電橋定時電路 的英文怎麼說

中文拼音 [diànqiáodìngshídiànlù]
電橋定時電路 英文
bridge timing circuit
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. To encourage more participation from the youth, itc has dedicated the last day of the expo as youth day which will offer a series of innovative workshops and live demonstrations with support from various collaborative partners, including dna fingerprint, internet robot game, virtual bridge building, etc. honourable guests and rthk teen power wi ll host special programmes on the youth day

    為鼓勵更多青年人參與這個盛會，創新科技署特別把創新博覽會的最後一天訂為「青年日」 。在各個合作夥伴的鼎力支持下，屆時會舉行一連串的創意工作坊及科技示範，包括dna指紋鑒定、網際網路機器人游戲和虛擬建橋等。香港電臺teenpower更會聯同特別嘉賓，在青年日主持特備節目。
  2. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  3. For the convenience of test, varied circuit chip defects caused by the production process are abstracted as all kinds of models. at present the commonly used fault models mainly consist of stuck - at fault, stuck - open fault, bridge fault, store fault, delay fault, etc. testing methods based on voltage testing mainly aim at stuck - at fault model and have also obtained satisfactory result in research for many years. bridge fault is tested easily by quiescent power supply current ( iddq ) testing method. in regard to stuck - open fault that is difficult to testd by quiescent power supply current ( iddq ) and voltage testing, it can is tested by the dynamic current ( iddt ) testing

    為了便於測試，我們將生產過程中集成電路出現的多種多樣的缺陷抽象為各種模型。目前常用的故障模型主要有:固定故障，開路故障，橋接故障，存儲故障，時滯故障等。電壓測試主要針對固定型故障模型，多年的研究也取得了令人滿意的結果; cmos電路中的橋接故障則宜用穩態電流測試方法（ iddq ）測試;對于電壓和穩態電流難以測試的開路故障，可以使用瞬態電流測試（ iddt ）的方法進行測試。
  4. The results show that occurrence of the single or double pole block on the dc lines, or short - circuit faults on the dc or ac lines will not influence seriously on power system stability

    模擬結果表明：當南橋、華新換流站發生直流輸電單雙極閉鎖以及交、直流側短路故障時，不會給系統帶來穩定問題。
  5. Summarizing the development statement of monitoring technology for bridge, based on principle of pulse laser ranger detection and fiber - optic strain measurement, in view of the problem affected by single - chip inherent feature, integrating the goodness of cpld device and single - chip, using a / d converter to measure the count quantization error, a strain measurement system is worked out. the above system chiefly consists of light source, optic fiber sensor, photo detector and signal processing circuit

    本文綜述了國內外橋梁監測技術的發展概況，在深入研究脈沖激光測距和光纖應變測試原理的基礎上，針對單片機固有計數頻率低、計數量化誤差大和延時不固定等不足，結合cpld計數頻率高、延時小而固定和單片機控制功能強的優勢，並採用模數轉換技術設計計數量化誤差測量電路，提出了基於激光脈沖時間測量法的光纖應變測量的方案。
分享友人
分享到 Line

分享到臉書