flange attached by soldering or brazing - product standard

    連續工作溫度為175 200極端溫度為260時耐火或不耐火的由螺紋環連接的環形電連接器.軟焊或銅焊上圓頭法蘭密封插座.產品標準
  7. Road vehicles - connections for on - board electrical wiring harnesses - tabs for single - pole connections - dimensions and specific requirements

    道路車輛.車上電氣布線線束的連接.單極連接接頭用接線片.尺寸和特殊要求
  8. Electrical accessories for domestic and similar purposes. round non - wirable two - pole plugs, 2, 5 a - 250 volts, with cord, for the connection of class ii equipment for household and similar purposes

    家用及類似電器附件.級設備連接用帶軟線2 . 5安250伏圓形不可重新接線的二極插頭
  9. Connectors, electrical, circular, coupled by threaded ring, fire - resistant or non fire - resistant, operating temperatures 175 c continuous, 200 c continuous, 260 c peak - plug - product standard

    連續工作溫度為175 200極端溫度為260時耐火或不耐火的由螺紋環連接的環形電連接器.插頭.產品標準
  10. Ultrasonic wire bonding was applied to connect the contacts and sub - miniature - a ( sma ) connectors. also a suitable shield box has been designed for the test of hts filters

    對于超導濾波器的焊接，採用超聲點焊焊接sma的接頭和高溫超導濾波器的接觸電極，實現了較小的接觸電阻和較好的機械強度。
  11. Specification for resistance spot welding - electrode holders - morse taper fixing

    點焊設備規程.電極夾具.第2部分:莫氏錐形接頭
  12. In 2004, the company s technology development department has actively and successfully developed the shield - type american - style european - style cable heads, high - low - voltage cable branch cases for load switch busbar coupler system, outdoor ring network cabinets, box - type transformer substations and auxiliary products, which have passed the authentication one after another and been launched into the market in large batches, giving a strong support to the upgrading of the national urban power grids and the construction of key projects ; in 2006, the company has developed the four - splitting and dual - splitting wire and cable box and released to market ; the 2nd half of 2006, over 500kv ultra - high voltage electrical hardware being developed for 2007 market ; four products awarded national patents in 2006

    2004年公司技術開發部積極開發了屏蔽型美式歐式電纜接頭，負荷開關母線聯接系統的高低壓電纜分接箱，戶外環網櫃，箱式變電站及配套產品相繼通過鑒定，大批量投入市場，有力支持國家城網改造與重大工程建設2006年公司又研製出四分流二分流電線電纜分線盒，已投放市場2006年下半年，正在研製開發超高壓500kv及以上電力金具，有望2007年投放市場2006年有六種產品已申請國家專利。
  13. Cathode power connection

    陰極電源接頭
  14. Anode power connection

    陽極電源接頭
  15. Resistance spot welding - electrode adaptors, male taper 1 : 10 - part 2 : parallel shank fixing for end - thrust electrodes iso 5183 - 2 : 2000 ; german version en iso 5183 - 2 : 2002

    電阻點焊.外錐度1 : 10電極接頭.第2部分:軸端推力電極
  16. Resistance welding equipment - electrode adaptors, male taper 1 : 10 - parallel shank fixing for end - thrust electrodes

    電阻焊設備.外錐度1 : 10電極接頭.端推力電極用平行柄接頭
  17. Resistance spot welding - electrode adaptors, male taper 1 : 10 - part 2 : parallel shank fixing for end - thrust electrodes

    電阻點焊.外錐度1 : 10的電極夾頭座.第2部分:端推力電極用直柄接頭
  18. Electric resistance welding. spot welding electrode adaptor with punching cooling bore. sizes and tolerances

    電阻焊接.沖有冷卻孔的點焊電極夾頭座.尺寸和公差
  19. Resistance spot welding - electrode adaptors, female taper 1 : 10

    電阻點焊.內錐度1 : 10的電極接頭
  20. Resistance welding equipment - electrode adaptors, male taper 1 : 10 - part 1 : conical fixing, taper 1 : 10

    電阻焊接設備.電極接頭外錐度1 : 10 .第1部分:圓錐形接頭錐度1 : 10
分享友人
分享到 Line

分享到臉書