電模擬模型 的英文怎麼說

中文拼音 [diànxíng]
電模擬模型 英文
electric analog model
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  • 模型 : 1 (仿製實物) model; pattern 2 (制砂型的工具) mould; pattern3 (模子) model set; mould patter...
  1. In order to get the energy characteristic of flywheel, this paper put forward the circumrotate state k of flywheel by analogy with soc. then, the energy model of flywheel battery was established and the simulation results of the design flywheel battery were got

    本文還探討了飛輪池的能量特性,建立了飛輪池的能量,提出用飛輪運轉狀態k來類比化學池的soc ,並用simulink對所設計的飛輪池進行了分析。
  2. As the single rectangular coil is the routine induction probe, the system is simulated based on the theory of a - v - a. the perfect induction field is studied. the corresponding relations between the slots and the field are also analyzed, as well as the measurement scale is given here

    )描述下交變磁場測量技術單矩形線圈激勵形式下的數值,從場量檢測的角度出發,分析了無缺陷情況下該系統的磁場分佈特性,以及有缺陷情況下缺陷與場分佈的對應關系以及缺陷檢測的數值范圍。
  3. Aiming at the compensation benefits calculation combined with development layout of the yellow river mainstream cascades is now taken into account the dynamic characteristic of different level years, the compensation benefit simulation model of the yellow river mainstream cascade reservoirs is adopted to calculate the power generation compensation benefits of the yellow river upstream run - of - river power stations in three level years of 2000, 2010 and 2020

    摘要針對以往補償效益的研究都是靜態計算而言,本文結合不同水平年黃河幹流梯級的滾動開發規劃,考慮不同年代補償效益的動態特性,採用黃河幹流梯級水庫補償效益的,計算了2000 、 2010以及2020三個水平年黃河上游徑流式梯級站的發補償效益。
  4. Neural network control is an important mode of intelligent control, and it is widely used in branches of control science, first, the architecture and the learning rule ( error back propagation algorithm ) of multiplayered neural network which is widely used in control system are presentedo especially, the paper refers to the architecture of diagonal recurrent neural network and its learning algorithm - - - - - recurrent prediction error algorithm because of its faster convergence with low computing costo next, before introducing the neural network control to the double close loop dc driver system, the controllers of current and velocity loop are designed using engineering design approach after analysis of the system, simulation models of the system are created

    神經網路控制是智能控制的重要方式之一,它廣泛應用於自動控制學科各個領域。本文首先敘述了控制系統中常用的多層前饋網路結構及演算法( bp演算法) ,特別提及了能夠較好描述系統動態性能的對角遞歸神經網路和在用遞推預報誤差演算法訓練drnn時取得了較快的收斂速度。其次,應用工程方法分析設計了tf - 1350糖分離機的流、轉速雙閉環直流調速系統的控制器,作為引入神經網路控制的設計基礎,並建立了系統的
  5. Based on output voltage and capacitor - current feedback current spwm control, the inverter is modeled and the prototype is made

    並對採用輸出壓和流瞬時值反饋的流spwm控制技術逆變器建立了,製作了原理樣機。
  6. The models of diode rectifier system and filter circuit, are established by using power system blockset ( psb ), which are also supplied by matlab

    利用matlab提供的氣系統塊( psb ) ,建立了二極體整流橋、濾波路等元件的
  7. After establishing induction motor simulation model with iron loss, this paper has investigated effect of iron loss and proposed two schemes to compensate estimated error due to iron : one modified the structure of controller, the other modified the structure of observer, both schemes eliminated the detuning effect of iron

    對于鐵耗的影響,本文建立了考慮鐵耗的感應后,研究了鐵耗造成的估計誤差,並利用兩種方法對誤差進行補償,一種是修改控制器結構的方法,另一種是修改觀測器結構的方法,最終都較好地消除鐵耗對速度估計的影響。
  8. Electricity auction market simulation with intelligence agent model

    力拍賣市場的智能代理
  9. Through the introduction of vvvf theory and the control thought of plc, the mathematic model of test rigs is founded which is run under the mode of electronic simulation, which is the theory foundation for the realization of control system

    通過介紹變頻調速理論和plc的控制思想,建立了試驗臺在式運行下的數學,為控制系統的實現奠定了理論基礎。
  10. Design and produce the hpvs ’ s electric simulate model, combine with the double close - loop controller, simulate the system ’ s self - excited phenomenon and the badly signal ’ s character, and to find the root reason and the solution method

    然後結合雙閉環控制器和,驗證所設計的控制方法和所搭建的控制器的有效性,並進一步現場可能出現的各種情況,得到結論。
  11. This thesis focuses on the ingress process module of ctu, which translates c - 5 dcp format to rainier 4gs3. the specification analysis, architecture and logic design, functional simulation testbench design, synthesis report and testing result are discussed in this thesis. the research work mainly includes : the specification analysis and design requirements of ctu logic ; the architecture and logical design of ingress process module, which includes receive control fsm, send control fsm and cell position adjustment logic ; the performance improvement of ingress process module to receive and transmit data cell at the full line speed

    本論文的主要研究工作包括:通信協議轉換邏輯的功能分析和設計需求;通信協議轉換邏輯上行方向的系統分析及體系結構設計,包括上行接收狀態機、發送狀態機、信元內位元組位置調整機制等的設計;通信協議轉換邏輯上行方向的線速設計,主要是上行接收的線速設計,要使用流水設計技術;提出了高速實現roundrobin調度策略的實現方法,並設計實現了桶式移位器和優先級編碼路;應用bfm設計了上行處理各塊的testbench ,完成了各級塊的和系統集成
  12. Modeling mac layer for powerline communication networks

    力線通訊網路中媒質接入層的
  13. In chapter 6, we set up the simulation model of yunhe diesel engine generator system, simulated common marine power system faults process, and obtained a lot of conclusion from the running result

    第六章採用matlab6 . 1軟體,建立雲河輪柴油發機組的,對一些常見的力系統故障和現象進行了
  14. Through the study with non - linearity friction on simulation model of the stabilized system, in theory the analysis of the angular acceleration loop ' s contribution is given. in testing platform, the measure devices of angular acceleration and velocity constitute the double loops, they are angular acceleration loop and angular velocity loop. and this experiment gives the proof that the angular acceleration loop could eliminate the errors which are taken by the motor ' s reversing

    最後,本文在理論上分析角加速度環對隔離度的貢獻;通過對含有非線性摩擦力矩的平臺穩定系統的研究,從理論上驗證角加速度環具有克服摩擦力矩的能力;在實驗轉臺上加入由線加速度計構成的角加速度測量裝置,並與測速機構成角加速度環、角速度環雙環結構,驗證了角加速度環對機換向誤差的消除作用。
  15. In this paper, the working principle of the interleaving two - transistor forward converter is analyzed in detail, and the waveforms of the switch drain - to - source voltage and transformer magnetizing current are researched in different duty cycle conditions. the simulation model is constructed and the simulation results verify the analysis

    本文分析了交錯並聯雙管正激變換器的工作原理,研究了在不同占空比條件下開關管的漏源壓和變壓器勵磁流波形,建立了結果證明理論分析的正確性。
  16. This paper had developed a series of mathematical models and algorithm, which can be used for developing the real - time module for any performance boiler training simulator, by researching the 1006t / h sub - critical boiler ( including powder manufacturing apparatus ) of luohuang power plant

    本文針對珞璜廠1006t / h亞臨界鍋爐系統(包括制粉系統)進行及演算法研究,建立一套適合的數學及演算法,可用於該鍋爐全工況機實時塊的開發。
  17. And it can be controlled running at a rating slip, when its efficiency is the highest. then, simulation model of lim vector control system is constructed, which is proved accurate by simulation results under different speed and different load. and it is concluded that lim efficiency is lower under light load or low speed

    其次,建立了考慮邊端效應的直線感應機矢量控制系統的,不同速度和負載下結果驗證了的有效性,得到了機在輕載或低速運行時效率較低的結論。
  18. To make pic ( particl - in - cell ) simulations. to set up models of guns and magnetic field and simulate them in the vacuum and plasma, respectively. we found that plasma held back part of space charge effects and improved trajectory of electrons. but beam would oscillate and became instable as accretion of plasma density. by simulating again and again, we draw a conclusion magic could n ' t work when plasma density was more by far than beam electron density. at last a four - stage depressed collector was simulated

    建立子槍和聚焦系統,分別在真空和填充等離子體條件下進行。發現填充等離子體能補償部分空間荷效應,改善子束包絡軌跡,提高子的流通率,但是隨著等離子體密度的增大,束子會出現振蕩不穩定性,遺憾的是通過反復多次發現本文所用粒子的代表性軟體magic無法用於等離子體密度遠高於束子密度的情況。
  19. Elevator dispatching method in idle traffic mode based on elevator traffic probability simulation model

    基於梯交通流概率的空閑交通梯調度方法
  20. Study on modifying the simulation model and computating the key parameters of partial discharge in single void

    單氣隙局部放電模擬模型的修正與關鍵參數的確定
分享友人